非对称铺层复合材料层合板质量优化设计

复合材料广泛应用于航空航天等领域,追求轻量化设计已经成为研究重点.对复合材料层合板质量优化设计,可以减少层合板的纤维用量,减小层合板的质量,降低成本.首先研究复合材料层合板在承受轴向载荷时,产生的形变量、应力示意图,分析容易发生失效部位;以层合板铺层厚度为设计变量,最大应变、铺层比例等为约束条件,最小化层合板质量为优化...     

介入治疗用非血管可降解支架的研究进展

介入治疗是介于外科和内科治疗之间的新兴治疗方法,其中用于胆管、食管和气管等官腔的支架属于非血管介入治疗。非血管可降解支架与官腔具有良好的生物相容性,并且支架置入人体后,可以在一定时间内降解,转化为对人体无害的小分子排除体外。本文综述了介入治疗用非血管可降解支架的研究进展,重点介绍了非血管可降解支架的材料选择,外形设计,支架工艺(包括支架成型,覆膜改性,载药处理),性能测试(包括物理性能,力学性能,生物相容性,降解性能等)及临床应用进展。     

沉淀剂对悬浮共沉淀法制备二甲醚催化剂的影响

以无水乙醇为溶剂,将Cu、Zn和Al的硝酸盐并流共沉淀在HZSM-5分子筛的悬浮溶液中,一步合成CuO-ZnO-Al2O3/HZSM-5双功能催化剂.研究了沉淀剂的种类、加入顺序和加入量对催化剂活性的影响.结果表明,以适量的草酸作沉淀剂,采用悬浮液并流共沉淀法制备的双功能催化剂,对CO2加氢直接合成二甲醚有较高的催化性能:在固定床反应器中,温度为270℃,压力为3.0 MPa,空速为4 800 h-1的反应条件下,CO2的单程转化率达到28.7%,二甲醚的选择性达到53.2%.BET、XRD、TPR、TPD和N2O滴定等对催化剂结构表征结果表明,双功能复合催化剂CuO-ZnO-Al2O3/HZSM-5的结构影响CO2加氢合成二甲醚的催化性能.     

Chromo-chemodosimetric detection for Fe2+ by Fenton reagent-induced chromophore-decolorizing of halogenated phenolsulfonphthalein derivatives

A commercially-available sulfonphthalein derivative was demonstrated to be a chemodosimeter for Fe²⁺ and its sensing behavior was further investigated by UV-vis spectroscopy in aqueous media under the optimum conditions. In the presence of chlorophenol red (CPR) and H₂O₂, the absorption maximum at 435 nm decreased upon addition of Fe²⁺, resulting in a significant color change of the CPR solution from yellow to colorless. The chemosensor system did not show significant responses to a series of other metal ions including Al³⁺, Zn²⁺, Cd²⁺, Hg²⁺, Mn²⁺, Co²⁺, Fe³⁺, Ni²⁺, Cu²⁺, La³⁺, Ce⁴⁺, Th⁴⁺, Pd²⁺, Pb²⁺, Sb³⁺, Cr³⁺, Au³⁺, Ag⁺, Nd³⁺, Sm³⁺, alkali and alkaline earth metal cations, allowing for highly selective naked-eye detection of Fe²⁺. Quantitative analysis was carried out kinetically for practicable the Fe²⁺ assay when either fixed time method or the initial rate method was applied. When the detecting time was set, the decrease of absorbance signal was linear with Fe²⁺ concentration in the range of 0 to 7.50 × 10^?5 mol L^?1 and the regression equation was ΔA = 0.00759 + 0.00593C _Fe with a correlation coefficient r = 0.9953. The chemodosimetric system has employed an irreversible Fenton reagent-promoted oxidation of the CPR free chromophore and the hydroxyl radicals were generated in the presence of both Fe²⁺ and hydrogen peroxide. The mechanistic interpretation of the signaling process was partially confirmed by the radical scavenging experiment and the FT-IR analysis of the intermediates formed at different reaction periods.     

