Determination of ofloxacin in human serum by high-performance liquid chromatography with column switching.

The chromatographic behaviour of ofloxacin on various sorbents, including ODS, C8, C1, nitril, phenyl and tert,-butyl, as stationary phases was investigated and a high-performance liquid chromatography (HPLC) assay was developed for the determination of ofloxacin in serum. The serum samples were directly introduced onto an HPLC column after filtering through a Morcut II membrane filter to remove proteins. The filtrate was concentrated on a pre-column using a phenyl stationary phase and was then introduced to an analytical column with an ODS stationary phase by column switching. Ofloxacin and enoxacin as an internal standard were detected by ultraviolet absorbance at 300 nm. Determination was possible for ofloxacin over the concentration range 50-2000 ng/ml; the limit of detection was 20 ng/ml. The recovery of ofloxacin added to serum was 88.8-101.7% with a coefficient of variation of less than 5.2%. This method is applicable to pharmacokinetic studies of patients after treatment with ofloxacin.     

Rapid determination of indium,nickel and copper in NBS standard reference material by substoichiometric radioactivation analysis

A method of rapid determination for indium, nickel and copper in Spinach (NBS; SRM-1570) by substoichiometric radioactivation analysis is described. The method is based on the principle that an equal amount of non-irradiated test sample is added to the irradiated standard sample and subsequent substoichiometric extraction for the irradiated test and standard samples is carried out. Indium is extracted as diethyldithiocarbamate into carbon tetrachloride, nickel as dimethylglyoximate into chloroform and copper as dithizonate into carbon tetrachloride. The radioactivities of these extracts are measured by NaI(Tl) or Ge(Li) detector coupled with pulse-height analyser. The analytical results obtained by the method were in good agreement with our published values and certified values by NBS.     

Surface derivatization of poly(p-phenylene terephthalamide) fiber designed for novel separation and extraction media

The surface derivatization of poly(p-phenylene terephthalamide) fiber was studied. The obtained surface-derivatized filaments were packed into a fused-silica capillary to evaluate its surface characteristics by using GC. As the stationary phase for GC the surface-derivatized fibers showed higher retention for alkanes and alkylbenzenes than that with the untreated Kevlar fiber. The improvements on the retention power and the peak shape were observed on the benzyl-modified fibrous stationary phase. The derivatized fibrous materials were also evaluated as the extraction medium in fiber-in-tube SPE, and the effect of the surface modification on the extraction power was compared to the parent fiber. The results indicated that the modified fiber possessed a higher extraction power than the untreated fiber. Based on the facts, the successful modification of the fiber surface was estimated.     

Substoichiometric extraction of phosphorus

A study of the substoichiometric extraction of phosphorus is described. Phosphorus was extracted in the form of ternary compounds such as ammonium phosphomolybdate, 8-hydroxyquinolinium phosphomolybdate, tetraphenylarsonium phosphomolybdate and tri-n-octylamine phosphomolybdate. Consequently, phosphorus was extracted substoichiometrically by the addition of a substoichiometric amount of molybdenum for all four phosphomolybdate compounds. On the other hand, phosphorus could be separated substoichiometrically with a substoichiometric amount of tetraphenylarsonium chloride or tri-n-octylamine. Stoichiometric ratios of these ternary compounds obtained substoichiometrically were 1∶12∶3 for phosphorus, molybdenum and organic reagent. Applicability of these compounds to phosphorus determination was also discussed.     

Rapid fermentation of beer using an immobilized yeast multistage bioreactor

The characteristics of yeast sulfite metabolism in a multistage bioreactor system for beer fermentation were investigated. No sulfite was produced in the continuous stirred-tank reactor (CSTR). However, large amounts were produced in the packed-bed reactor (PBR). Production of sulfite in the PBR seems to be inevitable when it is operated continuously. In order to control the sulfite level in the young beer, the yeast needs to be reactivated into the growth phase. One possible strategy to achieve this is to aerate and periodically remove yeast clogged in the reactor once every 6–7 months before the sulfite level exceeds a given concentration (e.g., 20 mg/L). It was confirmed that sulfite production is closely related to the growth condition of the yeast and is therefore important to consider in the control strategy for sulfite when using the immobilized yeast reactor for beer production.     

