Purification of 3-ethoxycarbonylquinuclidine and its conversion to 3-quinuclidinecarboxylic acid and 3-quinuclidinylmethanol

3-Ethoxycarbonylquinuclidine obtained by the Grob method is a mixture of 3-ethoxycarbonyl-1-azabicylo-[2.2.2]- and, according to ¹³C NMR data, 5-ethoxycarbonyl-5-azatricyclo[3.2.1.0^2,7]octanes (1621). 3-Ethoxy-carbonylquinuclidine was purified by recrystallization of the hydrochloride, hydrolyzed by water to 3-quinuclidinecarboxylic acid, and reduced by LiAlH₄ to 3-quinuclidinylmethanol.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 11, 1509–1512, November, 1992.     

Isotope gas analysis of tritium-labelled organic compounds based on pyrolytical decomposition

Summary A procedure has been developed for the activity measurement of tritium-labelled organic compounds in the gas phase. The organic compounds are pyrolysed in hydrogen carrier gas at 1150° and the decomposition products are swept through a carbon packing in accordance with the principle of the oxygen determination developed byUnterzaucher andBürger. The radioactive gas mixture obtained from the sample is swept by the hydrogen carrier gas flowing continuously through the reactor into a proportional counter tube, after the addition of propanebutane counter gas. By closure of the counter tube at a suitable moment, the radioactive gas is quantitatively trapped in the counter tube. The activity is measured in the limited proportional region. No memory effect occurs. The preparation of the sample requires 12 minutes; the relative standard deviation of analysis is <0.5%.

---

Zusammenfassung Ein Verfahren zur Aktivitätsbestimmung bei tritium-markierten organischen Verbindungen in der Gasphase wurde ausgearbeitet. Die organischen Substanzen werden in Wasserstoff als Trägergas bei 1150° pyrolysiert. Die Zersetzungsprodukte werden wie bei der Sauerstoffbestimmung nachUnterzaucher bzw.Bürger über eine Kohleschicht geleitet. Das radioaktive Gas-gemisch aus der Probe gelangt mit dem kontinuierlich strömenden Trägergas in ein Proportionalzählrohr, nachdem Propan-Butan-Zählgas zugesetzt wurde. Man schließt das Zählrohr im richtigen Augenblick, um das radioaktive Gas quantitativ zu erfassen. Die Aktivität wird im Proportionalbereich gemessen. Ein Memory-Effekt tritt nicht auf. Die Vorbereitung der Probe beansprucht 12 Minuten. Die relative Standardabweichung ist kleiner als 0,5%.

     

Differentiation between dexamethasone and betamethasone in a mixture using multiple mass spectrometry

Direct gas chromatographic methods to analyse phenylurea pesticides are discouraged by the thermal instability of these compounds, that in conventional hot splitless inlet systems leads to extensive and irreproducible formation of isocyanates and amines. However a careful control of the operating conditions, like the inlet temperature, the pressure and the presence of suitable chemical additives (as acetic acid, low-molecular-mass amines, organic anhydrides) can either: (i) minimise the thermal decomposition enabling the direct GC-MS analysis of phenylureas, or (ii) lead to reproducible conversion to isocyanates. Experimental design was employed to study the effect of the experimental variables on the thermal transformation of phenylurea pesticides in splitless inlet system. Two strategies were alternatively optimised: (i) the minimisation of degradation reactions to increase the signal of phenylureas; (ii) the maximisation of the degradation to isocyanates that are in turn determined. The maximal yields in isocyanate were obtained with high inlet temperatures, low carrier flows in the injection phase and the presence of acetic anhydride. By contrast, the use of relatively low inlet temperatures, high carrier flows during the injection and the presence of an amine maximise the response of the parent compounds.     

Manometric precision determination of carbon and hydrogen in milligram amounts of organic material

A method is described for the precise determination of carbon and hydrogen in milligram, amounts of sample. The method is based on the manometric measurement of the amounts of carbon dioxide and water formed on combustion. A precision mercury manometer is used in which pressures are converted to mercury volumes. The latter are measured with the aid of a commercial piston-type buret using a photo-electric level indication.     

