Chiral recognition in NMR spectroscopy using crown ethers and their ytterbium(III) complexes

Chiral crown ethers 1 and 5 are useful enantiomeric discriminating agents in ¹H NMR spectroscopy for neutral and protonated primary amines, amino acids, and amino alcohols. The presence of the carboxylic acid groups in 1 and 5 provide sites at which ytterbium(III) can bind. Adding ytterbium(III) nitrate to crown–substrate mixtures in methanol-d₄ causes shifts in the spectra of substrates and often enhances the chiral discrimination in the ¹H NMR spectrum. The enhancement in enantiomeric discrimination that occurs in the presence of ytterbium(III) allows lower concentrations of the crown ether to be used in chiral recognition studies. Several amide derivatives of 1 were prepared and evaluated as chiral NMR discriminating agents, although except for 1e, these were less effective than 1.     

Preparation and characterization of nanoaggregates of poly(ethylene oxide)-b-polymethacrylate and poly-L-lysine

Poly(ethylene oxide)-b-polymethacrylate (PEO-b-PMA), one of the double-hydrophilic block copolymers, has proved to the form nanoaggregates with poly-L-lysine (PLS). This was confirmed by turbidimetry, zeta-potential measurements, and dynamic light scattering. The nanoaggregate formation is induced by electrostatic charge neutralization of the PMA block with PLS. The properties of the aggregates are affected by PLS concentration as well PEO-b-PMA concentration. The aggregates have potential applications in biomedical science.     

Geochemical studies on the Chernobyl radioactivity in environmental samples

Artificial radionuclides in deposition and airborne dust samples in 1986 were measured at Tsukuba and 11 stations in Japan. In May 1986, the Chernobyl radioactivity was observed in rain and air samples in Japan. The Chernobyl-derived Pu isotopes, which are characterized by higher²³⁸Pu/^239,240Pu (85) and²⁴¹Pu/²³⁸Pu (0.5) activity ratios than those of the nuclear test-derived Pu and⁹⁰Sr, were detected in deposition and airborne dust samples in Japan, as well as volatile radionuclides such as¹³¹I and¹³⁷Cs. However, the activities of Pu isotopes and⁹⁰Sr observed in Japan were about two and three orders of magnitude lower than those expected from the activity ratios in the total release at Chernobyl, which means that the residence time of Pu in the air was shorter than that of¹³⁷Cs. In order to understand the fractionation between the Chernobyl radionuclides we studied about individual wet and dry deposition. The results suggest that this cause is due to the difference of the particle size of radionuclide-bearing particles, which may be related to the release process of Chernobyl radionuclides.     

Depolymerization of poly(2,6-dimethyl-1,4-phenylene oxide) under oxidative conditions

Depolymerization of an engineering plastic, poly(2,6-dimethyl-1,4-phenylene oxide) (PPO), was accomplished by using 2,6-dimethylphenol (DMP) under oxidative conditions. The addition of an excess amount of DMP to a solution of PPO in the presence of a CuCl/pyridine catalyst yielded oligomeric products. When PPO (M(n)=1.0x10(4), M(w)/M(n)=1.2) was allowed to react with a sufficient amount of DMP, the molecular weight of the product decreased to M(n)=4.9x10(2) (M(w)/M(n)=1.5). By a prolonged reaction with the oxidant, the oligomeric product was repolymerized to produce PPO essentially identical to the starting material, making the oligomer useful as a reusable resource. During the depolymerization reaction, an intermediate phenoxyl radical was observed by ESR spectroscopy. Kinetic analysis showed that the rate of the oxidation of PPO was about 10 times higher than that of DMP. These results show that a monomeric phenoxyl radical attacks the polymeric phenoxyl to induce the redistribution via a quinone ketal intermediate, leading to the substantial decrease in the molecular weight of PPO, which is much faster than the chain growth.     

Effect of omega-hydrogenation on the adsorption of fluorononanols at the hexane/water interface: pressure effect on the adsorption of fluorononanols

The interfacial tension gamma of the hexane solution of 1H,1H-perfluorononanol (FDFC(9)OH) and its omega-hydrogenated analogue, 1H,1H,9H-perfluorononanol (HDFC(9)OH), against water was measured as a function of pressure and concentration at 298.15 K in order to clarify the effect of omega-dipole on the orientation of fluorononanol molecules from the viewpoint of volume. The adsorbed films of both alcohols exhibit two kinds of phase transitions among three different states: the gaseous, expanded, and condensed states. The partial molar volume changes of adsorption - in the expanded and condensed states were evaluated and compared between the two systems. The - values of both alcohols are negative, and thus the alcohol molecules have smaller volume in the adsorbed film than in the bulk solution. Furthermore, the value was obtained through the evaluation of by the density measurement of the bulk hexane solution. It was found that the value of HDFC(9)OH is smaller than that of FDFC(9)OH in the condensed state. On the basis of three matters concerning the molecular structure of alcohols, the occupied area at the interface, and the orientation of FDFC(9)OH in the adsorbed film deduced from the earlier results of X-ray reflectivity measurement, the mean tilt angle of HDFC(9)OH from the interface normal in the condensed film was estimated to be 15 degrees . The thermodynamic estimation demonstrated here is highly valuable one to provide structure information on an adsorbed film.     

