Absolute frequency measurement of rubidium 5S-7S two-photon transitions with a femtosecond laser comb

The absolute frequencies of rubidium 5S-7S two-photon transitions at 760 nm are measured to an accuracy of 20 kHz with an optical frequency comb based on a mode-locked femtosecond Ti:sapphire laser. The rubidium 5S-7S two-photon transitions are potential candidates for frequency standards and serve as important optical frequency standards for telecommunication applications. The accuracy of the hyperfine constant of the 7S1/2 state is improved by a factor of 5 in comparison with previous results.     

电子储存环中插入元件的非线性束流动力学的Lie代数方法

介绍了用能保证哈密顿系统“辛”性质的Lie映射方法来研究电子储存环中的插入元件对束流动力学的影响.并以此方法对合肥光源中将要安装的波荡器UD?–?1对储存环的影响作了初步的研究     

Correlation between Al2O3 particles and interface of Al-Al2O3 coatings by cold spray

Al-Al₂O₃ composite coatings with different Al₂O₃ particle shapes were prepared on Si and Al substrate by cold spray. The powder compositions of metal (Al) and ceramic (Al₂O₃) having different sizes and agglomerations were varied into ratios of 10:1 wt% and 1:1 wt%. Al₂O₃ particles were successfully incorporated into the soft metal matrix of Al. It was found that crater formation between the coatings and substrate, which is typical characteristic signature of cold spray could be affected by initial starting Al₂O₃ particles. In addition, when the large hard particles of fused Al₂O₃ were employed, the deep and big craters were generated at the interface between coatings and hard substrates. In the case of pure soft metal coating such as Al on hard substrate, it is very hard to get proper adhesion due to lack of crater formation. Therefore, the composite coating would have certain advantages.     

Abnormal adsorption behavior of dimethyl disulfide on gold surfaces

Adsorption of dimethyl disulfide (DMDS) on gold colloidal nanoparticle surfaces has been examined to check its binding mechanism. Differently from previous results, DMDS molecules adsorbed on the gold surface at high concentration showed the S–S stretching band at 500 cm⁻¹ in surface-enhanced Raman scattering (SERS) spectra, which indicates the presence of intact adsorption of DMDS molecules. However, it was found that the S–S bond of disulfides was easily cleaved on the gold surface at low concentration. These behaviors were not observed for diethyl disulfide (DEDS) or diphenyl disulfide (DPDS). Our results indicate that DMDS molecules with the shortest alkyl chains on the gold surface can be inserted into self-assembled monolayers (SAMs) without the S–S bond cleavage during self-assembly due to insufficient lateral van der Waals interaction and the low adsorption activity of disulfides, whereas DEDS with longer alkyl chains or DPDS with the weak disulfide bond dissociation energy would not. These unusual DMDS adsorption behaviors were examined by scanning tunneling microscopy (STM) and X-ray photoelectron spectroscopy (XPS). We also compared the bonding dissociation energy of the S–S bonds of various disulfides by means of a density functional theory (DFT) calculation.     

Bandwidth-tunable band-rejection filter based on helicoidal fiber grating pair of opposite helicities

We have developed a new type of all-fiber band-rejection filter consisting of a helicoidal long-period fiber grating pair of opposite helicities, which provides highly flexible spectral control over the rejection bandwidth. The detailed fabrication method and operation principles of the proposed bandwidth-tunable band-rejection filter are described. The proposed device enables unique rejection bandwidth tuning over more than 14 nm at the rejection level of 15 dB, with low insertion loss and polarization-dependent loss achieved by adjusting torsion stress.     

Formation of p-type ZnO film on InP substrate by phosphor doping

ZnO thin film was initially deposited on InP substrate by radio frequency (rf) magnetron sputtering and the diffusion process was performed using the closed ampoule technique where Zn₃P₂ was used as the dopant source. To verify the junction formation of ZnO thin films, the electrical properties were measured, and the effects of Zn₃P₂ diffusion on ZnO thin films were investigated. It is observed that the electrical property of the film is changed from n-type to p-type by dopant diffusion effect. Based on the results, it is confirmed that ZnO thin films can be a potential candidate for ultraviolet (UV) optical devices.     

左右手系材料界面处全反射行为的特性

基于电磁场理论，推导了左右手系材料界面处发生全反射时的物理特性，分析了相位变化情况.提出利用左右手系材料构成周期性结构，观测全反射时介质中隐失波干涉的实验设想，并从理论上计算了干涉条纹的分布. 关键词： 左手材料 负折射率 全反射 隐失波     

Reflective and photoacoustic infrared spectroscopic techniques in assessment of binding media in paintings

This study proposes a method to estimate the lipid content in binding media in paintings that can be used at any laboratory equipped with an infrared spectrometer. The lipid content estimator, termed greasiness index (GI), is defined as a ratio of lipid ν(C=O) and protein amide I bands at 1743 and 1635 cm⁻¹, respectively. Three Fourier transform infrared (FTIR) sampling techniques were evaluated for GI determination: reflective attenuated total reflection—ATR, specular reflection microscopy—μSR and photoacoustic—PAS. A set of model painting samples containing three tempera binding media (casein, egg, egg + oil), seven pigments and one varnish type were used in the study. Multivariate analysis was used to evaluate the resulting data. A good reproducibility of GI was obtained by ATR and PAS but not with μSR. The discriminative power of the technique is higher for unvarnished samples, but, generally, the GI estimator can be used for the categorisation of binding media in large populations of painting samples analysed with the same FTIR technique (sampling technique, detection, etc.).     

Transient binary nucleation from ethanol-hexanol vapour

We study condensation of ethanol-hexanol vapour by numerical solution of kinetic equations. The number of droplets formed in unit volume is computed within self-consistent classical model. It is shown that formation of ethanol-rich droplets prevails at the initial stage of nucleation process, but in the stationary state formation of droplets near the saddle point (on cluster formation energy surface) plays the dominant role. Presented at the 6th Joint Seminar “Development of Materials Science in Research and Education”, Karlštejn, Czech Republic, 17–19 September 1996. This work was supported by Grant No. A1010615 of the Grant Agency of the Academy of Sciences of the Czech Republic.     

铋镓共掺的高浓度掺铒石英基光纤中铒离子团簇率的实验研究

使用MCVD法结合溶液掺杂技术制作了铒铋镓共掺的石英基光纤.根据光纤吸收谱，得出其中铒离子浓度是5.24×10²⁵/m³.然后提出了一种新的利用透射率测定掺铒光纤的团簇率的实验方法，该方法相比于以前的方法更简单有效.利用该方法，测得了自制铒铋镓共掺光纤中团簇率.通过与前人的结果相比较，充分说明铋和镓的掺入大大提高了铒离子在石英基光纤中的溶解度，抑制了铒离子形成团簇.