The surface activity of the lower homologues of n-alkylammonium chlorides in aqueous solutions. Effect of hydrophobic hydration

Summary The surface tensions of aqueous solutions ofn-alkylammonium chlorides (methyl to hexyl) have been measured at 25 °C. With methylammonium chloride the surface tension increased with concentration, whereas with ethylammonium chloride and higher homologues, the surface tension decreased with concentration. The results suggest that this transition is attributed to the effect of hydrophobic hydration. For propylammonium chloride and higher homologues, the relation between the surface tension lowering da and the concentrationC in the range of 0–10 dyne/cm, can be expressed by the equation; = AC + BC, whereA andB are constants. The surface tension coefficientB has been found to increase approximately twofold for each additional CH₂ group of alkyl chain.

---

Zusammenfassung Es wurden die Oberflächenspannungen wäßriger Lösungen vonn-Alkylammoniumchloriden (Methyl- bis Hexylammoniumchloride) bei 25 °C gemessen. Für Methylammoniumchlorid nimmt die Oberflächenspannung mit der Konzentration zu, aber bei allen höheren Homologen mit der Konzentration ab. Die Ergebnisse deuten darauf hin, daß dieser Übergang durch die hydrophobe Hydration bedingt wird. Für Propylammonium-chlorid und die höheren Homologen wird die Beziehung zwischen der Erniedrigung der Oberflächenspannung und der KonzentrationC in dem Bereich von 1 bis 10 dyn/cm durch die folgende Gleichung ausgedrückt: = AC + BC (A undB sind Konstanten). Es wurde gefunden, daß B für jede zusätzliche CH₂-Gruppe etwa um den Faktor 2 größer wird.

     

Accurate and rapid estimation on spectral interferences in routine analysis by ICP-AES: use of mutual interference coefficients

A practical method to estimate spectral interferences and to select optimum analytical lines in ICP-AES is suggested. Depending on the matrix composition and the amounts of the analyte, the analytical lines suffering from little interferences and the limit of determination can be determined from calculation using spectral interference coefficients. For this calculation, the spectral interference coefficients, which are defined as apparent mass of the analyte equivalent to the spectral interference from unit mass of the interferent, are obtained experimentally for 639 emission lines of 68 elements. There is a good correlation between the coefficients obtained on two spectrometers having different resolutions.     

Determination of glutamate-pyruvate transaminase activity in blood serum with a pyruvate oxidase/poly(vinyl chloride) membrane sensor

Pyruvate oxidase (E.C. 1.2.3.3.) is immobilized by adsorption on a wet PVC membrane. Glutamate-pyruvate transaminase activity (5–1600 IU l^?1) in serum is determined by a pyruvate oxidase sensor consisting of the immobilized pyruvate oxidase coupled to a platinum electrode for measuring hydrogen peroxide, after an l-alanine—α-ketoglutarate reaction. The assay requires ?60 s, and has a precision of 2–3%. Endogenous pyruvate should not interfere if measurements are made > 30 s after starting the reaction.     

Successive substitution titration of calcium and magnesium with EGTA using thallium oxide electrode for indication

Summary It is demonstrated that magnesium can be titrated with EGTA in the presence of CaEDTA complex. On the basis of this substitution reaction, calcium and magnesium are successively titrated with EGTA, if an appropriate amount of CaEDTA is added after having reached the end point for calcium. Both end points are indicated amperometrically using a thallium oxide anode. The method has been tested for analysis of tap and mineral water. Larger amounts of manganese(II) render the calcium result too high. Moreover, the indication of both end points is affected by the electrode position of an inactive MnO₂-layer onto the Tl₂O₃-layer. Reducing agents destroy the Tl₂O₃-layer. These interferences can be overcome by addition of an appropriate amount of manganate(VII) to the sample.