Easy deposition of Ag onto polystyrene beads for developing surface-enhanced-Raman-scattering-based molecular sensors

We describe a very simple electroless plating method that can be used to prepare Ag-coated polystyrene beads. Robust Ag nanostructures are reproducibly fabricated by soaking polystyrene beads in ethanolic solutions of AgNO(3) and butylamine. When the molar ratio of butylamine to AgNO(3) is far below 1.0, distinct nanosized Ag particles are formed on the polystyrene beads, but by increasing the amount of butylamine, network-like Ag nanostructures are formed that possess very broad UV/vis absorption characteristics extending from the near-UV to near-infrared regions. In conformity with the UV/vis absorption characteristics, the Ag-deposited polystyrene beads were highly efficient surface-enhanced Raman scattering (SERS) substrates, with an enhancement factor estimated using 4-aminobenzenethiol (4-ABT) as a model adsorbate to be larger than 1.1x10(6). On the basis of the nature of the SERS peaks of 4-ABT, those Ag-deposited polystyrene beads were confirmed, after attaching biotin groups over 4-ABT, to selectively recognize streptavidin molecules down to concentrations of 10(-11) g mL(-1) (i.e., approximately 0.2 pM). Since a number of different molecules can be used as SERS-marker molecules (such as 4-ABT), multiple bioassays are readily accomplished via SERS after attaching appropriate host or guest molecules onto them.     

偶氮材料——乙基橙的光致双折射特性

将偶氮化合物乙基橙样品置于一对正交的偏振片之间，用一束激发光照射该样品，分别测量 在激发光的不同强度和不同偏振方向下探测光的透射功率，研究样品的双折射特性.实验表 明，透射光的饱和值和稳定值与激发光强成正比，且与激发光偏振方向有关，探测光与激发 光振动方向的夹角(θ)为45°时，其值最大；若θ不太小（>10°），sin²2θ 与透射光的饱和值、稳定值成线性关系.同时，利用巴俾涅补偿器对样品的双折射率差进 行了测量，分别得到了绿光激发前后的准确数值为1.11×10^-3和3.57×10 ^-3. 关键词： 偶氮 双折射 测量     

Efficient gel‐type electrolyte with bismaleimide via in situ low temperature polymerization in dye‐sensitized solar cells

This study reports the characteristics of gel‐type dye‐sensitized solar cells (DSSCs), fabricated with gel‐type electrolyte containing poly‐1,1′‐(methylenedi‐4,1‐phenylene)bismaleimide (PBMI), or poly‐1,1′‐(3,3′‐dimethyl‐1,1′‐biphenyl‐4,4′‐diyl)bismaleimide (PDBBMI), or poly‐N,N′‐(4‐methyl‐1,3‐phenylene)bismaleimide (PMPBMI), prepared by in situ polymerization of the corresponding monomer without an initiator at 30 °C. Incorporating 0.3 wt % content of exfoliated alkyl‐modified nanomica (EAMNM) into PBMI‐gelled electrolyte leads to higher short‐circuit current density (J_sc = 17.14 mA cm^?2) and efficiency (η = 7.02%) than that of neat PBMI‐gel electrolyte (J_sc = 15.32 mA cm^?2, η = 6.41%). Incorporating 0.3 wt % EAMNM into PBMI‐gelled electrolyte results in remarkably stable device performance under continuous light soaking under one sun (100 mW cm^?2) at 55 °C. The efficiency of DSSCs based on PBMI/0.3 wt % EAMNM‐gelled electrolyte drops by only 1.7% (η = 6.93%) after 500 h of continuous light soaking. © 2010 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem, 2010     

Ant colony optimization for power plant maintenance scheduling optimization—a five-station hydropower system

A number of algorithms have been developed for the optimization of power plant maintenance schedules. However, the true test of such algorithms occurs when they are applied to real systems. In this paper, the application of an Ant Colony Optimization formulation to a hydropower system is presented. The formulation is found to be effective in handling various constraints commonly encountered in practice. Overall, the results obtained using the ACO formulation are better than those given by traditional methods using engineering judgment, which indicates the potential of ACO in solving realistic power plant maintenance scheduling problems.