Optimization of separation in two-dimensional high-performance liquid chromatography by adjusting phase system selectivity and using programmed elution techniques

The overall peak capacity in comprehensive two-dimensional liquid chromatographic (LC x LC) separation can be considerably increased using efficient columns and carefully optimized mobile phases providing large differences in the retention mechanisms and separation selectivity between the first and the second dimension. Gradient-elution operation and fraction-transfer modulation by matching the retention and the elution strength of the mobile phases in the two dimensions are useful means to suppress the band broadening in the second dimension and to increase the number of sample compounds separated in LC x LC. Matching parallel gradients in the first and second dimension eliminate the necessity of second-dimension column re-equilibration after the independent gradient runs for each fraction, increase the use of the available second-dimension separation time and can significantly improve the regularity of the coverage of the available retention space in LC x LC separations, especially with the first- and second-dimension systems showing partial selectivity correlations. Systematic development of an LC x LC method with parallel two-dimensional gradients was applied for separation of phenolic acids and flavone compounds. Several types of bonded C18, amide, phenyl, pentafluorophenyl and poly(ethylene glycol) columns were compared using the linear free energy relationship method to find suitable column combination with low correlation of retention of representative standards. The phase systems were optimized step-by-step to find the mobile phases and gradients providing best separation selectivity for phenolic compounds. The optimization of simultaneous parallel gradients in the first and second dimension resulted in significant improvement in the utilization of the available two-dimensional retention space.     

Large volume injection techniques in capillary gas chromatography

Large volume injection (LVI) is a prerequisite of modern gas chromatographic (GC) analysis, especially when trace sample components have to be determined at very low concentration levels. Injection of larger than usual sample volumes increases sensitivity and/or reduces (or even eliminates) the need for extract concentration steps. Also, an LVI technique can serve as an interface for on-line connection of GC with a sample preparation step or with liquid chromatography. This article reviews the currently available LVI techniques, including basic approaches to their optimization and important real-world applications. The most common LVI methods are on-column and programmed temperature vaporization (PTV) in solvent split mode. Newer techniques discussed in this article include direct sample introduction (DSI), splitless overflow, at-column, and "through oven transfer adsorption desorption" (TOTAD).     

Benzene elimination from reformate gasoline by high pressure hydrogenation in a fixed-bed reactor

The reduction of benzene from benzene-rich real gasoline fractions has been studied in a high-pressure fixed-bed reactor using a Pt/TiO₂ catalyst. It was found that the yield of this process decreases with the toluene content in the feedstock, but it is independent of the kind of the saturated hydrocarbons. This revised version was published online in August 2006 with corrections to the Cover Date.     

Chromatographic methods for the separation of biocompatible iron chelators from their synthetic precursors and iron chelates

Chromatographic methods have been developed for the separation of the three novel biocompatible iron chelators pyridoxal isonicotinoyl hydrazone (PIH), salicylaldehyde isonicotinoyl hydrazone (SIH), and pyridoxal 2-chlorobenzoyl hydrazone (o-108) from their synthetic precursors and iron chelates. The chromatographic analyses were achieved using analytical columns packed with 5 microm Nucleosil 120-5 C18. For the evaluation of all chelators in the presence of the synthetic precursors, EDTA was added to the mobile phase at a concentration of 2 mM. The best separation of PIH and its synthetic precursors was achieved using a mixture of phosphate buffer (0.01 M NaH2PO4, 5 mM 1-heptanesulfonic acid sodium salt; pH 3.0) and methanol (55:45, v/v). For separation of SIH and its synthetic precursors, the mobile phase was composed of 0.01 M phosphate buffer (pH 6.0) and methanol (60:40, v/v). o-108 was analyzed employing a mixture of 0.01 M phosphate buffer (pH 7.0), methanol, and acetonitrile (60:20:20, v/v/v). These mobile phases were slightly modified to separate each chelator from its iron chelate. Furthermore, a RP-TLC method has also been developed for fast separation of all compounds. The chromatographic methods described herein could be applied in the evaluation of purity and stability of these drug candidates.     

Evaluation of the QuEChERS sample preparation approach for the analysis of pesticide residues in olives

This paper describes the use of a quick, easy, cheap, effective, rugged, and safe (QuEChERS) method for extraction and cleanup of 16 pesticide residues of interest in olives and olive oil. These products contain a high lipid content, which can adversely affect pesticide recoveries and harm traditional chromatographic systems. For extraction, the main factors (oil and water content) were studied and optimized in experiments to maximize pesticide recoveries. Dispersive SPE with different sorbents was also investigated to minimize matrix coextractives and interferences. For analysis, a new automated DSI device was tested in GC-MS to avoid nonvolatile coextractives from contaminating the instrument. LC-MS/MS with positive ESI was used for those pesticides that were difficult to detect by GC-MS. The final method was validated for olives in terms of recoveries, repeatabilities, and reproducibilities using both detection techniques. The results demonstrated that the method achieved acceptable quantitative recoveries of 70-109% with RSDs < 20% for DSI-GC-MS and 88-130% with RSDs < 10% for LC-MS/MS, and LOQ at or below the regulatory maximum residue limits for the pesticides were achieved.     

