Primary and secondary relaxations in bis-5-hydroxypentylphthalate revisited

The molecular structure of bis-5-hydroxypentylphthalate (BHPP) is like dihexyl phthalate but having appended to it two hydroxyl end groups, which contribute additional dipole moments and capacity for hydrogen-bond formation. In a previously published dielectric study of the primary and secondary relaxations of BHPP, it was found that all the dynamic properties are normal except for the anomalously large width of the primary relaxation loss peak. There are two secondary relaxations, the relaxation time of the slower one increases with increasing pressure, whereas that of the faster one is practically insensitive to pressure. Hence, the slower secondary relaxation is the "universal" Johari-Goldstein (JG) [J. Chem. Phys. 53, 2372 (1970); 55, 4245 (1971)] relaxation in BHPP. All is well except if the observed large width of the primary relaxation were an indication of a corresponding large coupling parameter n=0.45 in the coupling model. Then the predicted relations between the primary relaxation time tau(alpha) and the JG relaxation time tau(JG) found previously to hold in many glass formers would be violated. It was recognized that this singular behavior of BHPP is likely due to broadening of the primary loss peak by the overlapping contributions of two independent dipole moments present in BHPP, and the actual coupling parameter is smaller. However, at the time of publication of the previous work there were not enough data to support this explanation. By making broadband dielectric measurements of dibutyl phthalate (DBP) and dioctyl phthalate (DOP) that have chemical structures closely related to BHPP but with only one dipole moment, we show that all their dynamic properties are almost the same as BHPP but the widths of their primary relaxation loss peaks are significantly narrower corresponding to a smaller coupling parameter n=0.34. The new data presented here indicate that the coupling parameter of BHPP is about the same as DBP and DOP, and the predicted relations between tau(alpha) and tau(JG) of BHPP are brought back in agreement with the experimental data.     

Apparent molar volumes,heat capacities,and molecular excluded volumes of methylated,hydroxy and methoxy derivatives of 1-methylcytosine in aqueous solutions at 25°C

Densities and specific heat capacities of aqueous solutions: 1-methylcytosine; 1-methyl-N⁴-hydroxycytosine; 1,5-dimethylcytosine; I,N⁴-dimethylcytosine; 1,5-dimethyl-N⁴-hydroxycytosine; 1-methyl-N⁴-methoxycytosine; 1,N⁴,N⁴-trimethylcytosine, 1,5-dimethyl-N⁴-methoxycytosine were determined using flow calorimetry and flow densimetry at 25°C. Apparent molar volumes and heat capacities were then determined. Molecular excluded volumes were evaluated. A relationship was found between the values of the increments in partial molar values and the kind of groups substituted. Four types of contributions were distinguished: substitution of hydrogen on C, N, and O (in OH group on N4) atoms by CH₃ group and replacement of hydrogen on N4 atom by OH group. The correlation between the experimental partial molar volumes and calculated molecular excluded volumes was also elaborated.     

Electrospray mass spectrometry and tandem mass spectrometry of the natural mixture of cyclic peptides from linseed

The cyclic peptides from linseed are composed exclusively of the hydrophobic amino acids: Phe, Leu, Ile, Val, Met, Pro, and Trp. Because these compounds does not contain functional groups which undergo easily protonation or deprotonation. their ionization in solvents used usually for peptide analysis is not efficient. A rapid and sensitive procedure for detection and structure elucidation of the cyclic peptides based on ionization with Na+ and NH4+ ions. A cationisation of methionine containing peptides with methyl iodide has been also described. The extract of seeds of Linum utitatissimum was analyzed directly by ESI-MS and neutral loss ESI-MS/MS technique. The analysis confirms the presence of cyclolinopeptides reported previously: CLA (c(Pro-Pro-Phe-Phe-Leu-Ile-Ile-Leu-Val), and CLB (c(Pro-Pro-Phe-Phe-Val-Ile-Met-Ile-Leu)). Cyclolinopeptides CLC, CLD, CLE, and CLG, which contain methionine oxide, were detected in relatively small quantities. These peptides results likely from the oxidation of their not reported precursors: CLD' (c (Pro- Phe-Phe-Trp-Ile-Met-Leu-Leu)), CLE'(c (Pro-Leu-Phe-Ile-Met-Leu-Val-Phe)), CLF (c (Pro-Phe-Phe-Trp- Val-Met-Leu-Met), and CLG (c (Pro-Phe-Phe-Trp-Ile-Met-Leu-Met), present at higher concentrations in the extract protected from atmospheric oxygen. The sequences of the unreported cyclic peptides were proposed on the basis of CID experiments and homology with peptides described by Morita,1,2 and supported by the fragmentation of synthetic analogues of CLA of a known structure.     

