2,3-Dihydroxypyridine Loaded Amberlite XAD-2 (AXAD-2-DHP): Preparation, Sorption–Desorption Equilibria with Metal Ions, and Applications in Quantitative Metal Ion Enrichment from Water, Milk and Vitamin Samples

2,3-Dihydroxypyridine loaded (via –N=N–linker) Amberlite XAD-2 (AXAD-2-DHP) was prepared and characterized by elemental analyses, TGA and FT-IR spectra. It (1g packed in a column of 1cm diameter; surface area 135.5m²g^–1) was found to be an effective solid phase sorbent for enriching Zn²⁺, Mn²⁺, Ni²⁺, Pb²⁺, Cd²⁺, Cu²⁺, Fe³⁺ and Co²⁺ at pH 3.5 to 7.0 using flow rates between 1.0–5.0mLmin^–1. For desorption (recovery 97.0–99.8%) of the metal ions, 8 to 10mL of 2.0molL^–1 HCl or 1.5molL^–1 HNO₃ at a flow rate of between 2.0 and 4.0mLmin^–1 were found most suitable. The t_1/2 (time for 50% sorption) is between 2 and 10min when a 50mL solution (containing a total amount of metal of 2mg) was equilibrated with 0.5g of resin. Sorption of all metal ions except Pb²⁺ follows the Langmuir model, whereas for Pb the data fits with the Freundlich model. The sorption capacity is between 60.7 (for Cd) and 406.7 (for Cu) µmolg^–1. The resin can withstand an acid concentration of 6molL^–1 and can be reused for thirty cycles of sorption–desorption. The preconcentration factor varies between 100 and 300. For Cd, Ni and Cu the sorption capacity of 2,3-dihydroxypyridine loaded cellulose is lower than that of the present resin. The tolerance limits of electrolytes, humic acid, complexing agents, Ca²⁺ and Mg²⁺ in the enrichment of all metal ions are reported. The limits of detection are 3.88, 5.37, 8.72, 13.88, 4.71, 1.24, 0.59 and 0.30µgL^–1 for Zn²⁺, Mn²⁺, Ni²⁺, Pb²⁺, Cd²⁺, Cu²⁺, Fe³⁺ and Co²⁺, respectively. The calibration curves for flame AAS determination were linear in the ranges 0.018–1.0, 0.067–5.0, 0.2–5.0, 0.9–20, 0.028–2.0, 0.077–5.0, 0.19–10 and 0.1–3.5µgmL^–1, respectively. All the eight metal ions in river and synthetic water samples, Co in vitamin tablets and Zn in milk samples have been quantitatively enriched with Amberlite XAD-2-DHP and determined by flame atomic absorption spectrometry.     

Spectrophotometric determination of traces of selenium(IV) in various environmental samples using the flow-injection technique (FIT)

A simple, sensitive, and rapid flow-injection spectrophotometric method was developed for the determination of trace amounts of selenium(IV). The method is based on the oxidation reaction of 3-methyl-2-benzothiazolinone hydrazone hydrochloride (MBTH) by selenium(IV) followed by the coupling reaction with chromotropic acid (4.5-dihydroxy naphthalene-2.7-disulphonic acid) in a basic medium (phosphate buffer, pH 10.5) to give a pink derivative with λ_max 530 nm that is stable for more than 7 days at 35°C. The reaction and flow conditions of the full experimental design were optimized. A detection limit (2s) of 0.25 μg/L Se(IV) was obtained at a sampling rate of 10 samples per hour. Beer’s law is obeyed for a Se(IV) concentration range of 0.05–0.5 μg/mL at the wavelength of maximum absorption. The detailed study of various interference ions indicates that the method is highly selective. The method was successfully applied to the determination of traces of selenium(IV) in various water samples. The results obtained were in good agreement with those obtained by the reported methods at the 95% confidence level. The text was submitted by the authors in English.     

Magnetic switch of permeability for polyelectrolyte microcapsules embedded with Co@Au nanoparticles

We explored using a magnetic field to modulate the permeability of polyelectrolyte microcapsules prepared by layer-by-layer self-assembly. Ferromagnetic gold-coated cobalt (Co@Au) nanoparticles (3 nm diameter) were embedded inside the capsule walls. The final 5 mum diameter microcapsules had wall structures consisting of 4 bilayers of poly(sodium styrene sulfonate)/poly(allylamine hydrochloride) (PSS/PAH), 1 layer of Co@Au, and 5 bilayers of PSS/PAH. External alternating magnetic fields of 100-300 Hz and 1200 Oe were applied to rotate the embedded Co@Au nanoparticles, which subsequently disturbed and distorted the capsule wall and drastically increased its permeability to macromolecules like FITC-labeled dextran. The capsule permeability change was estimated by taking the capsule interior and exterior fluorescent intensity ratio using confocal laser scanning microscopy. Capsules with 1 layer of Co@Au nanoparticles and 10 polyelectrolyte bilayers are optimal for magnetically controlling permeability. A theoretical explanation was proposed for the permeability control mechanisms. "Switching on" of these microcapsules using a magnetic field makes this method a good candidate for controlled drug delivery in biomedical applications.     

