一种测定反应体系压力变化的无汞反应动力学装置

测量反应体系压力变化的装置已有报道,但本文装置具有操作方便、记数准确等优点。 1 实 验 1.1 实验原理及试剂 详见文献。 1.2 装置及仪器 本文的无汞动力学测量装置用于乙炔氢氯化均相催化反应力学研究,其组装图如图1所示。     

Adsorption enthalpy and desorption enthalpy during displacement of adsorbate to solvent in a liquid-solid system

The adsorption heat of the stoichiometric displacement process for the adsorption of a solute in a liquid-solid system was investigated. On the basis of the SDM-A and the rule of the additivity of energy, an expression which describes the dependence of the adsorption enthalpy on the nature and concentration of the solute, and on the solvent and adsorbent, was derived. The adsorption heat determined for the solute with the traditional method can be divided into two independent fractions, relating to the adsorption of the solute and to the desorption of the solvent. Experimental data on both isotherms from the literatures and precise calorimetry were used to test the adsorption heat and its fractions computed quantitatively via the equations presented in this study, and a satisfactory degree of conformity between them was obtained. Supported by the Natural Science Foundation of Shaanxi Province in China.     

High performance organic field-effect transistors based on amphiphilic tris(phthalocyaninato) rare earth triple-decker complexes

LB films of three amphiphilic tris(phthalocyaninato) rare earth triple-decker complexes with crown-ethers as hydrophilic heads and long alkyl chains as hydrophobic tails have been prepared and found to display very well ordered layer structures, as proved by pi-A isotherms, UV-vis and polarized absorption spectra, X-ray diffraction experiments, and microscopic morphology characterization. These LB films have been fabricated into field-effect transistor (FET) devices, which show carrier mobilities as high as 0.24-0.60 cm2 V-1 s-1, among the highest mobilities achieved thus far for all LB film-based OFETs.     

In situ UV-visible spectroscopic measurements of kinetic parameters and active sites for catalytic oxidation of alkanes on vanadium oxides

In situ diffuse reflectance UV-visible spectroscopy was used to measure the dynamics of catalyst reduction and oxidation during propane oxidative dehydrogenation (ODH) on VOx/gamma-Al2O3. Transients in UV-visible intensity in the near-edge region were analyzed using a mechanistic model of ODH reactions. Rate constants per site for the kinetically relevant reduction step (C-H bond activation) measured using this analysis are slightly larger than those obtained from steady-state ODH rates normalized by surface V. The ratio of these values provides a measure of the fraction of the V surface sites that are active for ODH (0.6-0.7, for V surface densities of 2.3-34 V nm(-2)). This suggests that some of the V atoms are either inaccessible or inactive. Reoxidation rate constants, which cannot be obtained from steady-state analysis, are 10(3)-10(5) times larger than those for the C-H bond activation reduction step.     

Influence of the water molecule on cation-pi interaction: ab initio second order Møller-Plesset perturbation theory (MP2) calculations

The influence of introducing water molecules into a cation-pi complex on the interaction between the cation and the pi system was investigated using the MP2/6-311++G method to explore how a cation-pi complex changes in terms of both its geometry and its binding strength during the hydration. The calculation on the methylammonium-benzene complex showed that the cation-pi interaction is weakened by introducing H(2)O molecules into the system. For example, the optimized interaction distance between the cation and the benzene becomes longer and longer, the transferred charge between them becomes less and less, and the cation-pi binding strength becomes weaker and weaker as the water molecule is introduced one by one. Furthermore, the introduction of the third water molecule leads to a dramatic change in both the complex geometry and the binding energy, resulting in the destruction of the cation-pi interaction. The decomposition on the binding energy shows that the influence is mostly brought out through the electrostatic and induction interactions. This study also demonstrated that the basis set superposition error, thermal energy, and zero-point vibrational energy are significant and needed to be corrected for accurately predicting the binding strength in a hydrated cation-pi complex at the MP2/6-311++G level. Therefore, the results are helpful to better understand the role of water molecules in some biological processes involving cation-pi interactions.     

The 4051-Angstroms band of C3 (A 1Piu-X 1Sigmag +, 000-000): perturbed low-J lines and lifetime measurements

Rotational analyses have been carried out at high resolution for the 000-000 and 000-100 bands of the A (1)Pi(u)-X (1)Sigma(g) (+) transition of supersonic jet-cooled C(3). Two different spectra have been recorded for each band, using time gatings of 20-150 and 800-2300 ns. At the shorter time delay the spectra show only the lines observed by many previous workers. At the longer time delay many extra lines appear, some of which have been observed previously by [McCall et al.Chem. Phys. Lett. 374, 583 (2003)] in cavity ring-down spectra of jet-cooled C(3). Detailed analysis of these extra lines shows that at least two long-lived states perturb the A (1)Pi(u), 000 state. One of these appears to be a (3)Sigma(u) (-) vibronic state, which may possibly be a high vibrational level of the b (3)Pi(g) state, and the other appears to be a P = 1 state with a low rotational constant B. Our spectra also confirm the reassignment by McCall et al. of the R(0) line of the 000-000 band, which is consistent with the spectra recorded towards a number of stars that indicate the presence of C(3) in the interstellar medium. Fluorescence lifetimes have been measured for a number of upper-state rotational levels. The rotational levels of the A (1)Pi(u) state have lifetimes in the range of 230-190 ns, decreasing slightly with J; the levels of the perturbing states have much longer lifetimes, with some of them showing biexponential decays. An improved value has been obtained for the nu(1) vibrational frequency of the ground state, nu(1) = 1224.4933 +/- 0.0029 cm(-1).     