Kinetics of self-condensation of acetone over heterogeneous Ba(OH)2 and Sr(OH)2 catalysts

Catalytic performance of Ba(OH)₂ and Sr(OH)₂ in self-condensation of acetone was examined in the temperature range from 273 to 303 K. A kinetic model of second order with respect to acetone was used for interpretation of the results obtained for the diacetone alcohol formation.This revised version was published online in December 2005 with corrections to the Cover Date.     

Rheological properties of multisticker associative polyelectrolytes in semidilute aqueous solutions

Multisticker associative polyelectrolytes of acrylamide (≈86 mol %) and sodium 2‐acrylamido‐2‐methylpropanesulfonate (≈12 mol %), hydrophobically modified with N,N‐dihexylacrylamide groups (≈2 mol %), were prepared with a micellar radical polymerization technique. This process led to multiblock polymers in which the length of the hydrophobic blocks could be controlled through variations in the surfactant‐to‐hydrophobe molar ratio, that is, the number of hydrophobes per micelle (N_H). The rheological behavior of aqueous solutions of polymers with the same molecular weight and the same composition but with two different hydrophobic block lengths (N_H = 7 or 3 monomer units per block) was investigated as a function of the polymer concentration with steady‐flow, creep, and oscillatory experiments. The critical concentration at the onset of the viscosity enhancement decreased as the length of the hydrophobic segments in the polymers increased. Also, an increase in the N_H value significantly enhanced the thickening ability of the polymers and affected the structure of the transient network. In the semidilute unentangled regime, the behavior of the polymer with long hydrophobic segments (N_H = 7) was studied in detail. The results were well explained by the sticky Rouse theory of associative polymer dynamics. Finally, the viscosity decreased with an increase in the temperature, mainly because of a lowering of the sample relaxation time. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1640–1655, 2004     

Optimized conditions for hydrocarbon group type analysis of base oils by thin-layer chromatography-flame ionisation detection

The results of research on the optimization of the thin-layer chromatography-flame ionisation detection for the determination of group composition of natural base oils, including separation of the aromatics into subgroups, are presented. Neutral base oils obtained in several steps of refining from vacuum distillation petroleum fractions are the most difficult to analyze by hydrocarbon group type analysis (HGTA) because of the high content of aliphatic fragments in their molecules. Factors affecting the accuracy and precision of the results were identified. The paper presents the analytical procedure, including two different calibration methods, as well as the results of studies on the reproducibility of HGTA of typical base oils of different viscosity classes under the optimized conditions. The same conditions were found suitable for HGTA of other high-boiling petroleum fractions by TLC with flame ionisation detection. The paper also introduces a new procedure for reproducible determination of polar fractions in base oils utilizing solid-phase extraction columns, and presents a corrected procedure for the determination of saturated compounds and aromatics (mono-, bi- and polycyclic) in base oils by column liquid chromatography.     

Facts and artifacts about aromatic stability estimation

The stability of a set of 105 five-membered π-electron systems (involving aromatic, non-aromatic and anti-aromatic species) was evaluated using six isodesmic reactions of which two belong to the subclass of homodesmotic reactions, which are based on cyclic and acyclic reference systems. We demonstrate that the ‘Resonance Energies’ derived from isodesmotic schemes have obvious flaws and do not correct or cancel other contributions to the energy, such as the changes of hybridization, homoconjugation of heterosubstituted cyclopentadienes, conjugative interactions of CC or CX (X=N or P) with a π or pseudo π orbital at Y (Y=O, S, NH, PH), strain, etc. as effectively as possible. Likewise, ‘aromatic stabilization energies (ASE)’ derived from homodesmotic schemes based on the acyclic reference compounds do not give satisfactory results. We strongly recommend that only cyclic reference compounds should be used for ASE and other aromaticity evaluations. The analysis is based on ab initio optimized geometries at B3LYP/6-311+G^∗∗.     

