离子排斥色谱中色谱柱温度对有机酸保留的影响

研究了离子排斥色谱中色谱柱温度对有机酸(脂肪酸、芳香酸)保留的影响。采用Shim-pack SCR-102H离子排斥柱,分别以0.2 mmol/L p-甲苯磺酸为淋洗液分离6种脂肪族有机酸(甲酸、乙酸、丙酸、丁酸、戊酸和己酸)以及0.08 mmol/L H2SO4为淋洗液分离6种芳香酸(邻苯二甲酸、水杨酸、苯乙酸、对羟基苯甲酸、苯甲酸、邻甲苯甲酸),流速为1.2 mL/min,柱温控制为25～50℃,直接电导检测。结果表明,有机酸的保留值随温度升高而减小。但每种有机酸的保留受温度的影响程度不同,即当温度改变时,每种有机酸保留值的变化程度不同。一般规律为:有机酸的保留越强,其保留值随温度的变化程度越大。依据范特霍夫曲线的线性回归数据,可知有机酸的范特霍夫曲线具有良好的线性关系,其保留为放热过程。通过改变柱温,可以实现有机酸,特别是强保留有机酸保留值的改变,改善有机酸的色谱峰形和分离状况。     

花状3D纳米Pd/CeO2催化剂的制备及其性能研究

以PdCl2为前驱体,十六烷基三甲基溴化铵为保护剂,用超声波膜扩散法制备了Pd纳米粒子溶胶(E,Pd负载量1.0 wt%)。采用水热法制备了3D纳米花状Pd/CeO2催化剂(F),其结构,形貌和物理化学性能经XRD,SEM和N2吸附-脱附表征。考察了晶化时间对F形貌和晶型的影响。结果表明,晶化时间72 h制备的F72具有较高的比表面积(108 m2·g-1)和较大的孔体积(0.11 cm3·g-1);晶化时间48 h制备的F48呈现花状形貌,由大量厚度(20 nm～30 nm)均匀的纳米单元自组装而成。     

富集分离质谱检测磷酸化肽新材料与分析方法进展

本文对2005年以来,金属离子和金属氧化物亲和色谱材料及其他特别材料结合质谱检测,用于富集分离测定磷酸化肽及磷酸化蛋白的分析方法进行评述。引用文献119篇。     

An interesting two‐phase solvent system and its use in preparative isolation of aconitines from aconite roots by counter‐current chromatography

Two‐phase solvent system plays crucial role in successful separation of organic compounds using counter‐current chromatography (CCC). An interesting two‐phase solvent system, composed of chloroform/ethyl acetate/methanol/water, is reported here, in which both phases contain sufficient organic solvents to balance their dissolving capacities. Adjusting the solvent system to get satisfactory partition coefficients (K values) for target compounds becomes relatively simple. This solvent system succeeded in sample preparation of aconitine (8.07 mg, 93.69%), hypaconitine (7.74 mg, 93.17%), mesaconitine (1.95 mg, 94.52%) from raw aconite roots (102.24 mg, crude extract), benzoylmesaconine (34.79 mg, 98.67%) from processed aconite roots (400.01 mg, crude extract), and yunaconitine (253.59 mg, 98.65%) from a crude extract of Aconitum forrestii (326.69 mg, crude extract).     

2,2′‐Anhydro‐1‐(3′,5′‐di‐O‐acetyl‐β‐D‐arabinofuranosyl)uracil,a cyclouridine nucleoside with a C4′‐endo furanosyl conformation

2,2′‐Anhydro‐1‐(3′,5′‐di‐O‐acetyl‐β‐D‐arabinofuranosyl)uracil, C₁₃H₁₄N₂O₇, was obtained by refluxing 2′,3′‐O‐(methoxymethylene)uridine in acetic anhydride. The structure exhibits a nearly perfect C4′‐endo (⁴E) conformation. The best four‐atom plane of the five‐membered furanose ring is O—C—C—C, involving the C atoms of the fused five‐membered oxazolidine ring, and the torsion angle is only −0.4 (2)°. The oxazolidine ring is essentially coplanar with the six‐membered uracil ring [r.m.s. deviation = 0.012 (5) Å and dihedral angle = −3.2 (3)°]. The conformation at the exocyclic C—C bond is gauche–trans which is stabilized by various C—H...π and C—O...π interactions.     

