1,3,4-oxadiazolin-2-ones from carbo-t-butoxyhydrazones

5-Substituted-1,3,4-oxadiazolin-2-ones 2 were synthesized by the oxidation of carbo-t-butoxyhydrazones 1 of aromatic aldehydes with lead tetraacetate or, preferably, iodosobenzene diacetate. In some instances 5-acetoxy-1,3,4-oxadiazoles 3 were obtained along with 2 . The oxidation of carboethoxyhydrazones 4 gave 2-ethoxy-1,3,4-oxadiazoles 5 .     

Preconcentration and separation of copper(II), cadmium(II) and chromium(III) in a syringe filled with 3-aminopropyltriethoxysilane supported on silica gel

In this study, a syringe was filled with silica gel loaded with 3-aminopropyltriethoxysilane, for the separation and preconcentration of copper, cadmium and chromium prior to their determination by graphite furnace atomic absorption spectrometry (GFAAS) in seawater. For this purpose, a syringe was filled with 0.5 g of modified silica gel and the sample solution was drawn into the syringe and ejected back again. The analyte elements were quantitatively retained at pH 5. Then, the elements sorbed by the silica gel were eluted with 2.0 M of HCl and determined by GFAAS. At optimum conditions, the recovery of Cu, Cd and Cr were 96-98%. Detection limits (3delta) were 6.6, 7.5 and 6.0 micro g L(-1) for Cu, Cd and Cr, respectively. The elements could be concentrated by drawing and discharging several portions of sample successively but eluting only once. Cu, Cd and Cr added to a seawater sample were quantitatively recovered (>95%) in the range of the 95% confidence level. The method proposed in this paper was compared with a column technique. Optimum experimental conditions, reproducibility, precision and recoveries of both techniques are the same, but the syringe technique is much faster, easier and more practical than the column technique. It is a portable system and allows one to make the sorption process in the source of sample. In addition, the risk of contamination is less than in the column technique.     

Borate adsorption at Pt(111) in acidic medium

The adsorption/desorption process of borate was studied at Pt(111) in acidic solution by cyclic voltammetry. A so-called butterfly wave in the cyclic voltammogram of Pt(111) in HClO₄ shifted to negative direction upon the addition of boric acid with the disappearance of its sharp spikes. The shift in potential was found to be −57 mV with a tenfold increase of boric acid concentration. This illustrates that this anomalous wave is due to borate adsorption/desorption by a one-electron transfer process. The borate adsorption/desorption wave was observed to shift by −63 mV/pH. At pH>3, the anomalous wave splits forming two separate waves, depending on the pH and the scan rate. The appearance of two waves is assigned to the change in the adsorption mode of borate or the participation of OH in the adsorption process.     

Coordination of solvent molecules to VO(acac)<Subscript>2</Subscript> complexes in solution studied by hyperfine sublevel correlation spectroscopy and pulsed electron nuclear double resonance

Interactions and binding sites of the solvent molecules chloroform and ethanol to bis(acetylacetonate)oxovanadium(IV) (VO(acac)₂) complexes in (frozen) solutions have been investigated by pulsed electron nuclear double resonance, sum peak electron spin echo envelope modulation and hyperfine sublevel correlation spectroscopy. The experimental proton hyperfine coupling data of coordinating solvent molecules have been interpreted using quantum chemical calculations (density functional theory). Experimental and computed hyperfine couplings indicate that ethanol coordinates to vanadium in the equatorial plane of VO(acac)₂ and chloroform interacts via hydrogen bonding to oxygens of the acac ligands.     

Ethylene- ando-phenylenediamine-N,N′-bis(dimethylmethylenephosphonic) acids as complexing agents

Summary Ethylene- ando-phenylene-diamine-N, N-bis(dimethylmethylenephosphonic) acids form polymeric complexes of general formula M₂L · xH₂O (M = Mn^II, Co^II, Ni^II, Cu^II, Zn^II, Cd^II or Pb^II; x=2 or 4). These have octahedral geometry and are polymeric, according to i.r. (far and near) and electronic spectral data and magnetic moment and thermogravimetric studies. The ligands are thought to be tetradentate for each metal atom, coordination taking place through phosphoryl oxygen and amino-group nitrogen.     

A Note on the Indirect Controls for a Coupled System of Wave Equations

By a procedure of successive projections, the authors decompose a coupled system of wave equations into a sequence of sub-systems. Then, they can clarify the indirect controls and the total number of controls. Moreover, the authors give a uniqueness theorem of solution to the system of wave equations under Kalman’s rank condition.     

