Bromination of 2,1,3-benzothiadiazoles

The bromination of 2,1,3-benzothiadiazoles in 47% hydrobromic acid at elevated temperature has led to a general preparative method for the synthesis in high yield of otherwise difficulty accessible brominated 2,1,3-benzothiadiazoles. The typical addition reaction is apparently eliminated under these reaction conditions and substitution takes place exclusively. Bromination of 2,1,3-benzothiadiazole occurs successively at positions 4 and 7. 4-Substituted 2,1,3-benzothia-diazoles are selectively brominated at position 7. 5-Bromo- and 5-methyl-2,1,3-benzothiadiazole are brominated consecutively at positions 4 and 7.     

Ab-initio-Berechnungen des π-Bindungsbeitrages in BF3 und BCl3

Ab initio gradient calculations were performed on BF₃ and BCl₃ to evaluate the -contribution in these compounds. The influence of the basis set on the results is studied for borontrifluoride. For the chlorine compound the -contribution is smaller than for the fluorine compound.

     

Development of an ethanol-selective optode membrane based on a reversible chemical recognition process

Lipophilic trifluoroacetophenone derivatives incorporated in plasticized PVC membranes are able to selectively extract water and alcohols from the sample solution into the organic membrane phase, reversibly forming hydrates and hemi-acetals, respectively. Since this is accompanied by a change in the absorption spectrum of the acetophenone isologue, the chemical recognition process can directly be translated into an optical signal. With N-acetyl-N-dodecyl-4-trifluoroacetylaniline (ETH 6022) as the electrically neutral, lipophilized carrier ethanol can be determined from 0.5 to 35% (v/v) in aqueous solutions. The calibration curve for different ethanol-water mixtures shows a good correlation with the mathematically derived formalism and thus confirms the theoretically expected behavior. Besides high reproducibility of the optical signals, very short response times of less than 30 s were realized. The optode membrane presented exhibits a preference for ethanol compared to water by a factor greater than 11. The selectivities for several primary alcohols, such as methanol, ethanol, 1-propanol and 1-n-butanol, are comparable, but isopropanol and tert.-butanol are rejected by a factor of about 10. The alcohol concentration in different beverages was determined to evaluate the reliability of the system. The values obtained for wine, beer and different spirits show an excellent correlation with those obtained by a conventional approach involving distillation and density measurements. A residual standard deviation of ± 0.27% (v/v) over the 0.7–40% (v/v) range was found.     

The Total Synthesis of (±)-Isocomene by an Intramolecular Ene Reaction. Preliminary communication

The racemic sesquiterpene isocomene ( 1 ) has been synthesized starting from 1,7-octadien-3-one ( 2 ) in a stereoselective manner (Scheme 2). In the key step 4 → 5 the C(7), C(8)-bond was formed by an intramolecular thermal ene reaction. Further elaboration of 5 involved the ring contraction 6 → 7 , the elimination 8 → 9 and the final olefin isomerization 9 → 1 .     

Die Reaktionen von Eisen(III)-chlorid mit Trithiazylchlorid. Die Kristallstruktur von [S4N4Cl]+[FeCl4]⊖

Reactions of Iron Trichloride with Trithyazyl Chloride. Crystal Structure of [S₄N₄Cl]⁺[FeCl₄]^? Iron trichloride reacts with (NSCl)₃ yielding S₄N₄[FeCl₄]₂, S₃N₃Cl₂[FeCl₄] or S₄N₄Cl[FeCl₄], depending on the reaction conditions. The i.r. spectra prove the presence of [FeCl₄]^? ions for all three compounds. The ⁵⁷Fe-Mössbauer spectra show a slight quadrupole splitting at 80 K for S₃N₃Cl₂[FeCl₄] (ΔE^Q = 0.42 mm · s^?1) and S₄N₄Cl[FeCl₄] (ΔE^Q = 0.23 mm · s^?1), which indicates a slight deformation of the FeCl₄^? tetrahedra. The crystal structure of S₄N₄Cl[FeCl₄] was determined and refined with X-ray diffraction data (2549 independent reflexions, R = 0.026). S₄N₄Cl[FeCl₄] crystallizes in the triclinic space group P1 with two formula units per unit cell. The lattice constants are a = 712, b = 911, c = 1006 pm, α = 76.5°, β = 83.8° and γ = 80.5°. The structure consists of the so far unknown [S₄N₄Cl]^⊕ cations and slightly deformed FeCl₄^? ions. The [S₄N₄Cl]^⊕ ion consists of a S₄N₄ ring built up of two nearly planar S₃N₂ fragments having a dihedral angle of 136°. The average SN bond length is 157 pm, the SCI bond length 214 pm.     