Headspace solid-phase microextraction of phthalic acid esters from vegetable oil employing solvent based matrix modification

A new solvent-free analytical procedure based on headspace solid-phase microextraction (SPME) coupled to gas chromatography employing an electron capture detector (GC/ECD) or alternatively a mass spectrometric detector (GC/MSD) has been developed for the determination of phthalic acid esters (dimethyl-[DMP], diethyl-[DEP], di-n-butyl-[DnBP], butylbenzyl-[BBP], di-2-ethylhexyl-[DEHP] and di-n-octyl [DnOP] phthalate) in vegetable oils. Four different fiber coatings were evaluated, among them polydimethylsiloxane with a thickness of 100 μm appeared to be the best choice for allowing extraction of the whole group of analytes. Various solvents were tested as sample matrix modification agents with the aim to facilitate the transfer of esters with low vapour pressure (DEHP and DnOP) from oil matrix into the headspace. The addition of methanol resulted in optimal set-up applicable for all phthalate esters. Temperature control and the way of sample stirring were recognized as critical points of the whole procedure. Primarily, because shaking rather than stirring of the sample is carried out using a CombiPal multipurpose sampler, the automation of the SPME method employing this instrument was found to be not fully suitable for efficient stripping of phthalates from the oil matrix into the sample headspace. Nevertheless, the optimized manual SPME method, encompassing GC/ECD or GC/MSD for the separation and detection of target analytes, offers a unique solution and showed acceptable performance characteristics: linear response in the range of 0.5-2 mg kg⁻¹ and repeatability expressed as R.S.D. between 14 and 23% at the spiking level of 2 mg kg⁻¹.     

Chromatographic enantioseparation of amino acids using a new chiral stationary phase based on a macrocyclic glycopeptide antibiotic

The separation of the enantiomers of several a-amino acids was studied on a new chiral stationary phase (CSP) which is based on the macrocyclic glycopeptide antibiotic eremomycin attached to silica particles. Retention and separation factors were determined under analytical conditions at ambient temperature for different mobile phase compositions. In order to evaluate the potential with respect to preparative separations the adsorption isotherms of D- and L-methionine were determined for one mobile phase composition applying the elution by characteristic point method. The isotherms were validated by comparing experimentally determined elution profiles with predictions based on the equilibrium dispersive model. Finally, the performance of the eremomycin CSP was compared with a commercially available CSP based on the macrocyclic antibiotic teicoplanin. After determining the isotherms of D- and L-methionine also for the teicoplanin phase, the equilibrium dispersive model was used for both CSP to identify optimal operating conditions. For the separation and conditions considered the new eremomycin CSP revealed a better performance compared to the teicoplanin CSP.     

Solvent and temperature gradients in separation of synthetic oxyethylene-oxypropylene block (co)polymers using high-temperature liquid chromatography

Chromatographic behavior of synthetic block (co)oligomer samples (EO)n(PO)m(EO)n and (PO)n(EO)m(PO)n with different distribution of propylene oxide (PO) and ethylene oxide (EO) monomer units was investigated on three types of stationary phases on zirconium dioxide support: Zr-PS (polystyrene), Zr-carbon, and Zr-carbon C18. The effects of the distribution and sequence of the oxyethylene and oxypropylene monomer units on the chromatographic retention depend on the type of the stationary phase, but are strongly affected by the organic modifier (methanol or ACN) in aqueous-organic mobile phase. Special attention was focused on the influence of the mobile-phase composition on the separation according to the EO and PO distribution. Zirconia-based columns are stable at elevated temperatures and can be used in high-temperature LC (HTLC); hence, we investigated the temperature effects on the chromatographic behavior up to 90 degrees C. The applications of solvent and temperature gradients were compared on the zirconia stationary phases in the RP mode.     

Two-dimensional capillary liquid chromatography: pH gradient ion exchange and reversed phase chromatography for rapid separation of proteins

In the present work, an orthogonal two-dimensional (2D) capillary liquid chromatography (LC) method for fractionation and separation of proteins using wide range pH gradient ion exchange chromatography (IEC) in the first dimension and reversed phase (RP) in the second dimension, is demonstrated. In the first dimension a strong anion exchange (SAX) column subjected to a wide range (10.5-3.5) descending pH gradient was employed, while in the second dimension, a large pore (4,000 A) polystyrene-divinylbenzene (PS-DVB) RP analytical column was used for separation of the protein pH-fractions from the first dimension. The separation power of the off-line 2D method was demonstrated by fractionation and separation of human plasma proteins. Seventeen pH-fractions were manually collected and immediately separated in the second dimension using a column switching capillary RP-LC system. Totally, more than 200 protein peaks were observed in the RP chromatograms of the pH-fractions. On-line 2D analysis was performed for fractionation and separation of ten standard proteins. Two pH-fractions (basic and acidic) from the first dimension were trapped on PS-DVB RP trap columns prior to back-flushed elution onto the analytical RP column for fast separation of the proteins with UV/MS detection.     

Stability constants of amino acids, peptides, proteins, and other biomolecules determined by CE and related methods: recapitulation of published data

The stability (affinity, association, binding, complexation, formation) constant characterizes binding interaction between the analyte and the complexing agent. Knowledge of the stability constant makes possible the prediction and estimation of the binding behavior of constituents (amino acids, peptides, proteins, drugs, antibiotics, enzymes, enantiomers) to their partners, and the finding of a suitable partner for the given analyte to form a stable complex. The present paper summarizes the stability constant determination methods and the approaches used to evaluate the experimental data. Further, the paper recapitulates the published stability constant values determined, mainly, by capillary electrophoretic methods, taken from the Web of Science database covering the last decade. Details of the experimental conditions employed for the determination of the stability constants are also given. The review attempts to give a critical evaluation of the problems that accompany the determination of stability constant and discusses their solution.