First observation of the sigma(*+)(c) baryon and a new measurement of the sigma(*+)(c) mass

Using data recorded with the CLEO II and CLEO II.V detector configurations at the Cornell Electron Storage Rings, we report the first observation and mass measurement of the Sigma(*+)(c) charmed baryon, and an updated measurement of the mass of the Sigma(+)(c) baryon. We find M(Sigma(*+)(c))-M(Lambda(+)(c)) = (231.0+/-1.1+/-2.0) MeV, and M(Sigma(+)(c))-M(Lambda(+)(c)) = (166.4+/-0.2+/-0.3) MeV, where the errors are statistical and systematic, respectively.     

Orientation effect on superfluid <Superscript>3</Superscript>He in anisotropic aerogel

The orientation of the order parameter in the A-like and B-like phases of superfluid ³He immersed in uniaxially compressed aerogel is reported. With the use of NMR methods, it is found that the orbital momentum of the A-and B-like phases is oriented along the deformation. In the A-like phase, a relatively narrow NMR line with an anomalously large negative frequency shift is observed. The Leggett frequency in the A-like phase, which shows the same energy gap suppression as in the B-like phase, is measured. The text was submitted by the authors in English.     

The effect of iron spin transition on electrical conductivity of (Mg,Fe)O magnesiowüstite

We measured the electrical conductivity of Mg_0.81Fe_0.19O magnesiowüstite, one of the important minerals comprising Earth’s lower mantle, at high pressures up to 135 GPa and 300 K in a diamond-anvil cell (DAC). The results demonstrate that the electrical conductivity increases with increasing pressure to about 60 GPa and exhibits anomalous behavior at higher pressures; it conversely decreases to around 80 GPa and again increases very mildly with pressure. These observed changes may be explained by the high-spin to low-spin transition of iron in magnesiowüstite that was previously reported to occur in a similar pressure range. A very small pressure effect on the electrical conductivity above 80 GPa suggests that a dominant conduction mechanism changes by this electronic spin transition. The electrical conductivity below 2000-km depth in the mantle may be much smaller than previously thought, since the spin transition takes place also in (Mg,Fe)SiO₃ perovskite.     

Magnetic and charge transport properties of the Na-based Os oxide pyrochlore

The Na-based osmium oxide pyrochlore was synthesized for the first time by an ion-exchange method using KOs₂O₆ as a host. The composition was identified as Na_1.4Os₂O₆·H₂O by electron probe micro-analysis, thermogravimetric analysis, and structural analysis using synchrotron X-ray diffraction. Na_1.4Os₂O₆·H₂O crystallizes in a regular pyrochlore structure with some defects (space group: Fd-3m, a=10.16851(1) Å). Electrical resistivity, heat capacity, and magnetization measurements clearly showed absence of superconductivity down to 2 K, being in large contrast to what was found for the β-type pyrochlore superconductor AOs₂O₆ (A=Cs, Rb, and K). The Sommerfeld coefficient is 22 mJ K⁻² mol⁻¹, being the smallest among AOs₂O₆. A magnetic anomaly at ∼57 K and associated magneto-resistance (+3.7% at 2 K in 70 kOe) were found.     

A catalytically active molecularly imprinted polymer that mimics peroxidase based on hemin: application to the determination of<Emphasis Type="Italic"> p</Emphasis>-aminophenol

Despite the increasing number of applications of molecularly imprinted polymers (MIP) in analytical chemistry, the synthesis of polymers with hemin introduced as the catalytic center to mimic the active site of peroxidase remains as a challenge. In the current work, a new type of molecularly imprinted polymer (MIP) was synthesized with 4-aminophenol (4-APh) as the template and two monomers: hemin, which acts as the catalytic center, and methacrylic acid (MAA), which is used to build the active sites. This work shows that MIP successfully mimics peroxidase. For this purpose, a flow injection analysis system coupled to an amperometric detector was investigated through multivariate analysis. The determination of 4-APh was not affected by the equimolar presence of structurally similar phenol compounds, including catechol, 4-chloro-3-methylphenol, 2-aminophenol, guaiachol, chloroguaiachol and 2-cresol, thus highlighting the good performance of the imprinted polymer. Under the optimized experimental conditions, an analytical curve covering a wide linear response range from 0.8 up to 500 μmol L⁻¹ (r > 0.999) was obtained, and the method gave satisfactory precisions (n = 8), as evaluated via the relative standard deviation (RSD), of 4.1 and 3.2% for solutions of 4-APh of 50 and 500 μmol L⁻¹, respectively. Recoveries of 96–111% from water samples (tap water and river water) spiked with 4-APh were achieved, thus illustrating the accuracy of the proposed system. Figure Schematic presentation of the synthesis of the MIP     

Ability of poly(vinyl alcohol) fibers to initiate graft copolymerization

It was noted in a graft copolymerization reaction involving a system of poly(vinyl alcohol) fibers (PVA fibers), methyl methacrylate, and water that fibers oxidized with hydrogen peroxide or sodium hypochlorite or ferric ion-adsorbing fibers effectively initiate the reaction as in the case of cellulose fibers. The initiation reaction of the sample was markedly activated by the presence of a pretreatment with an oxidizing agent at a concentration on the order of 10^?9 mole/l., but the oxidized samples were sharply deactivated by such means as reduction and oximation. Since model initiators for the present system, such as iron(III) acetylacetonate-adsorbing PVA fibers or ferric ion-adsorbing fibres, with the co-existence of acetylacetone were observed to initiate graft copolymerization effectively, it is believed that carbonyl groups in modified PVA fibers could be a major factor for initiating copolymerization through interaction with metallic ions.     

Biosensor for phenol based on the direct electron transfer blocking of peroxidase immobilising on silica–titanium

Horseradish peroxidase (HRP) was immobilised on silica gel modified with titanium oxide. This material was employed to prepare modified carbon paste electrode. The direct electron transfer of the hydrogen peroxide reduction by HRP was blocked when immobilised on silica–titanium. This biosensor presented a very sensitive response for phenol (1 μmol l⁻¹) at an applied potential of 0 mV vs SCE. The best condition was achieved in phosphate buffer pH 6.8, ratio of hydrogen peroxide/phenol higher than 0.35. The biosensor showed a linear response range between 10 and 50 μmol l⁻¹ of phenol, adjusted by the equation j=−32.8+16.3 [phenol], for n=5 with a correlation coefficient of 0.9995. The response time of the biosensor was about 3 s.     

Effects of carbonyl and aldehyde groups in the graft copolymerization of methyl methacrylate on cellulose with a ceric salt

Graft copolymerization of methyl methacrylate on cellulosic materials of various carbonyl and aldehyde contents with the use of a ceric salt as an initiator was studied. It was found that the concentration of the ceric salt which gives the maximum per cent grafting is in good agreement with the equivalent of total carbonyl content in the cellulosic material, and the number of grafted chains in copolymers is roughly proportional to it. However, the molar ratio of the number of grafted chains to total carbonyl content is quite small, being approximately 1:50, and the graft copolymerization can be explained kinetically on the assumption that the number of radicals produced on cellulose by the ceric salt leading to branching is very much smaller than the number of radicals destroyed by the ceric salt, and growing radicals can be stabilized by the termination reaction with the ceric salt or with a cellulose radical. Although both aldehyde and carbonyl groups contribute to the formation of grafted chains, the former are effective mainly at low concentrations of the ceric salt; both groups participate in the production of graft copolymers showing the maximum per cent grafting.