Determination of pesticides in soil by liquid-phase microextraction and gas chromatography-mass spectrometry

Trace amounts of pesticides in soil were determined by liquid-phase microextraction (LPME) coupled to gas chromatography-mass spectrometry (GC-MS). The technique involved the use of a small amount (3 microl) of organic solvent impregnated in a hollow fiber membrane, which was attached to the needle of a conventional GC syringe. The organic solvent was repeatedly discharged into and withdrawn from the porous polypropylene hollow fiber by a syringe pump, with the pesticides being extracted from a 4 ml aqueous soil sample into the organic solvent within the hollow fiber. Aspects of the developed procedure such as organic solvent selection, extraction time, movement pattern of plunger, concentrations of humic acid and salt, and the proportion of organic solvent in the soil sample, were optimized. Limits of detection (LOD) were between 0.05 and 0.1 microg/g with GC-MS analysis under selected-ion monitoring (SIM). Also, this method provided good precision ranging from 6 to 13%; the relative standard deviations were lower than 10% for most target pesticides (at spiked levels of 0.5 microg/g in aqueous soil sample). Finally, the results were compared to those achieved using solid-phase microextraction (SPME). The results demonstrated that LPME was a fast (within 4 min) and accurate method to determine trace amounts of pesticides in soil.     

Liquid-liquid-liquid microextraction of aromatic amines from water samples combined with high-performance liquid chromatography

A simple preconcentration and clean-up liquid-liquid-liquid microextraction of aromatic amines is described in this paper. The compounds were extracted from 2.0 ml aqueous samples (donor phase) into an organic phase, layered on the donor phase, and then back extracted to a microdrop of aqueous receiving phase, suspended in the organic phase. After extraction, the microdrop was injected into the HPLC system directly for analysis. Optimal conditions of the extraction were donor phase (a1): 2 ml of water sample adjusted to pH 13 with NaOH-NaCl; organic phase (o), 150 microl ethyl acetate; and receiving phase (a2) of 2 microl aqueous solution at pH 2.1. The a1-->o extraction time was 15 min and for o-->a2, 30 s. 18-Crown-6 ether, which can complex with amine, was added to the aqueous receiving phase to improve the extraction performance. Enrichment factors ranged from 218 (for 4-nitroaniline) to 378 (for 4-chloro-2-aniline). The calibration curve for these anilines was linear within the range 2.5 ng/ml-2.5 microg/ml (r2=0.998). Detection limits ranged from 0.85 to 1.80 ng/mi (at S/N=3). This procedure can be a selective preconcentration method for aromatic amines present in water samples.     

Swallowtail porphyrins: synthesis, characterization and incorporation into porphyrin dyads

The incorporation of symmetrically branched tridecyl ("swallowtail") substituents at the meso positions of porphyrins results in highly soluble building blocks. Synthetic routes have been investigated to obtain porphyrin building blocks bearing 1-4 swallowtail groups. Porphyrin dyads have been synthesized in which the zinc or free base (Fb) porphyrins are joined by a 4,4'-diphenylethyne linker and bear swallowtail (or n-pentyl) groups at the nonlinking meso positions. The swallowtail-substituted Zn(2)- and ZnFb-dyads are readily soluble in common organic solvents. Static absorption and fluorescence spectra and electrochemical data show that the presence of the swallowtail groups slightly raises the energy level of the filled a(2u)(pi) HOMO. EPR studies of the pi-cation radicals of the swallowtail porphyrins indicate that the torsional angle between the proton on the alkyl carbon and p-orbital on the meso carbon of the porphyrin is different from that of a porphyrin bearing linear pentyl groups. Regardless, the swallowtail substituents do not significantly affect the photophysical properties of the porphyrins or the electronic interactions between the porphyrins in the dyads. In particular, time-resolved spectroscopic studies indicate that facile excited-state energy transfer occurs in the ZnFb dyad, and EPR studies of the monocation radical of the Zn(2)-dyad show that interporphyrin ground-state hole transfer is rapid.     

Sol-gel-coated oligomers as novel stationary phases for solid-phase microextraction

Amphiphilic and hydrophilic oligomers were synthesized and coated on fused silica capillaries using a sol-gel technique. Sol-gel-coated capillaries were evaluated for the solid-phase microextraction and preconcentration of a wide variety of non-polar and polar analytes. Both types of coatings were stable under high temperature (up to 280 degrees C). The extraction efficiency of the sol-gel coatings was evaluated for the extraction of both non-polar and polar analytes, including organochlorine pesticides, triazine herbicides, estrogens and alkylphenols (APs) and bisphenol-A (BPA). Compared with commercially available solid-phase microextraction (SPME) adsorbents such as poly(dimethylsiloxane)divenylbenzene and polyacrylate, the new materials showed comparable selectivity and sensitivity towards both non-polar and polar analytes. The new coatings gave good linearity and detection limits. For example with triazines, a detection limit of <0.005 microl l(-1), precision from 5.0 to 11.0% (n = 6) and linearity of the calibration plots (0.5 to 50 microl l(-1)) were obtained. The sol-gel coated SPME capillaries were used for the determination of triazine herbicides in reservoir water samples collected in Singapore.     

