An integrated platform for gas-diffusion separation and electrochemical determination of ethanol on fermentation broths

An integrated platform was developed for point-of-use determination of ethanol in sugar cane fermentation broths. Such analysis is important because ethanol reduces its fuel production efficiency by altering the alcoholic fermentation step when in excess. The custom-designed platform integrates gas diffusion separation with voltammetric detection in a single analysis module. The detector relied on a Ni(OH)₂-modified electrode. It was stabilized by uniformly depositing cobalt and cadmium hydroxides as shown by XPS measurements. Such tests were in accordance with the hypothesis related to stabilization of the Ni(OH)₂ structure by insertion of Co²⁺ and Cd²⁺ ions in this structure. The separation step, in turn, was based on a hydrophobic PTFE membrane, which separates the sample from receptor solution (electrolyte) where the electrodes were placed. Parameters of limit of detection and analytical sensitivity were estimated to be 0.2% v/v and 2.90 μA % (v/v)⁻¹, respectively. Samples of fermentation broth were analyzed by both standard addition method and direct interpolation in saline medium based-analytical curve. In this case, the saline solution exhibited ionic strength similar to those of the samples intended to surpass the tonometry colligative effect of the samples over analyte concentration data by attributing the reduction in quantity of diffused ethanol vapor majorly to the electrolyte. The approach of analytical curve provided rapid, simple and accurate analysis, thus contributing for deployment of point-of-use technologies. All of the results were accurate with respect to those obtained by FTIR method at 95% confidence level.     

Development of resonance‐enhanced multiphoton ionization SNMS for state‐selective detection of sputtered atoms under low‐energy ion irradiation

An instrument for a sputtered neutral mass spectrometry with a quadrupole mass spectrometer (QMS) by resonance‐enhanced multiphton ionization method is developed to study sputtered neutrals emission phenomena under ion irradiation in a low‐energy region. We have prepared a pulsed primary ion beam and an ion counting system, and have optimized the operation parameter including a sample bias, energy analyzer voltages, pulsed timing of laser and ion beam, etc. A yield ratio of the lowest‐lying excited state a⁵S₂ to the ground state a⁷S₃ for sputtered Cr atoms has been measured as a function of incident energy of Ar⁺ and O₂⁺ down to 600 eV using a polycrystalline Cr sample. The yield ratio has become a constant value for the Ar⁺ incidence, while it has exponentially increased below 1 keV for the O₂⁺ incidence. It is found that the internal energy distribution of sputtered Cr atoms has been significantly influenced by oxygen density at the surface. Copyright © 2011 John Wiley & Sons, Ltd.     

Quantum yields and quantitative spectra of firefly bioluminescence with various bivalent metal ions

We measured quantitative spectra of firefly (Photinus pyralis) bioluminescence in the presence of Zn²⁺ and other bivalent metal ions to investigate the effects of these metal ions on luciferin‐luciferase reaction. We studied the dependence of the quantum yield and spectrum on quantity and kind of bivalent metal ions. Adding various amounts of Mg²⁺, Mn²⁺ and Ca²⁺ produced virtually no change in the quantum yields or the spectra of bioluminescence. In contrast, increasing amounts of ions such as Zn²⁺ and Cd²⁺ decreased quantum yields and changed the bioluminescence color from yellow‐green to red. Quantitative analysis showed that the sensitivities of the quantum yield and color to various metal ions were in the order of Hg²⁺>Zn²⁺, Cd²⁺>Ni²⁺, Co²⁺, Fe²⁺≫Mg²⁺, Mn²⁺, Ca²⁺. We propose that the changes in quantum yield and spectrum caused by the metal ions are due to their effect on luciferase that surrounds oxyluciferin during its radioactive decay. We also found that having more metal ions accelerated bioluminescence reactions. The sensitivity of the reaction rate had no correlation with those of the quantum yield and spectrum.     