---

Sukzessive Substitutionstitration von Calcium und Magnesium mit ÄGTA, indiziert mit der Thalliumoxidelektrode

Zusammenfassung Magnesium kann mit ÄGTA in Gegenwart des CaÄDTA-Komplexes titriert werden. Auf der Grundlage dieser Substitutionstitration können Calcium und Magnesium nacheinander mit ÄGTA titriert werden, wenn nach dem Endpunkt für Calcium eine ausreichende Menge CaÄDTA zugesetzt wird. Beide Endpunkte werden amperometrisch mit Hilfe einer Thalliumoxidelektrode angezeigt. Die Methode wurde an Leitungswasser und Mineralwasser geprüft. Größere Mengen Mangan(II) bewirken zu hohe Calciumwerte. Darüber hinaus wird die Indikation beider Endpunkte dadurch beeinträchtigt, daß sich eine inaktive MnO₂-Schicht auf der Tl₂O₃-Schicht elektrolytisch abscheidet. Reduzierende Stoffe zerstören die Tl₂O₃-Schicht. Diese Störungen können durch Zugabe von Permanganat vermieden werden.

     

Dielectric relaxation in the paracrystalline phase in polyacrylonitrile

Thermal expansion and dielectric relaxation of polyacrylonitrile were measured in the temperature range from ?75 to 152°C. at frequencies from 30 cps to 3 Mc./sec. The thermal expansion curve and the temperature dependence of logarithmic relaxation time both show an inflection at 85°C. An x-ray study by Bohn reveals that this inflection comes from the thermal expansion of the paracrystalline phase of this polymer, and consequently the transition at 85°C. and the associated relaxation are ascribed to molecular motion in the paracrystalline phase. The relaxation strength increases with increasing temperature above this point. The transition is caused by freezing of the bending vibration of chains whereas the relaxation results from rotational vibration. The length of segments in this phase is roughly estimated to be ca. 100 A. by comparing the observed relaxation strength with the theory developed on the basis of the above considerations.     

Structural studies of the carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F: suggestion for the initial activation site for dihydrogen

The carbon monoxide complex of [NiFe]hydrogenase from Desulfovibrio vulgaris Miyazaki F has been characterized by X-ray crystallography and absorption and resonance Raman spectroscopy. Nine crystal structures of the [NiFe]hydrogenase in the CO-bound and CO-liberated forms were determined at 1.2-1.4 A resolution. The exogenously added CO was assigned to be bound to the Ni atom at the Ni-Fe active site. The CO was not replaced with H(2) in the dark at 100 K, but was liberated by illumination with a strong white light. The Ni-C distances and Ni-C-O angles were about 1.77 A and 160 degrees, respectively, except for one case (1.72 A and 135 degrees ), in which an additional electron density peak between the CO and Sgamma(Cys546) was recognized. Distinct changes were observed in the electron density distribution of the Ni and Sgamma(Cys546) atoms between the CO-bound and CO-liberated structures for all the crystals tested. The novel structural features found near the Ni and Sgamma(Cys546) atoms suggest that these two atoms at the Ni-Fe active site play a role during the initial H(2)-binding process. Anaerobic addition of CO to dithionite-reduced [NiFe]hydrogenase led to a new absorption band at about 470 nm ( approximately 3000 M(-1)cm(-1)). Resonance Raman spectra (excitation at 476.5 nm) of the CO complex revealed CO-isotope-sensitive bands at 375/393 and 430 cm(-1) (368 and 413 cm(-1) for (13)C(18)O). The frequencies and relative intensities of the CO-related Raman bands indicated that the exogenous CO is bound to the Ni atom with a bent Ni-C-O structure in solution, in agreement with the refined structure determined by X-ray crystallography.     