Influence of crystallite size on acetone hydrogenation over copper catalysts

Acetone hydrogenation was studied over a family of Cu/SiO2 catalysts as well as UHP Cu powder and a Cu chromite catalyst. Oxygen chemisorption via dissociative N2O adsorption was used to count surface Cu atoms and calculate crystallite sizes, and a microwave absorption technique was used to measure the electrical conductivity of these Cu particles. Under differential reaction conditions at 423 K and 1 atm, all catalysts exhibited deactivation on stream and activities were typically 10-20% of their initial values after 3-4 h on stream. However, initial turnover frequencies (TOFs) varied from 0.056 s(-1) on the most highly dispersed Cu catalyst to 0.50 s(-1) on Cu powder, with the highest TOF of 2.4 s(-1) occurring on 110 nm crystallites. A similar trend with a broader (80-fold) variation was observed in the "steady-state" TOF values. Apparent activation energies varied between 11 and 14 kcal/mol. These initial TOF values are in good agreement with previous results, and a correlation exists between TOF and Cu crystallite size in this reaction, which appears to be structure sensitive. In addition, the electrical conductivity of these dispersed Cu nanoparticles, which was always less than that of bulk Cu, also increased with increasing Cu crystallite size; consequently, the change in this parameter may offer a possible explanation for the increase in TOF.     

Orientation control of perovskite thin films on glass substrates by the application of a seed layer prepared from oxide nanosheets

Orientation control of perovskite compounds was investigated by the application of a seed layer prepared from oxide nanosheets. An aqueous suspension of oxide nanosheets was prepared by the exfoliation of a layered compound of KCa₂Nb₃O₁₀ oxide grains. A seed layer composed of (TBA)Ca₂Nb₃O₁₀ nanosheets (TBA = tetrabutylammonium) was formed on a glass substrate by simply dip coating it in the suspension. Two kinds of perovskite compounds, LaNiO₃ (LNO) and Pb(Zr,Ti)O₃ (PZT) with a preferred orientation of (00l) were successfully grown on this seeded glass substrate. In this study, the relation between lattice mismatch and electrical properties is investigated. A large, oriented PZT film with a size of 5 ×4 cm shows an improved P-E hysteresis behavior by use of this orientation control.     

An approximate max-flow min-cut relation for undirected multicommodity flow,with applications

In this paper, we prove the first approximate max-flow min-cut theorem for undirected multicommodity flow. We show that for a feasible flow to exist in a multicommodity problem, it is sufficient that every cut's capacity exceeds its demand by a factor ofO(logClogD), whereC is the sum of all finite capacities andD is the sum of demands. Moreover, our theorem yields an algorithm for finding a cut that is approximately minimumrelative to the flow that must cross it. We use this result to obtain an approximation algorithm for T. C. Hu's generalization of the multiway-cut problem. This algorithm can in turn be applied to obtain approximation algorithms for minimum deletion of clauses of a 2-CNF formula, via minimization, and other problems. We also generalize the theorem to hypergraph networks; using this generalization, we can handle CNF clauses with an arbitrary number of literals per clause.Most of the results in this paper were presented in preliminary form in Approximation through multicommodity flow,Proceedings, 31th Annual Symposium on Foundations of Computer Science (1990), pp. 726–737.Research supported by the National Science Foundation under NSF grant CDA 8722809, by the Office of Naval and the Defense Advanced Research Projects Agency under contract N00014-83-K-0146, and ARPA Order No. 6320, Amendament 1.Research supported by NSF grant CCR-9012357 and by an NSF Presidential Young Investigator Award.     

Safety Stock Determination with Serially Correlated Demand in a Periodic-Review Inventory System

We consider a periodic-review inventory replenishment model with an order-up-to-R operating doctrine for the case of deterministic lead times and a covariance-stationary stochastic demand process. A method is derived for setting the inventory safety stock to achieve an exact desired stockout probability when the autocovariance function for Gaussian demand is known. Because the method does not require that parametric time-series models be fit to the data, it is easily implemented in practice. Moreover, the method is shown to be asymptotically valid when the autocovariance function of demand is estimated from historical data. The effects on the stockout rate of various levels of autocorrelated demand are demonstrated for situations in which autocorrelation in demand goes undetected or is ignored by the inventory manager. Similarly, the changes to the required level of safety stock are demonstrated for varying levels of autocorrelation.