Design of a widely tunable laser with a chirped ladder filter

We theoretically investigated a digitally tunable laser with a chirped ladder filter and a ring resonator to obtain a wide wavelength tuning range covering the whole C- or L- band. The clear relation between the tuning range and laser structure, especially the ladder filter, is described analytically. The introduction of a chirped structure into a ladder filter is effective in achieving both wide tunability and a stable lasing mode. A numerical simulation based on multimode rate equations shows that a tuning range of over 40 nm and a mode suppression ratio over 40 dB can be achieved by introducing a chirped ladder filter.     

Mesomorphic properties of orthopalladated complexes of laterally substituted azobenzene derivatives, 2-alkoxycarbonyl-4-(4-ethoxyphenylazo)phenyl 4-methoxybenzoates

Homologous series of 2-alkoxycarbonyl-4-(4-ethoxyphenylazo)phenyl 4-methoxybenzoates (L) and their orthopalladated μ-chloro dimers (Pd₂Cl₂L₂) have been synthesized and their thermotropic phase transition behaviour has been characterized. The ligands, L, are three-ring nematogens with their central rings substituted in the 2-position by n-alkyl chains of varied length. The thermal stability of the nematic phases decreases rapidly with increasing side chain length and then levels off as the series is ascended. In every case the mesomorphic phase appears only over a small temperature range (less than 20° C). The orthopalladated species also proved to be nematogenic. Melting and clearing points rise on the average by 87° C and 126° C, respectively, and thus the temperature ranges of the nematic phases are enlarged considerably upon metallation. In relation to the observed stabilization of the nematic phases, particularly of higher homologues, a lath-like molecular structure, in which the side chains of the ligands fill up the clefts of the core part, has been deduced for a Pd2Cl2L2 homologue from its solution ¹H-NMR spectrum.     

Uptake and excretion of total inorganic arsenic by the freshwater alga Chlorella vulgaris

Arsenic-tolerant freshwater alga Chlorella vulgaris which had been collected from an arsenicpolluted environment were tested for uptake and excretion of inorganic arsenic. Approximately half the quantity of arsenic taken up by C. vulgaris was estimated to be adhered to the extraneous coat (10 wt %) of the cell. The remainder was bioaccumulated by the cell. Both adhered and accumulated arsenic concentrations increased with an increase in arsenic(V) concentration of the aqueous phase. Arsenic(V) accumulation was affected by the growth phse: arsenic was most actively accumulated when the cell was exposed to arsenic during the early exponential phase and then accumulation decreased with an increase in culture time exposed to arsenic. The alga grew well in the modified Detmer (MD) medium containing 1 mg As(III) dm^?3 and the growth curve was approximated by a ‘logistic equation’. Arsenic(III) was accumulated up to the second day of the culture time and arsenic(III) accumulation decreased with an increase in the culture time after that. Arsenic accumulation was also largely affected by various nutrients, especially by managanese, iron and phosphorus compounds. A modified MD medium with the three nutrients was proposed for the purpose of effective removal of arsenic from the aqueous phase. Using radioactive arsenate (Na₂H⁷⁴AsO₄), the arsenic accumulated was found to be readily excreted under conditions which were unfavourable for the multiplication of C. vulgaris.     

Average heat transfer rates measured and numerically analyzed for combined convection of air in an inclined cylindrical enclosure due to both magnetic and gravitational fields

The average heat transfer rates were measured for natural convection of air in a shallow cylindrical enclosure heated from below and cooled from above in a bore space of an inclined super-conducting magnet. Depending on the location of the enclosure in the bore space, the angle of inclination and the strength of magnetic field, the net acceleration force could be arbitrarily varied and in this report, two locations where mostly axial magnetizing force prevails were selected. The average heat transfer rates varied with the angle of inclination due to the change in the total net acceleration of gravitational and magnetizing forces. Numerical computations were also carried out for the similar system under the combined magnetizing and gravitational forces and the computed average Nusselt numbers agreed mostly with the measured results. Detailed flow modes were graphically presented for the computed cases.     

Development of a Millimeter Wave Compact Equipment for NDT of Materials

We developed a compact equipment working at 94 GHz to replace the commonly used network analyzer for nondestructive testing of materials. The compact equipment was designed to measure the variations in the amplitude and phase of the reflected signal from the material relative to a reference signal. A good accuracy of the amplitude and phase measurement of the equipment was obtained in the confirmative experiments. The distribution of a drop of water in a wood plate is clearly visible in the millimeter wave images obtained by the amplitude and phase measurement.     

Reaction kinetics and pathway of hydrothermal decomposition of aspartic acid

The kinetics and pathway of hydrothermal decomposition of aspartic acid were studied using a continuous‐flow tubular reactor. The reaction was carried out in the temperature range of 200–260°C and at a pressure of 20 MPa. Deamination was the primary reaction, indicated by the presence of significant amount of ammonia, fumaric acid, or maleic acid in the products. Other reaction products were pyruvic acid, malic acid, and traces of succinic and lactic acid. Traces of alanine were also detected, showing the possibility of decomposing high‐molecular weight amino acids to obtain simple amino acids such as glycine or alanine. Results on the effect of reaction parameters demonstrated that decomposition of aspartic acid is highly temperature dependent under hydrothermal conditions. For a slight temperature difference of 60°C (from 200 to 260°C), the first‐order reaction rate constants of 0.003 significantly increased to 0.231 s^?1. The activation energy was 144 kJ/mol, as calculated by the Arrhenius equation. No significant effect was exhibited by other reaction parameters such as pH and pressure. The results are useful in controlling the hydrolysis of proteinaceous materials toward high yield of aspartic acid under hydrothermal conditions. © 2007 Wiley Periodicals, Inc. 39: 175–180, 2007     

Preparation of a cyclodextrin dimer linked with a bis(picolinyl)cystine moiety and its intra- and intermolecular inclusion behavior

A novel cyclodextrin (CD) dimer linked with a bis(picolinyl)cystine (Cys) moiety was prepared by the coupling of Boc-protected Cys with amino-modified CDs, followed by deprotection of the Boc groups and bispicolinylation. The dimer showed less affinity to an organic guest molecule compared to that of a native CD monomer. It was attributed to an intramolecular inclusion of the pyridine moiety into CD cavity. The dimer caused significant increase of its organic guest affinity by an addition of a copper ion. The included pyridine group may come out of a CD cavity to bind the copper ion and the two CDs included cooperatively and intermolecularly a guest molecule with high affinity.     

(Triisopropylsilyl)acetaldehyde acetal as a novel protective group for 1,2-diols

(Triisopropylsilyl)acetaldehyde dimethyl acetal (TIPS-ADMA) was synthesized from chlorotriisopropylsilane in three steps. Cyclic and acyclic 1,2-diols can be transformed to (triisopropylsilyl)ethylidene acetals (TIPS-AA). Removal of the acetal by LiBF₄ regenerates the starting diol in excellent yield even in the presence of an acetonide of 1,2-diol. The TIPS-AA group can survive under the deprotection conditions of the acetonide in acetic acid at 80 °C. Selective protection of 2,3- and 4,6-diols for O-methyl d-mannoside with TIPS-ADMA and selective deprotection of the acetals have been achieved.