Ferrocene-containing polymers. I. Radiation-induced polymerization of ferrocenylmethyl methacrylate

γ-Ray-induced polymerizations of ferrocenylmethyl methacrylate (FMMA) in crystalline and amorphous states were investigated with kinetical and ESR methods. In the crystalline state the polymerization of FMMA proceeded slowly and gave low-molecular-weight polymers, whereas in the amorphous state it proceeded rapidly and gave polymers of much higher molecular weight. Molecular weight distributions of these polymers were binodal. The temperature dependence and the dose-rate dependence of the polymerization rates were different between the two states. Wide-line nuclear magnetic resonance (NMR) spectra of the amorphous monomer suggested that the polymerization proceeded in a supercooled state. Electron spin resonance (ESR) spectra of γ-irradiated FMMA and 1,1′-ferrocenyl-di(methyl methacrylate) showed that ferrocene radicals and methacrylic radicals were formed simultaneously at low temperature; with increasing temperature the former radicals disappeared, whereas the latter changed into growing chain radicals. The yields of radicals were relatively low; this means that ferrocene groups in the monomers behave as a radiation energy absorber.     

A novel method for preparation of 2-(methyl- or phehnylthio)alkanoic esters

Ethyl 2-acetylalkanoate gave ethyl 2-(methyl- or phenylthio)alkanoate in high yield on treatment wiht CH₃SSO₂CH₃, PhSSO₂Ph, or PhSSPh in the presence of small excess of EtONa in EtOH. Application of the present method to synthesis of pellitorine and the queen substance is also described.     

Computer simulation for the cooligomerization system

In order to clarify the kinetic features of the styrene (A)–methyl methacrylate (B)–CCl₄(S) cooligomerization system, a computer simulation was carried out. The experimental data on the degree of polymerization and the deviation of the cooligomer composition from the statistical steady-state composition were comparatively well explained by calculations based on the kinetic equations derived from the assumed reaction scheme and the values of the velocity coefficients, although the values of the four velocity coefficients in the initiation step and the velocity coefficient of the termination by the coupling of two solvent radicals were estimated. The results of the calculation of the rate of each component reaction show that the following two reactions are the most important in the initiation and in the transfer and termination steps when the [S]/([A] + [B]) ratio is large: where, A, A*, and P are styrene, polystyryl radical, and the cooligomer, respectively. Moreover, it was concluded that the deviation of the cooligomer composition from the statistical steady-state composition was caused by these two reactions.     

Protective effects of small amounts of bis(2-ethylhexyl)sulfosuccinate on the helical structures of human and bovine serum albumins in their thermal denaturations

The protective effect of an anionic double-tailed surfactant, sodium bis(2-ethylhexyl)sulfosuccinate (AOT), on the structures of human serum albumin (HSA) and bovine serum albumin (BSA) in their thermal denaturations was examined by means of circular dichroism measurements. The structural changes of these albumins were reversible in the thermal denaturation below 50 degrees C, but became partially irreversible above this temperature. The effect was observed in the thermal denaturation above 50 degrees C. Although the helicity of HSA decreased from 66% to 44% at 65 degrees C in the absence of the surfactant, the decrement of it was restrained in the coexistence of AOT of extremely low concentrations. When the HSA concentration was 10 muM, the maximal protective effect appeared at 0.15 mM AOT. In the coexistence of the surfactant of this concentration, the helicity was maintained at 58% at 65 degrees C, increasing to the original value upon cooling to 25 degrees C. Beyond 0.15 mM AOT, the helicity sharply decreased until 3 mM AOT. A particular AOT concentration required to induce the maximal protective effect ([AOT]REQ) was examined at different HSA concentrations. [AOT]REQ shifted to higher values with an increase of the protein concentration. From the protein concentration dependences of [AOT]REQ, the maximal protection was estimated to require 8.0 and 5.0 AOT ions per a molecule of HSA and BSA, respectively. The AOT concentration, where the protective effect was observed, was too low to form its micelle-like aggregate. Then the protein structures might be stabilized by a cross-linking of surfactant monomers bound to specific sites. These specific sites might exist between a group of nonpolar residues and a positively charged residue located on several sets of amphiphilic helical rods in the proteins. Such a unique function of the double-tailed ionic surfactant is first presented by its characteristic nature as an amphiphilic material.