O（^3P）原子与丙醛和正丁醛化学反应动力学研究

我们已对O(~3p)原子和酮类分子化学反应速率常数进行了系列测定,分析讨论了羰基对O(~3p)抽提氢原子反应速率的影响,关于O(~3p)与醛类分子反应速率的测定也有报道。本文用流动微波放电-化学发光光子计数方法测定O(~3p)原子与丙醛和正丁醛化学反应速率常数及其与温度的关系,并由动力学数据对醛基中C—H键的离解能进行了讨论。     

An Investigation on the Effect of Arsenic Poisoning on Humans,Agriculture, and Fisheries

The purpose of this investigation is to try and understand the degree of arsenic poisoning in the waste water from agricultural chemical factories which release effluents into the waterways in their vicinity. The method of determination is to use the water samples, soil, fish, clams, shell-fish, etc. found in the areas along the canals and aqueducts and those which lie upstream, midstream, and downstream and also the hair samples of people living in the contiguous areas, to check for the levels of arsenic in them by emission spectroscopy. From the analysis during a one year investigation, we find that the level of As in the water creatures of Chungkang Stream and Lu-Er-Men Stream is much higher than in the other water areas of Taiwan such as along beaches and the other rivers; the levels in the hair of the people who live nearby these water courses have a certain degree of correspondence with their eating habits and the quantity of food eaten; however, even those people who eat relatively little have almost 3% As, beyond the 2 mg/kg limit allowed for human beings. We are fully aware of the high level of food contamination on Taiwan, and this fact has been taken into consideration. The effect of As contamination in the soil on agricultural produce does not seem to have any apparent relationship. By the way, the influence of the monthly average rainfall on As contamination in the soil is not obvious.     

Automated,continuous, and dynamic speciation of urinary arsenic in the bladder of living organisms using microdialysis sampling coupled on-line with high performance liquid chromatography and hydride generation atomic absorption spectrometry

An on-line and fully automated method was developed for the continuous and dynamic in vivo monitoring of four arsenic species [arsenite (AsIII), arsenate (AsV), monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA)] in urine of living organisms. In this method a microdialysis sampling technique was employed to couple on-line with high performance liquid chromatography (HPLC) and hydride generation atomic absorption spectrometry (HGAAS). Dialysates perfused through implanted microdialysis probes were collected with a sample loop of an on-line injector for direct and automated injection into HPLC system hyphenated with HGAAS. The saline (0.9% NaCl) solution was perfused at the rate of 1 microl min(-1) through the microdialysis probe and the dialysate was loaded into 50 microl of sample loop. The separation conditions were optimally selected to be in phosphate buffer solution at a pH 5.2 with a flow rate of 1.2 ml min(-1). The effluent from the HPLC was first mixed on-line at the exit of the column with HCl (1 M) solution and then mixed with a NaBH4 (0.2% m/v) solution. Based on the optimal conditions obtained, linear ranges of 2.5-50 ng ml(-1) for AsIII and 6.75-100 ng ml(-1) for the other three arsenic species were obtained. Detection limits of 1.00, 2.18, 1.03 and 2.17 ng ml(-1) were obtained for AsIII, DMA, MMA and AsV, respectively. Typical precision values of 3.4% (AsIII), 5.4% (DMA), 3.6% (MMA) and 7.5% (AsV) were obtained, respectively, at a 25 ng ml(-1) level. Recoveries close to 100%, relative to an aqueous standard, were observed for each species. The average in vivo recoveries of AsIII, DMA, MMA and AsV in rat bladder urine were 56+/-5%, 60+/-9%, 49+/-3% and 55+/-7%, respectively. The use of an on-line microdialysis-HPLC-HGAAS system permitted the determination of four urinary arsenic species in the bladder of an anesthetized rat with a temporal resolution of 50 min sampling.     

超细粉Pb0.75Ca0.25[(Ni1/3Nb2/3)0.08Ti0.912Mn0.008]O3的制备与表征

报道了用化学共沉淀法制备掺杂Ca、Ni、Nb、Mn钛酸铅超细陶瓷粉末的方法。制得的粉料化学式为:Pb_0.75Ca_0.25[(Ni_1/3Nb_2/3)_0.08Ti_0.912Mn_0.008]O₃,粒径小于0.1μm,所有的掺杂元素均能定量掺入。