Improvement of the Derjaguin-Broekhoff-de Boer theory for the capillary condensation/evaporation of nitrogen in spherical cavities and its application for the pore size analysis of silicas with ordered cagelike mesopores

In a previous work, we proposed an improvement of the Derjaguin-Broekhoff-de Boer (DBdB) theory for capillary condensation/evaporation in open-ended cylindrical mesopores. In this paper, we report a further extension of this approach to the capillary condensation/evaporation of nitrogen in siliceous spherical cavities. The main idea of this improvement is to employ the Gibbs-Tolman-Koenig-Buff equation to predict the variation of the surface tension in spherical mesopores. In addition, the statistical film thickness (the so-called t-curve), which is evaluated accurately on the basis of adsorption isotherms measured for MCM-41 materials, is used instead of the originally proposed t-curve to take into account the excess chemical potential due to the surface forces. It is shown that the aforementioned modifications of the original DBdB theory that was refined by Ravikovitch and Neimark have significant implications for the pore size analysis of cagelike mesoporous silicas. To verify the proposed improvement of the DBdB pore size analysis (IDBdB), two series of FDU-1 samples, which are well-defined cagelike mesoporous materials (composed of siliceous spherical cavities interconnected by short necks), were used for the evaluation of the pore size distributions (PSDs). The correlation between the spinodal condensation point in the spherical pores predicted by the nonlocal density functional theory (NDFT) developed by Ravikovitch and Neimark and that predicted by the IDBdB theory is very good in the whole range of mesopores. This feature is mirrored to the realistic PSD characterized by the bimodal structure of pores computed from the IDBdB theory. As in the case of open-ended cylindrical pores, the improvement of the classical DBdB theory preserves its simplicity and simultaneously ensures a significant improvement of the pore size analysis, which is confirmed by the independent estimation of the average pore size by the NDFT and the powder X-ray diffraction method.     

Formal Mathematical Analysis of the Existence of the Common Intersection Point in Relation to Determining the Parameters Describing Ion Adsorption at the Oxide/Electrolyte Interface: Comparison of the Triple and Four-Layer Models

For most oxide/electrolyte systems potentiometric titration curves measured for different ionic strengths have a Common Intersection Point (CIP) which corresponds to the Point of Zero Charge (PZC). However, there are systems where a CIP exists but the surface charge at this point does not equal zero (PZC CIP). In this paper theoretical analysis of the systems in which the PZC and CIP do not coincide is presented. It is based on the well-known 2-pK surface charging approach and Triple Layer Model (TLM) as well as the Four Layer Model (FLM) of the electric double layer. The appropriate mathematical criterion for CIP existence was applied with detailed derivations, both for TLM and FLM. Having determined in this manner the parameter values, one can draw proper conclusions about the features of oxide/electrolyte adsorption systems, in which PZC and CIP do not coincide. The values of adsorption parameters are found by fitting simultaneously the obtained theoretical expressions to both of the experimental titration isotherms, and to the individual isotherms of electrolyte cation adsorption measured using radiometric methods.     

Carrier influence on the paramagnetic and catalytic properties of supported titanium complexes

Alumina-silica possessing various Al₂O₃/SiO₂ ratios was used as a carrier of surface titanium complexes. The systems obtained were examined as models for the investigation of the macroligand (inorganic gel) influence on the physicochemical properties of supported transition metal complexes. The titanium complexes were prepared first by the reaction of CpTiCl₃, with the hydroxyl groups of the gel and then reduced by an excess of BuLi. The influence was established of the basic gel properties on: (a) the amount of titanium(IV) and titanium(III) complexes on the alumina-silica gel surfaces; (b) the symmetry of the surface Ti^III surface complexes; (c) the electron density around the surface-Ti^III ions, ionic or covalent bonds character in a complex; and (d) the catalytic activity in olefin hydrogenation.