Kinetics of substitution of aquo ligands fromcis-diaquo-bis-(biguanide) cobalt(III) and chromium(III) ions by aspartic acid in ethanol—water mixtures

The kinetics of substitution of aqua ligands fromcis-diaqua-bis(biguanide)cobalt(III) and chromium(III) ions by aspartic acid in EtOH–H₂O media have been studied spectrophotometrically in the 30 to 45°C range. We propose the following rate law for the anation

Gallium(III) halide-catalyzed coupling of indoles with phenylacetylene: synthesis of bis(indolyl)phenylethanes

Indoles undergo smooth coupling with phenylacetylene in the presence of 10 mol % of gallium(III) chloride or gallium(III) bromide under mild conditions to afford the corresponding 1,1-bis(1H-3-indolyl)-1-phenylethanes in high yields and with high selectivity.     

Silica-alumina supported transition metal oxide catalyst for alkylation of aromatic compounds

Titanium oxide on silica-alumina support is described to be an efficient regenerable catalyst for alkylation of aromatic compounds with alkyl halides, alcohols and olefins, and the reaction is proposed to be initiated by the protonated metal active species present in the catalyst.     

On the characterization of electrified interface

Summary Estimation of zeta potential from experimental data on electroosmotic and electrophoretic effects for Zeokarb 225 (Na⁺ form)/methanol-water system has been made and discussed. Results indicate that zeta potentials estimated from electroosmotic flux and electrophoretic mobility are not in agreement and vary with applied potential difference in a linear manner. Reasons for the variation of zeta potential with electrical field have been discussed. It has been argued that zeta potentials estimated from electroosmotic data are more reliable in comparison to the values obtained from electrophoretic data.With 2 figures and 2 tables     

A Simple Alkylative 1,2-Carbonyl Transposition of Cyclohexenones

Acid catalysed dehydration of the diols 5 , derived from the cyclohexenone 3 affords mixtures of 8 and 11 . The product ratio 8/11 , although strongly dependent on both the reaction conditions and the substituent R, is independent of the diol configuration; this indicates a cationic intermediate 6 . Conditions were found, which allow the sequence A → B → C → D (Scheme 2) to be applied to the syntheses of the enones 8, 21 and 25 in fair to good yields from the corresponding cyclohexenones 3, 18 and 22 .     

Use of organic reagents in inorganic analysis

Summary Eighteen anilic acids have been prepared from maleic anhydride and various aromatic amines and their properties and analytical reactions with various metal ions have been studied. The acid prepared from benzidine was insoluble in all common solvents and, hence, its application could not be studied. Most of these reagents, except those obtained from aniline, o- and p-chloroanilines, nitranilines, p-amino-acetanilide and o-phenylenediamine, produced more or less quantitative precipitations with both thorium and zirconium. Their actions towards thorium and zirconium were very much alike. They also gave precipitations with mercury(I), lead and cerium(IV), but such precipitations were not complete. Ferrous iron showed greyish turbidity with most of the reagents, but ferric iron produced colourations varying from brown to violet, such colours were, however, found to be unstable either on standing for a while or on heating. Gold and platinum underwent reduction in presence of these reagents.Part VIII: See Z. analyt. Chem. 163, 403 (1958).The work has been carried out in the chemical laboratories of Darjeeling Government College, Darjeeling. The author is grateful to the authorities of the College for the laboratory facilities.     

Beaded reactive polymers 3 effect of triacrylates as crosslinkers on the physical properties of glycidyl methacrylate copolymers and immobilization of penicillin G acylase

Various glycidyl methacrylate (GMA) copolymers were synthesized by suspension polymerization, using pentaerythritol triacrylate (PETA), trimethylolpropane triacrylate (TMPTA), and trimethylolpropane trimethacrylate (TRIM) as crosslinking comonomers. These copolymers were evaluated for the immobilization of penicillin G acylase. Broad pore-size distribution that was observed was in the range 5-300 nm. Both surface area and pore volume increased with increase in the mole fraction of crosslinking comonomer (increasing crosslink density). The pore volume of the copolymers was more than doubled by including lauryl alcohol as porogen. Binding of penicillin G acylase (PGA) was quantitative on highly crosslinked copolymers. The expression of bound PGA was better on the relatively more hydrophilic GMA-TMPTA and GMA-PETA copolymer supports compared to the GMA-TRIM copolymers. Among the different copolymers studied, GMA-TMPTA copolymer 7411 exhibited highest activity of immobilized penicillin G acylase (167.4 IU/g) with 35.1% expression.