A new synthesis of 1,2,3,5‐tetrahydroimidazo[2,3‐b]‐[1,3]benzodiazocines

A new synthesis of 6‐carbomethoxy‐1,2,3,5‐tetrahydroirnidazo[2,3‐b][1,3]benzodiazocines 13 by the intramolecular cycloaddition reaction of methyl 2‐(1‐aziridinylmethyl)‐3‐(2‐ureidophenyl)propenoates 10 under Appel's dehydration conditions is described. The latter were readily obtained from 2‐nitrobenzalde‐hyde with methyl acrylate through the Baylis‐Hillman reaction.     

Hollow fiber membrane-protected solid-phase microextraction of triazine herbicides in bovine milk and sewage sludge samples

A porous polypropylene hollow fiber membrane (HFM)-protected solid-phase microextraction (HFM-SPME) procedure in conjunction with gas chromatography/mass spectrometric analysis for use in the determination of triazine herbicides in bovine milk samples is described. A 65-microm polydimethylsiloxane-divinylbenzne (PDMS-DVB) SPME fiber was protected by an HFM. HFM-SPME experimental parameters such as fiber type, extraction time, extraction temperature and salt concentration were investigated and optimized. The relative standard deviations for the reproducibility of the optimized HFM-SPME method varied from 4.30 to 12.37%. The correlation coefficients of the calibration curves were between 0.9799 and 0.9965 across a concentration range of 0-200 microg l(-1). The method detection limits for triazines in bovine milk were in the range of 0.003-0.013 microg l(-1) and limits of quantification were in the range of 0.006-0.021 microg l(-1). The suitability of HFM-SPME was extended to the analysis of the herbicides in sewage sludge samples. The results demonstrate that HFM-SPME was an efficient pretreatment and enrichment procedure for complex matrices.     

[CpIrCl2]2-catalysed cyclization of 2-alkynylanilines into indoles

[Cp^∗IrCl₂]₂ catalyses the cyclization of 2-alkynylanilines into indoles. A wide variety of substrates is tolerated. A reaction pathway involving intramolecular hydroamination is proposed.     

An Ultra-Microporous Metal–Organic Framework with Exceptional Xe Capacity

Molecular confinement plays a significant effect on trapped gas and solvent molecules. A fundamental understanding of gas adsorption within the porous confinement provides information necessary to design a material with improved selectivity. In this regard, metal–organic framework (MOF) adsorbents are ideal candidate materials to study confinement effects for weakly interacting gas molecules, such as noble gases. Among the noble gases, xenon (Xe) has practical applications in the medical, automotive and aerospace industries. In this Communication, we report an ultra-microporous nickel-isonicotinate MOF with exceptional Xe uptake and selectivity compared to all benchmark MOF and porous organic cage materials. The selectivity arises because of the near perfect fit of the atomic Xe inside the porous confinement. Notably, at low partial pressure, the Ni–MOF interacts very strongly with Xe compared to the closely related Krypton gas (Kr) and more polarizable CO₂. Further ¹²⁹Xe NMR suggests a broad isotropic chemical shift due to the reduced motion as a result of confinement.     

Electroreduction of oxygen on Pd catalysts supported on Ti-modified carbon

Carbon supports modified with well dispersed anatase TiO₂ (C–Ti-X; X (0.25, 0.5, 0.75, and 1.0) represents mass ratio of Ti precursor to carbon) were synthesized with various Ti loadings and used to support Pd catalysts for oxygen reduction. The anatase nanoparticles increased in size with increasing Ti loading. Pd dispersion improved with increasing Ti loading up to the C–Ti-0.75, which resulted in the best catalytic activity. Although the Pd dispersion was lowest on the C–Ti-1.0, it showed better catalytic performance than the catalysts supported on C–Ti-0.25 and C–Ti-0.5. At 0.8 V (vs. RHE), the best catalytic activity achieved was respectively 2.7 and 2.7 times the mass and specific activities of Pd supported on un-modified carbon. The interaction between Pd and highly dispersed TiO₂ is believed to improve the catalytic activity of Pd supported on TiO₂-modified carbons.     

Separation of five oligostilbenes from Vitis amurensis by flow‐rate gradient high‐performance counter‐current chromatography

A rapid and efficient high‐performance counter‐current chromatography (HPCCC) method was developed to separate five oligostilbenes from the roots of Vitis amurensis. An n‐hexane/ethyl acetate/methanol/water system (4:8:4:10, v/v/v/v) was selected as an optimal two‐phase solvent system of which the upper phase was used as the stationary phase and the lower phase was used as the mobile one. Partition coefficient values for the target compounds under these optimized conditions were 0.28 ( 1 , ampleosin A), 7.12 ( 2 , (+)‐g‐viniferin), 2.26 ( 3 , vitisin A), 5.38 ( 4 , wilsonol C), and 11.23 ( 5 , vitisin B). Flow‐rate gradient HPCCC (4 mL/min in 0–70 min, 8 mL/min in 70–250 min) was applied to isolate the target compounds in as high purity as possible within the shortest possible run time. Under these conditions, ampelopsin A (12.1 mg), (+)‐g‐viniferin (10.4 mg), vitisin A (2.8 mg), wilsonol C (3.2 mg), and vitisin B (37 mg) were isolated with >95% purity from 150 mg of enriched oligostilbene extract. Although the K_D of the last eluted compound, vitisin B (K_D = 11.23), was relatively large, it was eluted in 115–145 min using the two‐phase solvent system. This study shows that HPCCC is an efficient tool for the isolation and purification of natural products.