The fifth overtones of the C-H stretching vibrations and the bond lengths in some heterocyclic compounds

The fifth overtones of the C-H stretching vibrations of pyridine, pyrazine, thiophene, 3-methylthiophene, furan and pyrrole in the liquid state have been observed by a thermal lens technique. It was found that their frequency shifts from that of benzene are proportional to the decrease in the relevant C-H bond length.     

Development of rectangular column structured titanium oxide photocatalysts anchored on silica sheets by a wet process

Commercially available powdered photocatalysts such as P-25 are known to show high photocatalytic performance. However, in practical use, their anchoring onto a substrate without any binders is still very difficult. The purpose of this study is to design and develop high-performance photocatalysts that can be anchored onto a substrate, and to this end we have prepared a titanium oxide photocatalyst using a wet process. The results of this study led to the successful development of rectangular column structured titanium oxide crystals which could be anchored onto silica sheets. The rectangular columnar crystal was 100- 500 nm wide and 1000- 5000 nm long. Moreover, investigations on the complete oxidation reaction of acetaldehyde into CO₂ and H₂O showed a high performance equivalent to that of the most efficient marketed powdered photocatalysts.     

Dependence of the Reactivities of Titanium Enolates on How They Are Generated: Diastereoselective Coupling of Phenylacetic Acid Esters Using Titanium Tetrachloride

Oxidative coupling of phenylacetic acid esters was easily achieved by treating the esters with TiCl(4) and then adding Et(3)N to the resulting solution. The products consisted of dl- and meso-2,3-diphenylsuccinic acid esters with the Claisen condensation product, and the ratio of these products depended on the reaction conditions. Reaction conditions suitable for high dl selectivity were determined, and a dimer of titanium enolate was postulated as an intermediate responsible for the high dl selectivity. The selectivities were compared with those in known oxidative couplings in which titanium enolate intermediates are prepared through lithium enolates and silyl enol ethers. The results suggest that the reactivities of titanium enolates intermediates depend on how they are generated.     

Recent progress of high-power negative ion beam development for fusion plasma heating

A negative-ion-based neutral beam injector (N-NBI) has been constructed for JT-60U. The N-NBI is designed to inject 500 keV, 10 MW neutral beams using two ion sources, each producing a 500 keV, 22 A D⁻ ion beam. In the preliminary experiment using one ion source, a D⁻ ion beam of 13.5 A has been successfully accelerated with an energy of 400 keV (5.4 MW) for 0.12 s at an operating pressure of 0.22 Pa. This is the highest D⁻ beam current and power in the world. Co-extracted electron current was effectively suppressed to the ratio of Ie/I_D⁻ < 1. The highest energy beam of 460 keV, 2.4 A, 0.44 s has also been obtained. To realize 1 MeV class NBI system for ITER (International Thermonuclear Experimental Reactor), demonstration of ampere class negative ion beam acceleration up to 1 MeV is an important mile stone. To achieve the mile stone, a prototype accelerator and a 1 MV, 1 A test facility called MeV Test Facility (MTF) were constructed. Up to now, an H⁻ ion beam was accelerated up to the energy of 805 keV with an acceleration drain current of 150 mA for 1 s in a five stage electrostatic multi-aperture accelerator.     

Substoichiometric determination of phosphorus

Phosphorus in orchard leaves (NBS SRM-1571) and spinach (SRM-1570) was determined by various substoichiometric analytical methods such as the direct method, GRASHCHENKO's method and the method of carrier amount variation. All samples were labelled with³²P radioisotope. The data obtained by the method of carrier amount variation were also treated by the method of least squares instead of De VOE's method. Phosphorus concentration in orchard leaves was 0.206±0.011% by the direct method, 0.219±0.011% by GRASHCHENKO's method, 0.211±0.011% by the method of carrier amount variation and 0.207±0.007% by the method of least squares, respectively. These values agree with the value reported by NBS (0.21±0.01%). Furthermore, these concentrations obtained by various substoichiometric methods were compared with those by radioactivation reported in a prevoius paper.