Kinetics of γ-ray polymerization of formaldehyde in the presence of carbon dioxide

A kinetic study of the γ-ray polymerization of formaldehyde in toluene solution in the presence of carbon dioxide was carried out at temperatures of + 13 to ?17°C. Two modes of the polymerization, spontaneous and γ-ray polymerization, occur in this system. The γ-ray polymerization, experimentally separated from the spontaneous polymerization, was investigated. The rate of γ-ray polymerization increased slightly with the square root of carbon dioxide concentration. The rate of polymerization was also found to be proportional to the dose rate and the square of monomer concentration. The molecular weight of polymer formed was independent of the reaction condition. The apparent activation energy was estimated to be 10.3 kcal./mole. The kinetics of the γ-ray polymerization in the presence of carbon dioxide are explained quantitatively by a cationic mechanism, and the role of carbon dioxide is as an action of retardation for neutralization of the cationic initiating species, which was produced by γ-radiation, by means of a reverse reaction with an electron. Physical and mechanical properties of the polymer obtained by γ-ray polymerization were also investigated.     

(+)-Phorboxazole A synthetic studies. A highly convergent, second generation total synthesis of (+)-phorboxazole A

[structure: see text] A second generation total synthesis of the potent antitumor agent (+)-phorboxazole A (1) has been achieved. The cornerstone of this approach comprises a more convergent strategy, involving late-stage Stille union of a fully elaborated C(1-28) macrocycle with a C(29-46) side chain. The second generation synthesis entails the longest linear sequence of 24 steps, with an overall yield of 4.2%.     

Radical copolymerization of proto-hemin dimethyl ester

Iron(III) proto-porphyrin IX dimethyl ester (HDME) can copolymerize with π-conjugated monomers binding at one end of the polymer chain. Apparent Q, e values of HDME were Q = 70 and e = ?0.17. The copolymerization of HDME with π-unconjugated monomer was feasible by using π-conjugated monomer as a third component. When unconjugated vinylimidazoles were used as monomers, the obtained ternary copolymers of HDME formed intramacromolecular complexes of iron(II) porphyrin with vinylimidazole residues, which gave stable carbon monoxide adducts.     

Cationic polymerization of formaldehyde in liquid carbon dioxide. Part I

A cationic polymerization of formaldehyde which gave a high molecular weight polymer was studied in liquid carbon dioxide at 20–50°C. In the polymerization without any catalyst both the rate of polymerization and the molecular weight of the resulting polymer increased rapidly with a decrease in the loading density of the monomer solution to the reaction vessel, and also increased with an increase in the initial monomer concentration. From these results it was concluded that the initiating species could be ascribed to an impurity contained in the monomer solution. Both the rate of polymerization and the degree of polymerization of the polymer also increased with rising temperature. The carboxylic acid added acted as a catalyst in the polymerization because of increase in the polymer yield, the molecular weight of polymer formed, and the number of moles of polymer chain with increasing dissociation constant of acid used. It was concluded that the polymerization in liquid carbon dioxide proceeded by a cationic mechanism. Methyl formate had no influence on the polymerization, but methanol and water acted as a chain-transfer agent.     

Direct observation of adduct formation of alkyl and aromatic iodides with cl atoms using cavity ring-down spectroscopy

The reactions of Cl atoms with RI (R = n-C3H7, n-C4H9, cyclo-C6H11, C6H5, C6F5, and p-CH3C6H4) have been studied using cavity ring-down spectroscopy at a temperature range of 233-313 K and at 100 Torr total pressure of N2 diluent. Visible absorption spectra of the RI-Cl adducts were recorded at 440-520 nm at 263 K. The yields of the adducts were temperature-dependent. There was no discernible reaction of the adducts in the presence of 100 Torr of O2 at 263 K. Theoretical calculations were performed for C4H9I-Cl and C6H5I-Cl for quantitative explanation of the absorption spectra and the strength of the I-Cl bonds in the charge-transfer complexes. Evidence for the adduct formation following the reaction of Cl with C6H5Br was sought but not found at 440 and 520 nm.