Sulfonated carbon catalyzed oxidation of aldehydes to carboxylic acids by hydrogen peroxide

Sulfonated carbon as a strong and stable solid acid catalyst exhibited excellent catalytic performance in various acid-catalyzed reactions. Here, sulfonated carbon, as catalyst for oxidation reaction, was prepared via the carbonization of starch followed by sulfonation with concentrated sulfuric acid. N₂ physisorption, X-ray diffraction, Fourier transform infrared spectroscopy, X-ray fluorescence and acid-base titration were used to characterize the obtained materials. The catalytic activity of sulfonated carbon was studied in the oxidation of aldehydes to carboxylic acids using 30 wt% H₂O₂ as oxidant. This oxidation protocol works well for various aldehydes including aromatic and aliphatic aldehydes. The sulfonated carbon can be recycled for three times without obvious loss of activity.     

Direct conversion of fructose-based carbohydrates to 5-ethoxymethylfurfural catalyzed by AlCl3·6H2O/BF3·(Et)2O in ethanol

Direct conversion of fructose-based carbohydrates to 5-ethoxymethylfurfural (EMF) catalyzed by Lewis acid in ethanol was investigated. It was found that BF₃·(Et)₂O was favorable for 5-hydroxymethylfurfural (HMF) etherification to EMF. BF₃·(Et)₂O combination with AlCl₃·6H₂O with the molar ratio of 1 was an effective catalyst system for synthesis of EMF from fructose-based carbohydrates. 55.0%, 45.4% and 23.9% of EMF yields were obtained from fructose, inulin and sucrose under optimized conditions, respectively.     

Novel B,O-chelated fluorescent probe for nitric oxide imaging in Raw 264.7 macrophages and onion tissues

A novel fluorescent probe based on B,O-chelated dipyrromethene chromophore in far-visible and near-infrared spectral region (600–900 nm), boron chelated 8-(3,4-diaminophenyl)-3,5-bis(2-hydroxyphenyl)-4-bora-3a,4a-diaza-s-indancene (BOPB), has been first developed for nitric oxide (NO) imaging. BOPB, a turn-on fluorescent probe, can react with NO rapidly under physiological condition. The reaction product of BOPB with NO, BOPB-T, emits bright red fluorescence at 643 nm when excited at 622 nm. Meanwhile, BOPB-T displays high fluorescent quantum yield of 0.21 and good photostability. The selectivity for NO over other reactive oxygen/nitrogen species and ascorbic acid has been investigated and BOPB has good specificity for the detection of NO. MTT assay shows that the toxicity of BOPB (below 10 μM) to living cells can be neglected. Based on these investigations, BOPB has been used for NO imaging in Raw 264.7 cells and onion tissues. Meanwhile, mechanical injury to onion tissues results in a brighter fluorescence around the wound, which indicates that more NO has been produced in plant tissues in response to external stimuli. Our studies illustrate that BOPB has advantages of high sensitivity, low background interference and little photo damage on fluorescence imaging of NO.     

A simple microextraction and preconcentration approach based on a mixed matrix membrane

A simple adsorption/desorption procedure using a mixed matrix membrane (MMM) as extraction medium is demonstrated as a new miniaturized sample pretreatment and preconcentration technique. Reversed-phase particles namely polymeric bonded octadecyl (C₁₈) was incorporated through dispersion in a cellulose triacetate (CTA) polymer matrix to form a C₁₈-MMM. Non-steroidal anti-inflammatory drugs (NSAIDs) namely diclofenac, mefenamic acid and ibuprofen present in the environmental water samples were selected as targeted model analytes. The extraction setup is simple by dipping a small piece of C₁₈-MMM (7 mm × 7 mm) in a stirred 10 mL sample solution for analyte adsorption process. The entrapped analyte within the membrane was then desorbed into 100 μL of methanol by ultrasonication prior to high performance liquid chromatography (HPLC) analysis. Each membrane was discarded after single use to avoid any analyte carry-over effect. Several important parameters, such as effect of sample pH, salting-out effect, sample volume, extraction time, desorption solvent and desorption time were comprehensively optimized. The C₁₈-MMM demonstrated high affinity for NSAIDs spiked in tap and river water with relative recoveries ranging from 92 to 100% and good reproducibility with relative standard deviations between 1.1 and 5.5% (n = 9). The overall results obtained were found comparable against conventional solid phase extraction (SPE) using cartridge packed with identical C₁₈ adsorbent.