In Vitro and In Silico Screening and Characterization of Antimicrobial Napin Bioactive Protein in Brassica juncea and Moringa oleifera

The study aimed to investigate the antibacterial activity of Mustard (Brassica juncea) and Moringa (Moringa oleifera) leaf extracts and coagulant protein for their potential application in water treatment. Bacterial cell aggregation and growth kinetics studies were employed for thirteen bacterial strains with different concentrations of leaf extracts and coagulant protein. Moringa oleifera leaf extract (MOS) and coagulant protein showed cell aggregation against ten bacterial strains, whereas leaf extract alone showed growth inhibition of five bacterial strains for up to 6 h and five bacterial strains for up to 3 h. Brassica juncea leaf extract (BJS) showed growth inhibition for up to 6 h, and three bacterial strains showed inhibition for up to 3 h. The highest inhibition concentration with 2.5 mg/mL was 19 mm, and furthermore, the minimum inhibitory concentration (MIC) (0.5 mg/mL) and MBC (1.5 mg/mL) were determined to have a higher antibacterial effect for <3 KDa peptides. Based on LCMS analysis, napin was identified in both MOS and BJS; furthermore, the mode of action of napin peptide was determined on lipoprotein X complex (LpxC) and four-chained structured binding protein of bacterial type II topoisomerase (4PLB). The docking analysis has exhibited moderate to potent inhibition with a range of dock score −912.9 Kcal/mol. Thus, it possesses antibacterial-coagulant potential bioactive peptides present in the Moringa oleifera purified protein (MOP) and Brassica juncea purified protein (BJP) that could act as an effective antimicrobial agent to replace currently available antibiotics. The result implies that MOP and Brassica juncea purified coagulant (BJP) proteins may perform a wide degree of antibacterial functions against different pathogens.     

Changes in the physical properties of low bandgap polymer after interaction with ionic liquids

Over the past few years, polymers shown comprehensive utilization in optical devices, solar cells, sensors, and other such devices. However, the efficiency of these devices remains a problem. We have synthesized new thiophene based, lowband gap polymer, poly(2-heptadecyl-4-vinylthieno[3,4-d] [1,3] selenazole) (PHVTS) and investigated the interactions between the PHVTS and ionic liquids (ILs), in this study. We have used imidazolium- and ammonium-family ILs, and studied the interactions using various spectroscopic techniques such UV–visible, FTIR, and confocal Raman spectroscopies. Additionally, we studied surface morphology of the polymer-IL film. Spectroscopic studies show that both families of ILs can interact with the newly synthesized polymer poly(2-heptadecyl-4-vinylthieno[3,4-d] [1,3] selenazole). However, the imidazolium-family Ionic Liquid-polymer (IL-polymer) mixture films show higher conductivities than ammonium-family IL–polymer mixture films.     

Observation of competing order in a high-Tc superconductor using femtosecond optical pulses

We present studies of the photoexcited quasiparticle dynamics in Tl(2)Ba(2)Ca(2)Cu(3)O(y) (Tl-2223) using femtosecond optical techniques. Deep into the superconducting state (below 40 K), a dramatic change occurs in the temporal dynamics associated with photoexcited quasiparticles rejoining the condensate. This is suggestive of entry into a coexistence phase which, as our analysis reveals, opens a gap in the density of states (in addition to the superconducting gap), and furthermore, competes with superconductivity resulting in a depression of the superconducting gap.     

Fabrication of a solution-processed thin-film transistor using zinc oxide nanoparticles and zinc acetate

We have fabricated a solution-processed ZnO thin-film transistor without vacuum deposition. ZnO nanoparticles were prepared by the polyol method from zinc acetate, polyvinyl pyrrolidone, and diethyleneglycol. The solution-processable semiconductor ink was prepared by dispersing the synthesized ZnO in a solvent. Inverted stagger type thin-film transistors were fabricated by spin casting the ZnO ink on the heavily doped Si wafer with 200 nm thick SiO₂, followed by evaporation of Cr/Au source and drain electrodes. After the drying and heat treatment at 600 C, a relatively dense ZnO film was obtained. The film characteristics were investigated by scanning electron microscopy (SEM) and X-ray diffraction (XRD). In order to obtain the electrical properties of the solution-derived transistor, the on–off ratio, threshold voltage, and mobility were measured.     

Medical radioisotope 89Zr production with RFT-30 cyclotron

Journal of Radioanalytical and Nuclear Chemistry - 89Zr is an emerging radionuclide with promising application in nuclear medicine for the non-invasive diagnosis of various cancers with PET...     

Positron annihilation lifetime spectroscopy of advanced reduced-activation alloy (ARAA) in cold‐worked conditions

Journal of Radioanalytical and Nuclear Chemistry - The defects due to cold-rolling deformation in the advanced reduced-activation alloy (ARAA) have been analyzed using positron annihilation...     

Mechanical properties and degradation studies of poly(D,L‐lactide‐co‐glycolide) 50:50/graphene oxide nanocomposite films

Poly(D,L‐lactide‐co‐glycolide) 50:50 (PLGA)/graphene oxide (GO) nanocomposite films were prepared with various GO weight fractions. A significant enhancement of mechanical properties of the PLGA/GO nanocomposite films was obtained with GO weight fractions. The incorporation of only 5 wt% of GO resulted in an ~2.5‐fold and ~4.7‐fold increase in the tensile strength and Young's modulus of PLGA, respectively. The thermomechanical behaviors of composite films were investigated by dynamic mechanical analysis. Results indicated that the values of T_g and storage moduli of the PLGA/GO composites were higher than those of the pristine PLGA. The improvement in oxygen barrier properties of composites was presumably attributed to the filler effect of the randomly dispersed GO throughout the PLGA matrix. In this work, we also studied in vitro biodegradation behavior. PLGA/GO composite films were hydrolyzed at 37°C for periods up to 49 days. Because of the presence of GO nanosheets, degradation of composite films took place more slowly with increasing GO amounts. Copyright © 2013 John Wiley & Sons, Ltd.     

Low C24‐OH and C22‐OH sulfatides in human renal cell carcinoma

Histopathologic diagnosis of renal cell carcinoma (RCC) may sometimes be difficult with small biopsy samples. We applied histology‐directed matrix‐assisted laser desorption/ionization mass spectrometry to RCC samples to evaluate whether and how lipid profiles are different between RCC and normal tissue. We evaluated 59 RCC samples and 24 adjacent normal tissue samples collected from patients who underwent surgery. Five peaks were significantly differently expressed (p < 10^?7) between RCCs and adjacent normal tissue samples. C24‐OH sulfatide (ST‐OH {18:1/24:0}[M‐H]^?; m/z 906.7 in the negative ion mode) and C22‐OH sulfatide (ST‐OH {18:1/22:0}[M‐H]^?; m/z 878.6 in the negative ion mode) were most significantly underexpressed in RCC samples, compared with adjacent normal tissue samples. With 100 random training‐to‐test partitions within these samples, the median prediction accuracy (RCC vs. normal) ranged from 96.3% to 100% at p cutoff values for feature selection ranging from 0.001 to 10^?7. Two oncocytoma samples were predicted as normal tissue by five lipids that were differentially expressed between RCC and normal tissue at p < 10^?7. Clear‐cell, papillary, and chromophobe RCCs were different in lipid profiles. Permutation p‐ values for 0.632+ bootstrap cross‐validated misclassification rates were less than 0.05 for all the classifiers. Thus, lipid profiles differentiate RCC from normal tissue and may possibly classify the histology of RCC. © 2014 The Authors. Journal of Mass Spectrometry published by John Wiley & Sons, Ltd.