Figures of merit of pneumatic and ultrasonic sample introduction systems in inductively coupled plasma–multichannel-based emission spectrometry in an ultra-clean environment

Conventional figures of merit such as limits of detection, signal to background ratio or repeatability, are used to determine the performance of pneumatic and ultrasonic sample introduction systems in an ultra-clean environment with an axially viewed inductively coupled plasma-atomic emission spectrometry and multichannel detection. We observed that the ultrasonic nebuliser offered a large improvement of signal intensity (10-133 greater) compared to a cyclone chamber coupled with a pneumatic Meinhard nebuliser. This improvement is associated with an average increase of signal to background ratio by a factor 86 and an average decrease of detection limits by a factor 6. The improvement factors generally depend on the element and for the same element on spectral lines. Typically, the observed values of detection limits in this work are lower than those published and obtained in non-ultra-clean conditions. The results emphasize that the environmental conditions of cleaning and analysis are essential to avoid and control cross contamination of the samples and hence to obtain low detection limits.     

Tetraphenylbismuth 2,4-Dimethylbenzenesulfonate: Synthesis and Structure

Tetraphenylbismuth 2,4-dimethylbenzenesulfonate was synthesized by reacting pentaphenylbismuth or bromine with diphenylbismuth 2,4-dimethylbenzenesulfonate and its structure was established using X-ray diffraction analysis. The Bi atom has a distorted trigonal bipyramidal coordination. The Bi–C bond lengths are equal to 2.199(4)–2.227(4) Å the Bi–O distance and axial CBiO angle are equal to 2.665(3) Å and 174.2(1)°, respectively.     

L X-ray production cross sections, average L shell fluorescence yield and intensity ratios in heavy elements

L X-ray fluorescence cross sections, and intensity ratios were measured for elements in the 70￡Z￡92 atomic range at the excitation energy 59.5 keV using a Si(Li) detector. Furthermore, L X-ray fluorescence cross sections and intensity ratios were calculated for elements in the same range. The average L shell fluorescence yields were derived using experimental L X-ray fluorescence cross sections and theoretical photoionization cross sections. The obtained results were compared with other experimental and theoretical values. This revised version was published online in August 2006 with corrections to the Cover Date.     

Potential and Current Distributions in Chlorine Diaphragm Electrolyzers with Gas Removal from the Back Side of External Electrodes and Possibility of Electrolysis Intensification

The cell voltage balance components of monopolar and bipolar electrolyzers were analyzed on the basis of calculations in terms of a mathematical model of the potential and current distributions along the cell height and tests of a laboratory electrolyzer of industrial height. Ways to diminish energy expenditure and to intensify diaphragm electrolysis of aqueous sodium chloride solutions were substantiated theoretically and experimentally.     

Sorption-photometric and test determination of lead in environmental materials

The main analytical characteristics of the reaction of hexaoxacycloazochrom with lead were determined. A method for the sorption preconcentration of lead on the Thiopan 14 sorbent was proposed. Procedures were developed for the photometric determination of lead in natural waters, air, and soil at the level of the maximum permissible concentration. A new melange gel technique for preparing silicic acid xerogels modified with hexaoxacycloazochrom was developed for the test determination of lead in environmental samples at the level of the maximum permissible concentration.     

Determination of rare earth elements by neutron activation analysis in altered ultramafic rocks from the Akwatia District of the Birim diamondiferous field,Ghana

Summary Rare earth element (REE) analysis using instrumental neutron activation (INAA) was carried out on ultramafic rocks from the Akwatia District of the Birim diamondiferous field, Ghana, with the primary objective of investigating their kimberlitic characteristics. The total REE concentrations range from 113 to 1610 ppm and fall within the interval of those reported in the literature for kimberlites. Despite the marked difference in the REE contents, all the analyzed samples show similar REE patterns that resemble those of kimberlites. However, compared to most of the kimberlites, the ultramafic rocks have small negative Eu anomalies and low light-REE/heavy-REE ratios, suggesting that the rocks have been significantly assimilated by crustal rocks.