Separation of five oligostilbenes from Vitis amurensis by flow‐rate gradient high‐performance counter‐current chromatography

A rapid and efficient high‐performance counter‐current chromatography (HPCCC) method was developed to separate five oligostilbenes from the roots of Vitis amurensis. An n‐hexane/ethyl acetate/methanol/water system (4:8:4:10, v/v/v/v) was selected as an optimal two‐phase solvent system of which the upper phase was used as the stationary phase and the lower phase was used as the mobile one. Partition coefficient values for the target compounds under these optimized conditions were 0.28 ( 1 , ampleosin A), 7.12 ( 2 , (+)‐g‐viniferin), 2.26 ( 3 , vitisin A), 5.38 ( 4 , wilsonol C), and 11.23 ( 5 , vitisin B). Flow‐rate gradient HPCCC (4 mL/min in 0–70 min, 8 mL/min in 70–250 min) was applied to isolate the target compounds in as high purity as possible within the shortest possible run time. Under these conditions, ampelopsin A (12.1 mg), (+)‐g‐viniferin (10.4 mg), vitisin A (2.8 mg), wilsonol C (3.2 mg), and vitisin B (37 mg) were isolated with >95% purity from 150 mg of enriched oligostilbene extract. Although the K_D of the last eluted compound, vitisin B (K_D = 11.23), was relatively large, it was eluted in 115–145 min using the two‐phase solvent system. This study shows that HPCCC is an efficient tool for the isolation and purification of natural products.     

Effect of TaNx on electrical and optical properties of annealed TaNx/Ag/TaNx films

As‐deposited Ag(10 nm)/glass films exhibited agglomerated nanocrystals with seemingly thick boundaries. Introduction of a TaN_x layer below the Ag films resulted in dense and smooth structures, with a resistance at least three times lower than that of Ag/glass. For TaN_x(10 nm)/Ag(10 nm)/TaN_x(10 nm)/glass multilayer films, Auger electron spectroscopy results indicate that TaN_x acts as an effective barrier restraining the diffusion of Ag. After annealing (up to 573 K), no outward diffusion of Ag through either TaN_x layer was seen. However, partial oxidation of the outermost TaN_x layer to form Ta₂O₅ was observed. The films showed promising optical properties with 73% transmittance in the visible region and ~15% average transmittance in the near‐infrared region. The optical data obtained here was in good agreement with simulated predictions. Copyright © 2013 John Wiley & Sons, Ltd.     

Determination of pesticides in soil by liquid-phase microextraction and gas chromatography-mass spectrometry

Trace amounts of pesticides in soil were determined by liquid-phase microextraction (LPME) coupled to gas chromatography-mass spectrometry (GC-MS). The technique involved the use of a small amount (3 microl) of organic solvent impregnated in a hollow fiber membrane, which was attached to the needle of a conventional GC syringe. The organic solvent was repeatedly discharged into and withdrawn from the porous polypropylene hollow fiber by a syringe pump, with the pesticides being extracted from a 4 ml aqueous soil sample into the organic solvent within the hollow fiber. Aspects of the developed procedure such as organic solvent selection, extraction time, movement pattern of plunger, concentrations of humic acid and salt, and the proportion of organic solvent in the soil sample, were optimized. Limits of detection (LOD) were between 0.05 and 0.1 microg/g with GC-MS analysis under selected-ion monitoring (SIM). Also, this method provided good precision ranging from 6 to 13%; the relative standard deviations were lower than 10% for most target pesticides (at spiked levels of 0.5 microg/g in aqueous soil sample). Finally, the results were compared to those achieved using solid-phase microextraction (SPME). The results demonstrated that LPME was a fast (within 4 min) and accurate method to determine trace amounts of pesticides in soil.     

