ESR study of radical sites in crystalline texture of irradiated polypropylene by means of nitric acid etching

Bulk-crystallized isotactic polypropylene samples with different crystalline textures were etched by fuming nitric acid to remove the disordered region. The radicals produced by irradiation of γ-rays or ultraviolet light on these etched samples in vacuum at liquid nitrogen temperature were investigated by the ESR method. A triplet spectrum in addition to the original spectrum of polypropylene radicals was separated for the etched samples. It was concluded that this triplet was caused by radical species associated with nitro groups introduced on the surface of the crystalline residues by etching. The difference in the intensity of this triplet among the samples was ascribed to differences in crystalline textures and interpreted in a quantitative way. The concentration of polypropylene radicals corrected for the triplet differed among the quenched, annealed, and cold-drawn samples and the sample annealed one after drawing. This fact was interpreted on the basis of the hypothesis that radical sites were almost concentrated in the defects of crystal domain. The well known nonet spectrum, which can be observed at liquid nitrogen temperature after annealing the irradiated samples at room temperature, was also confirmed to be attributable to the defects of crystals. The behavior of free methyl radicals induced by ultraviolet irradiation was also found to be strongly dependent on the state of aggregation of the polymer molecules.     

Coating and water permeation properties of SiO2 thin films prepared by the sol-gel method on nylon-6 substrates

Nylon-6 substrates were coated with SiO₂ thin films by the sol-gel method and their water permeability coefficient was evaluated. Methyltriethoxysilane (MTES) and tetraethoxysilane (TEOS) were used as starting materials. The addition of MTES to TEOS has enabled the formation of crack-free thin films on the substrates. The thin films strongly adhered to the substrates. The water permeability coefficients of nylon-6 substrates coated with these thin films decreased with the increase in the ratio of TEOS to the total alkoxides. The pretreatment of the nylon-6 substrates with -aminopropyltriethoxysilane was found to be effective to suppress the water permeability. The water permeability was suppressed by about 40% under the optimal condition.     

Evaluation of the abilities of ��-cyclodextrin to form complexes by surface plasmon resonance with a Biacore? system

Although phase-solubility studies have often been used to evaluate the interaction of cyclodextrins (CDs) with various drugs, hundreds of milligrams of both CD and drug are required to prepare a phase diagram. A method that would require considerably less material for evaluating complex formation between a CD and guest compound is therefore needed. We previously reported the detection of the interactions between ??-CD and various drugs using a Biacore^® system. In this study, we succeeded in immobilizing 6-monodeoxy-6-monoamino-??-CD on the gold surface of a sensor chip and in detecting the interactions between the immobilized ??-CD and various drugs. The interaction processes were kinetically analyzed using Biacore^®. The surface plasmon resonance sensorgrams indicated that the association and dissociation rates of the interactions between ??-CD and drugs were faster than those between ??-CD and drugs. Although the association constants calculated from the sensorgrams were smaller than those calculated from phase-solubility studies, good correlation was shown between these data.     

Synthesis of Star-Shaped Polymers via Coordination of Bipyridyl-Terminated Polyoxyethylene with Metal Ions

Abstract

This paper describes the synthesis of various star-shaped polymers by means of complexation of bipyridyl-terminated polyoxyethylene with Ru(II) ion. Three kinds of bipyridyl-terminated polyoxyethylenes of different molecular weights were prepared from the corresponding polyoxyethylene monomethyl ethers with narrow molecular weight distributions. Bipyridyl was found to be introduced quantitatively at the end of the polymers based on the results of UV spectra. The formation of a star-shaped polymer was carried out by the reaction of RuCl₃ with three equivalents of bipyridyl-terminated polyoxyethylene. The UV spectrum of the star-shaped polymer obtained supported the formation of a typical Ru(II) tris(bipyridyl) complex. From the results of GPC, the star-shaped polymer obtained had a higher molecular weight than the pre-polymer and showed a narrow molecular weight distribution. In the case of a Ni(II) or a Co(II) complex, however, the star-shaped polymer was found to be dissociated into three linear prepolymers under the conditions of GPC measurement.     

Hydroxyapatite-supported copper(II)-catalyzed azide-alkyne [3+2] cycloaddition with neither reducing agents nor bases in water

Copper(II)-exchanged hydroxyapatite, prepared by ion-exchanging of Ca(II) in calcium hydroxyapatite [Ca₁₀(PO₄)₆(OH)₂] with Cu(NO₃)₂ at 70 °C in water, functions as a reusable heterogeneous catalyst with neither reducing agents nor bases for azide-alkyne [3+2] cycloaddition at 50 °C in water under air.     

Electrochemically controllable emission and coloration by using europium(III) complex and viologen derivatives

We have demonstrated electroswitchable emission and coloration using a novel composite material containing luminescent europium(III) complex Eu(hfa)(3)(H(2)O)(2) and diheptyl viologen HV(2+). The photoluminescence of the Eu(III) complex was controlled by the electrochemical coloration of HV(2+)via intermolecular energy transfer mechanisms.     

Enantioselective reductive aldol reaction using tertiary amine as hydride donor

An efficient method was developed for the enantioselective reductive aldol reaction of α,β-unsaturated ketones with aldehydes in the presence of a Lewis base catalyst; conjugate reduction using a tertiary amine and trichlorosilyl triflate, followed by an aldol reaction with BINAP dioxide (BINAPO) as an organocatalyst, gave the corresponding product in high yield with high stereoselectivity.     

Chain Transfer and Efficiency of End‐Group Introduction in Free Radical Polymerization of Methyl Methacrylate in the Presence of Poly(methyl methacrylate) Macromonomer

Summary: Experimental and modeling studies of addition–fragmentation chain transfer (AFCT) during radical polymerization of methyl methacrylate in the presence of poly(methyl methacrylate) macromonomer with 2‐carbomethoxy‐2‐propenyl ω‐ends (PMMA‐CO₂Me) at 60 °C are reported. The results revealed that AFCT involving PMMA‐CO₂Me formed in situ during methyl methacrylate polymerization has a negligible effect on the molecular weight distribution.

     

α‐Chiral Acetylenes Having an All‐Carbon Quaternary Center: Phase Transfer Catalyzed Enantioselective α Alkylation of α‐Alkyl‐α‐alkynyl Esters

Going through the phases : The title reaction was found to proceed by an initial base‐mediated isomerization to allenyl esters and subsequent phase transfer catalyzed alkylation at the α position of the ester (see scheme).