Study on adsorption behavior of cesium using ammonium tungstophosphate (AWP)-calcium alginate microcapsules

A functional microcapsule was prepared by encapsulating the fine crystalline ammonium tungstophosphate(AWP) in calcium alginate polymer(CaALG).The characterization of AWP-CaALG microcapsule was examined by SEM and EPMA.The adsorption behavior of Cs(I),Rb(I),Sr(II),Pd(II),Ru(III),Rh(III),La(III),Ce(III),Dy(III) and Zr(IV) was investigated by the batch method.The batch experiments were carried out by varying the shaking times,HNO 3 concentration,and initial concentration of metal ions.Relatively large K d values above 10 5 cm 3 /g for Cs(I) were obtained in the range of 0.1-5 M HNO 3,resulting in a separation factor of Cs/Rb exceeding 10 2.In contrast,the K d values of Sr(II),Pd(II),Ru(III),La(III),Dy(III),Ce(III) and Zr(IV) were considerably lower than 50 cm 3 /g.The K d value of Cs(I) decreased in the order of the coexisting ions,H + > Na + >> NH 4 +,and a linear relationship with a slop of about 1 was obtained between log K d and log [NH 4 + ]([NH 4 + ] > 0.01 M).The adsorption of Cs(I) was found to be controlled by chemisorption mechanism,and followed a Langmuir-type adsorption equation.A high uptake percentage of 99.4% for Cs(I) was obtained by using the dissolved solutions of spent fuel from FBR-JOYO(JAEA).     

Requirements for soft magnetic underlayer (SUL)—Micromagnetic simulations of single-pole-type write heads and SUL systems

Landau-Lifshitz-Gilbert micromagnetic models were used to analyze the head field distributions and high-frequency responses for various soft magnetic underlayer thicknesses (t-SUL) and saturation magnetization flux densities (B_s) of single-pole-type (SPT) head-SUL systems. It was found that B_s of 10-12 kG and t-SUL of 30-45 nm would be sufficient for the examined head and perhaps for most next generation head-SUL systems. Antiferromagnetic coupling in the SUL affects the head and SUL magnetization and, eventually, the head field. With regard to the head magnetization response, it was found that the magnetization under the coil responded first, while the response at the main pole tip was quite slow, even compared with the head field. The main pole tip of the head was fully saturated and the main pole yoke was almost saturated, while the SUL was not saturated in the examined head-SUL system.     

The effect of 1,3:2,4-<Emphasis Type="Italic">bis</Emphasis>-<Emphasis Type="Italic">O</Emphasis>-(<Emphasis Type="Italic">p</Emphasis>-methylbenzylidene)-<Emphasis Type="SmallCaps">d</Emphasis>-sorbitol (PDTS) on uniaxial elongational viscosity of polypropylene

We investigated the dynamic viscoelasticity and elongational viscosity of polypropylene (PP) containing 0.5 wt% of 1,3:2,4-bis-O-(p-methylbenzylidene)-d-sorbitol (PDTS). The PP/PDTS system exhibited a sol–gel transition (T _gel) at 193 °C. The critical exponent n was nearly equal to 2/3, in agreement with the value predicted by a percolation theory. This critical gel is due to a three-dimensional network structure of PDTS crystals. The elongational viscosity behavior of neat PP followed the linear viscosity growth function 3η ⁺ (t), where η ⁺ (t) is the shear stress growth function in the linear viscoelastic region. The elongational viscosity of the PP/PDTS system also followed the 3η ⁺ (t) above T _gel but did not follow the 3η ⁺ (t) and exhibited strong strain-softening behavior below T _gel. This strain softening can be attributed to breakage of the network structure of PDTS with a critical stress (σ _c) of about 10⁴ Pa.     

Uniaxial elongational viscosity of PS/a small amount of UHMW-PS blends

A series of polystyrene (PS) and a small amount of ultra high molecular weight (UHMW) PS blends have been prepared by using tetrahydrofuran (THF). Matrix PS has an M_w of 423,000 (M_w/M_n= 2.36) and UHMW-PS has either an M_w of 3,220,000 (M_w/M_n= 1.05) or 15,400,000 (M_w/M_n=1.30) in the range of concentration from 0 wt% to 1.5 wt%. The influence of a small amount of UHMW on dynamic viscoelasticity was investigated. At the frequency lower than 0.001 rad/s, the enhancement of G′ was observed by the incorporation of a small amount of UHMW. And the degree of enhancement was in the order of M_w of UHMW and its concentration. The measurement of uniaxial elongational viscosity for the blends was performed and the effects of UHMW on strain-hardening properties were analyzed at equal strain-rate conditions. The concentration of UHMW where the strain-hardening becomes substantially stronger was determined. To get more insight into the cause of enhancement of strain-hardening at a certain concentration, the damping function from step-shear stress relaxation was measured. The influence of a small amount of UHMW on the damping function was found to be small. It was interpreted, from time- and strain-dependency points, that the enhancement of strain-hardening by a small amount of UHMW was governed by the long relaxation time. Received: 6 September 2000 Accepted: 11 January 2001     

Nickel-catalyzed intermolecular codimerization of acrylates and alkynes

The linear codimerization of acrylates and alkynes to produce 1,3-dienes is successfully demonstrated using a nickel catalyst in association with 2-aminopyridine as an additive.     

An analysis for forced convection heat transfer from external surfaces to non-Newtonian fluids

A theoretical analysis has been proposed for the forced convection heat transfer from external surfaces immersed in non-Newtonian fluids of the power-law model. The integral treatment previously introduced for Newtonian fluids has been successfully extended to the non-Newtonian fluids over a flat plate and a wedge of an arbitrary included angle. The integral momentum and energy equations are transformed into a pair of characteristic equations, which can readily be solved for the velocity shape factor and the boundary layer thickness ratio, once the exponents in the expressions for the power-law model, free stream velocity and wall temperature variation are specified. It has been also found that an asymptotic expression derived under the assumption of large Prandtl number, is valid practically for all power-law fluids, and hence, can be used for a speedy, and yet accurate estimation of the local heat transfer to non-Newtonian fluids.     

Direct formation of a surface-relief grating on glass by ultraviolet visible laser irradiation

Surface-relief gratings were directly fabricated onto a glass surface by UV-visible laser irradiation. The glass surface was pretreated by molten salt, including Ag ions. Periodic intensity modulation of the laser light was conducted with a phase mask or by an interference technique. A pattern generated by intensity modulation was precisely transcribed onto the glass surface and a surface-relief grating was formed. The period and depth of the grating were 0.5 to 10 microm and less than 0.8 microm, respectively. The cross-sectional profile of the grating was sinusoidal or triangular, with very smooth surface morphology.     

A longitudinal view of mathematics achievement of primary students: case studies from Japan, Singapore, and the United States

This paper shares results from a secondary analysis of data from the participation of Japanese, Singaporean, and U.S. students in the International Project on Mathematical Attainment (IPMA). IPMA was a longitudinal study to assess the mathematics achievement of primary students from their first year of schooling through the end of fifth grade. Tests were constructed to enable achievement on the same items to be assessed over multiple years, thus permitting the assessment of growth in achievement throughout primary school. Achievement is compared to the grade at which the content is introduced so that achievement can be related to students’ opportunity to learn.