Solvent-bar microextraction of herbicides combined with non-aqueous field-amplified sample injection capillary electrophoresis

Solvent-bar microextraction (SBME) based on two-phase (water-to-organic) extraction was for the first time used as the sample pretreatment method for the non-aqueous capillary electrophoresis (NACE) of herbicides of environmental concern. Due to the compatibility of the extractant organic solvent and the NACE separation system, the extract could be introduced directly to the CE system after SBME. Through investigations of the effect of sample pH, extraction time, agitation speed and salt addition on extraction efficiency, the most suitable extraction conditions were determined: sample solution at a pH of 1, without added salt, and stirring at 700 revolutions per minute for 30 min. SBME as applied here was also compared with single-drop microextraction and hollow fiber-protected liquid-phase microextraction. SBME showed the highest extraction efficiency. In addition, field-amplified sample injection with pre-introduced organic solvent plug removal using the electroosmotic flow as a pump (FAEP) was used to enhance the sensitivity further in NACE. Based on studies of the effect of different organic solvents, different lengths of the organic plugs and different volumes of sample injection on stacking efficiency under the most suitable separation conditions, methanol was found to be the most efficient solvent for on-line preconcentration. Combined with SBME, FAEP-NACE achieved limits of detection of between 0.08 ng/mL and 0.14 ng/mL for the studied analytes. This preconcentration approach for NACE was demonstrated to be amenable to aqueous environmental samples by applying it to spiked river water.     

Determination of Allosteric Effects and Interstrand Bidentate Interactions in DNA‐Peptide Molecular Recognition

To study DNA allostery, quantitative DNase I footprinting studies were carried out on a newly designed peptide His‐Hyp‐Lys‐Lys‐(Py)₄‐Lys‐Lys‐NH₂ (HypKK‐10) containing the XHypKK (Hyp = hydroxyproline) and polyamide motifs. The interconnection of DNA footprints of peptides HypKK‐10 and the parent peptide PyPro‐12 supports the proposal that interaction network cooperativity is preferred in DNA‐peptide interactions between multiple recognition sites. A simple method of determining interstrand bidentate interactions between the peptide moieties and DNA bases is introduced. It is envisaged that interstrand bidentate interactions also participate in the relay of conformational changes to recognition sites on the complementary strands. Circular dichroism studies of the titration of peptide HypKK‐10 with an oligonucleotide duplex indicate that this peptide binds in a dimeric fashion to DNA in the minor groove. This work may prompt the design of new DNA binding ligands for the study of DNA‐peptide allosteric interactions and DNA interaction network.     

Preparation and application of rifamycin-capped (3-(2-O-β-cyclodextrin)-2-hydroxypropoxy)-propylsilyl-appended silica particles as chiral stationary phase for high-performance liquid chromatography

Rifamycin-capped (3-(2-O-β-cyclodextrin)-2-hydroxypropoxy)-propylsilyl-appended silica particles (RCD-HPS), a new type of substituted β-cyclodextrin-bonded chiral stationary phase (CSP) for high-performance liquid chromatography (HPLC), have been synthesized by the treatment of bromoacetate-substituted-(3-(2-O-β-cyclodextrin)-2-hydroxypropoxy)-propylsilyl-appended silica particles (BACD-HPS) with rifamycin SV in anhydrous acetonitrile. The stationary phase is characterized by means of elemental analysis and Fourier-transform infrared spectroscopy. This new CSP has a chiral selector with two recognition sites: rifamycin and β-cyclodextrin (β-CD). The chromatographic behavior of RCD-HPS was studied with several disubstituted benzenes and some chiral drug compounds under reversed-phase HPLC mobile phase conditions. The results show that RCD-HPS has excellent selectivity for the separation of aromatic positional isomers and enantiomers of chiral compounds due to the cooperative functioning of rifamycin and β-CD.     

Challenges associated with the synthesis of unusual o-carboxamido stilbenes by the Heck protocol: Intriguing substituent effects, their toxicological and chemopreventive implications

The syntheses of fourteen unusual o-carboxamido stilbenes by the Heck protocol revealed surprising complexity related to intriguing substituent effects with mechanistic implications. The unexpected cytotoxic and chemopreventive properties also seem to be substituent dependent. For example, although stilbene 15d (with a 4-methoxy substituent) showed cytotoxicity on HT29 colon cancer cells with an IC(50) of 4.9 μM, the 3,4-dimethoxy derivative (15c) is inactive. It is interesting to observe that the 3,5-dimethoxy derivative (15e) showed remarkable chemopreventive activity in WRL-68 fetal hepatocytes, surpassing the gold standard, resveratrol. The resveratrol concentration needed to be 5 times higher than that of 15e to produce comparable elevation of NQO1.     