Über die Konfiguration des Prolins im Ergotamin

It is well known that in the ergot alkaloids of the peptide type the proline appears in thel-configuration. Different methods of acid hydrolysis may lead to various cleavage products; hydrolysis by HCl yieldsd-proline, on the other hand hydrolytic cleavage by means of strongly acid cation exchange resin preserved the orginall-configuration.

---

---

Teilveröffentlichung der Dissertation vonH. Kolassa, Univ. Wien, 1973.     

Thermische Polymerisation von Acenaphthylen

Zusammenfassung Acenaphthylen wurde durch Anpolymerisation und zweifache Hochvakuumsublimation gereinigt. Die Reinigungsmethode wird ausführlich beschrieben.Bei verschiedenen Temperaturen wurde mit einer dilatometrischen Methode die thermische Bruttogeschwindigkeit gemessen. Zwischen 95 und 105 °C giltk _br=7,0₈·10¹⁰ exp (– 30,9 kcal/RT).Die beträchtliche Aktivierungsenergie der Bruttoreaktion ist sowohl auf eine große Aktivierungsenergie der thermischen Startreaktion als auch auf eine relativ hohe Wachstumsaktivierungsenergie zurückzuführen.Das Polymerisationsverhalten von Acenaphthylen kann vermutlich aufgrund seiner sterischen Eigenschaften erklärt werden.

---

Summary Acenaphthylene was purified by partial polymerisation, followed by double stage high vacuum sublimation. The method of purification is described in detail.The thermal overall rate was measured at different temperatures by a dilatometric method. Between 95 and 105 °C the following relation holds:k _th=7,0₈ · 10¹⁰ exp (– 30,9 kcal/RT).The considerable energy of activation of the overall reaction depends on a relatively high energy of activation of both the thermal initiation and the propagation reaction.It is supposed, that the polymerisation behaviour of acenaphthylene depends mainly on its steric properties.

     

Bond lengthening and through-bond interactions in p,p'-dibenzene and related molecules

The structure of p,p'-dibenzene (PDB) has been investigated by full geometry optimizations using the empirical force field (EFF) and MINDO/3 methods. While other structural parameters are in good agreement, the central bond length calculated by MINDO/3 (1.595 Å), as confirmed by an ab initio (STO-3G basis set) optimization (1.596 Å), is in striking contrast to the corresponding length calculated by EFF (1.543 Å). A detailed analysis of the electronic structure of PDB based on a quantitative perturbational molecular orbital treatment reveals that through-bond coupling of the four π systems is responsible for an elongation of the σ bond which mediates this interaction. Further studies using the EFF and MINDO/3 approaches demonstrate that extended C-C single bonds can arise even in structures with fewer than four π systems. The effect of substituents on the central bond length in PDB has been briefly investigated. (MINDO/3). A variety of other structures have been identified in which bond lengthening may result from through-bond coupling.     

Total Synthesis of (±)-α-Acoradiene via Intramolecular Photoaddition and Reductive Cyclobutane Cleavage

(±)-α-Acoradiene (4) has been synthesized from 3-methoxy-2-cyclohexenone by a sequence of 8 steps. The key steps (Scheme 6) are the regio- and stereoselective photo[2+2]addition 7→6 and the reductive fragmentation 6→5 .     

Flash Photolysis Studies of Reversible Photoprocesses V. Photochromism and triplet states in the dianthrone system

The kinetics of the formation of the photochromic forms B and C of tetramethyl-dianthrone has been studied in triacetin and methylcyclohexane/2-methylpentane at several temperatures. A flash spectroscopy method was developed, which allows the recording of the transient behaviour of the sample as function of both – wavelength and time – using a single photoflash for excitation. The results show that the photochromic forms B and C are directly populated from the excited singlet state. In addition a new triplet-triplet absorption band in the near infrared region was detected.