Investigation of thermal hazard during the hydrosilylation of 1,6-divinyl(perfluorohexane) with trichlorosilane

In this study, we examined the reaction hazard during the hydrosilylation reaction between trichlorosilane (TCS) and 1,6-divinyl(perfluorohexane) (FDV) in the presence of a butanol solution of chloroplatinic acid (Pt-Cat) as the catalyst. Assuming the three industrial risks of excessive addition of Pt-Cat, contamination by iron rust and mixing with cooling water, we observed the temperature and pressure change of TCS/FDV with an excessive amount of Pt-Cat, TCS/FDV/Pt-Cat with Fe₂O₃ and TCS/FDV/Pt-Cat with distilled water, using an accelerating rate calorimeter (ARC). The temperature and pressure greatly increased, especially in the sample with Fe₂O₃. For instance, in TCS/FDV/Pt-Cat with 1.5 wt.% Fe₂O₃, the heat release rate exceeded 624 K · min^?1 and the pressure rose above 25 MPa during the exothermic reaction.     

Development of a Carbon Paste Electrode for Lactate Detection Based on Meldola’s Blue Adsorbed on Silica Gel Modified with Niobium Oxide and Lactate Oxidase

A reagentless amperometric biosensor sensitive to lactate was developed. The sensor employs a carbon paste electrode modified with lactate oxidase (LOx) and Meldola’s Blue (MB) adsorbed on silica gel coated with niobium oxide. The dependence on the biosensor response was investigated in terms of pH, supporting electrolyte, ionic strength, lactate oxidase (LOx) amounts and applied potential. The biosensor showed an excellent operational stability (96 % of the activity was maintained after 150 determinations) and storage stability (allowing measurements for more than 1.5 months, when stored in a refrigerator). The proposed biosensor also presented good sensitivity allowing lactate quantification at levels down to 6.5×10^?7 mol L^?1. Moreover, the biosensor showed a good linear response range (from 0.1 to 5.0 mmol L^?1 for lactate). Lactate analysis in biological samples such as blood was also performed. The precision of the data obtained by the proposed biosensor showed reliable results for real complex matrices.     

Emission control by binary energy transfer processes on oligouridine

Fluorescent oligonucleotides have been designed on which two different energy transfer processes were mounted together: excitonic interaction and FRET. The fluorescence emission of the oligonucleotides was controlled well by the two different energy transfer processes, in response to their hybridization to the complementary RNA both in vitro and in cells.     

Palladium-catalyzed 1,1-aryloxygenation of terminal olefins

This paper describes the 1,1-arylacetoxylation of diverse α-olefins using organostannanes and hypervalent iodine oxidants. The reaction provides a convergent approach for generating a C-C and a C-O bond as well as a new stereocenter in a single catalytic transformation.     

Exciton-polariton transmission in quantum dot waveguides and a new transmission path due to thermal relaxation

Exciton-polariton transmission in quantum dot waveguides is investigated with quantum time-evolution equations in Liouville space for exciton wave packet dynamics. The transmission efficiency of the exciton-polariton wave with the longitudinal and transverse mode transformations strongly depends on the geometric parameters (bending angle and interdot distance) of the waveguides and on configuration of an additional branch attached to the waveguide. We have numerically demonstrated that the transmission efficiency significantly improves by controlling these geometric parameters and the configuration of the branched waveguide. The optimal bending angle for efficient transmission with the longitudinal and transverse mode transformations deviates from the right angle owing to more than nearest-neighbor-site interactions through a shortcut. We have also found that existence of thermal relaxation enables to open a new transmission channel along which the exciton-polariton transmission through the Coulomb interaction is suppressed.     

Simulation of metastable zone width and induction time for a seeded aqueous solution of potassium sulfate

The metastable zone width (MSZW, ΔT_m) and induction time (t_ind) were determined with computer simulation for seeded batch crystallization of potassium sulfate from aqueous solution. The MSZW and induction time determined with simulation showed the same behavior as experimental values reported in the literature; log (ΔT_m) increased linearly with an increase in log R (R: cooling rate) and t_ind decreases in proportion to (ΔT)⁻ⁿ (ΔT: supercooling, n: nucleation order in the secondary rate expression of B=k_n(ΔT)ⁿ). The secondary nucleation parameters (k_n and n) were deduced both from the simulated MSZW and induction times by using the previously proposed model [J. Cryst. Growth, 2010, 312, 548–554]. The secondary nucleation rate calculated with the deduced parameters was in agreement with that calculated with the parameters input for simulation.