Tunable luminescence and energy transfer process between Tb3+ and Eu3+ in GYAG:Bi3+, Tb3+, Eu3+ phosphors

A series of Eu³⁺ ions co-doped (Gd_0.9Y_0.1)₃Al₅O₁₂:Bi³⁺, Tb³⁺ (GYAG) phosphors have been synthesized by means of solvothermal reaction method. The XRD pattern of GYAG phosphor sintered at 1500 °C confirms their garnet phase. The luminescence properties of these phosphors have been explored by analyzing their excitation and emission spectra along with their decay curves. The excitation spectra of the GYAG:Bi³⁺, Tb³⁺, Eu³⁺ phosphors consists of broad bands in the shorter wavelength region due to 4f⁸ → 4f⁷5d¹ transition of Tb³⁺ ions overlapped with 6s² → 6s¹6p¹ (¹S₀ → ³P₁) transition of Bi³⁺ ions and the charge transfer band of Eu³⁺–O^2?. The present phosphors exhibit green and red colors due to ⁵D₄ → ⁷F₅ transition of Tb³⁺ ions and ⁵D₀ → ⁷F₁ transition of Eu³⁺ ions, respectively. The emission was shifted from green to red color by co-doping with Eu³⁺ ions, which indicate that the energy transfer probability from Tb³⁺ to Eu³⁺ ions are dependent strongly on the concentration of Eu³⁺ ions.     

Theoretical Modelling and Facile Synthesis of a Highly Active Boron‐Doped Palladium Catalyst for the Oxygen Reduction Reaction

A highly active alternative to Pt electrocatalysts for the oxygen reduction reaction (ORR), which is the cathode‐electrode reaction of fuel cells, is sought for higher fuel‐cell performance. Our theoretical modelling reveals that B‐doped Pd (Pd‐B) weakens the absorption of ORR intermediates with nearly optimal binding energy by lowering the barrier associated with O₂ dissociation, suggesting Pd‐B should be highly active for ORR. In fact, Pd‐B, facile synthesized by an electroless deposition process, exhibits 2.2 times and 8.8 times higher specific activity and 14 times and 35 times less costly than commercial pure Pd and Pt catalysts, respectively. Another computational result is that the surface core level of Pd is negatively shifted by B doping, as confirmed by XPS, and implies that filling the density of states related to the anti‐bonding of oxygen to Pd surfaces with excess electrons from B doping, weakens the O bonding to Pd and boosts the catalytic activity.     

Synthetic and X-ray structural and reactivity studies of Cp*RuIV complexes containing bidentate dithiocarbonate, xanthate, carbonate, and phosphinate ligands (Cp* = eta5-C5Me5)

The reaction of [Cp*RuCl2]2 (1; Cp* = eta5-C5Me5) with tetraalkyldithiuram disulfides (R2NC(S)SS(S)CNR2, R = Me, Et), isopropylxanthic disulfide ([iPrOC(S)S]2), and bis(thiophosphoryl) disulfide ([(iPrO)2P(S)S]2) led to the isolation of dark-red crystalline solids of Cp*RuIVCl2(eta2-dithiolate) complexes [dithiolate = S2CNR2, DTCR (2a, R = Me; 2b, R = Et), S2COiPr (3), and S2P(iPrO)2 (4)]. Dichlorido substitution in 2 and 3 with DTCEt and S2COiPr anions yielded RuIV derivatives containing bis(DTC) and mixed DTC-dithiocarbonate ligands. These are the first organoruthenium complexes of such ligands. The reaction of monophosphines with 2a resulted in monochlorido substitution, whereas the analogous reaction with 3 resulted in displacement of both chlorido ligands and reduction of the metal center to RuII. Reduction at Ru was also observed in the reaction of 2a with [CpCr(CO)3]2. Of these complexes, only 2 and 3 are air-stable in the solid state for an extended period. All of the complexes have been spectrally characterized, and selected compounds are also crystallographically characterized.