Analytical investigations of the behavior of silole-core dendrimers with peripheral globotriaose in water and acetone/water mixed solvent

A new compound having a 2,3,4,5-tetraphenylsilole derivative on the center silicon of Dumbbell(1)6Gb3; Silole-Dumbbell(1)6Gb3 (1) was previously reported. It was found that 1 exhibited strongly increased fluorescence both in water and in a 96% acetone/water mixed solvent. The physical behavior of 1 in water and in the 96% acetone/water mixed solvent was investigated, and analyses including fluorescence quantum yields, dynamic-light-scattering (DLS), atomic-force-microscopy (AFM), and fluorescence microscopy were carried out. It was clarified that 1 dynamically formed different types of aggregates in water and in higher acetone concentrations to yield high aggregation-induced emission (AIE) effects due to the formation of micelle-like particles in water and inversion-type micelles in the acetone/water mixed solvent, respectively.     

Control of energy spread and dark current in proton and ion beams generated in high-contrast laser solid interactions

By using temporal pulse shaping of high-contrast, short pulse laser interactions with solid density targets at intensities of 2 × 10(21) W cm(-2) at a 45° incident angle, we show that it is possible to reproducibly generate quasimonoenergetic proton and ion energy spectra. The presence of a short pulse prepulse 33 ps prior to the main pulse produced proton spectra with an energy spread between 25% and 60% (ΔE/E) with energy of several MeV, with light ions becoming quasimonoenergetic for 50 nm targets. When the prepulse was removed, the energy spectra was broad. Numerical simulations suggest that expansion of the rear-side contaminant layer allowed for density conditions that prevented the protons from being screened from the sheath field, thus providing a low energy cutoff in the observed spectra normal to the target surface.     

Radiation damage in Si photodiodes by high-temperature irradiation

Results are presented of a detailed study of the effects of high-temperature 4-MeV neutron irradiation on the performance degradation of Si pin photodiodes together with the radiation-induced defects, observed by deep level transient spectroscopy. The degradation of the device performance and the introduction rate of the lattice defects decrease with increasing sample temperature during irradiation. For a 250°C irradiation, the reduction of the reverse current is only 20% of the starting value. This result suggests that the creation and recovery of the radiation damage proceeds simultaneously at high temperatures. Carbon-related complex as hole capture levels is also mainly responsible for the device degradation for high-temperature neutron irradiation.     

Influence of blood proteins on biomedical analysis. XII. Effects of glycation on gliclazide (oral hypoglycemic drug)-binding with serum albumin in diabetics.

The sera of diabetic patients showed an inverse correlation (r = -0.67, n = 57) between free gliclazide (oral hypoglycemic drug) level and the fructosamine value. The binding capacity of the primary binding site for gliclazide in the albumin molecule was increased from 4.5 x 10(-4) to 8.0 x 10(-4) M-1 by glycation of albumin, but not that of the secondary binding site (1.2 x 10(-4) M-1). This suggests that the glycation of albumin increases its total binding capacity for gliclazide, resulting in a low free gliclazide level. Therefore, a low hypoglycemic activity of the drug is observed when it is administered to diabetic patients with hyperglycemia.     

Volume reduction and tritium retention factor in electrolytic enrichment of water

Volume reduction(N), tritium retention factor (R), tritium concentration factor(Z) and apparent separation factor(beta) were measured on the large and small electrolytic cell systems. The relative variation of R was smaller than that of Z. So, it is recommended to use R in calculation of tritium concentrations in water samples. Furthermore, it was empirically revealed that R can be obtained only from N if a reliable beta-value is previously known. Therefore, it is possible to obtain R without electrolysis of the tritium standard solution. Taking into account the above facts, the so-called non-spike analysis of tritium, in which electrolytic enrichment and liquid scintillation counting are combined, becomes practicable.     

Carbazole Dendrimers as Solution‐Processable Thermally Activated Delayed‐Fluorescence Materials

Recently, thermally activated delayed fluorescence (TADF) materials have received increasing attention as effective emitters for organic light‐emitting diodes (OLEDs). However, most of them are usually employed as dopants in a host material. In this report, carbazole dendrimers with a triphenyl‐s‐triazine core are reported, which are the first solution‐processable, non‐doped, high‐molecular‐weight TADF materials. The dendrimers were obtained by a new and facile synthetic route using the tert‐butyldimethylsilyl moiety as a protecting group. All dendrimers showed TADF in toluene. Measurements of the temperature‐dependent luminescence lifetime revealed that spin‐coated neat films also showed TADF with moderate quantum yields. OLED devices incorporating these dendrimers as spin‐coated emitting layers gave external quantum efficiencies of up to a 3.4 %, which suggests that this device is harvesting triplet excitons. This result indicates that carbazole dendrimers with attached acceptors are potential TADF materials owing to their polarized electronic structure (with HOMO–LUMO separation).     

Highly photoluminescent nanocrystals based on a gold(I) complex and their electrophoretic patterning

The fabrication of nanocrystals (NCs) composed of the cationic Au(I) complex was demonstrated by the reprecipitation method in which the colloidal solution of the NCs showed brilliant green phosphorescence with a quantum yield of 83% in n-hexane. Characterization of the prepared NCs was performed by transmission electron microscopy observation and elemental analysis with energy-dispersive X-ray spectroscopy. The obtained Au(I) NCs were particles of random shapes with a diameter of 200-400 nm. The selected-area electron diffraction and X-ray diffraction measurements showed the characteristic diffraction patterns attributable to the crystal structure of the bulk crystal of the Au(I) complex. A similar method was performed with a different counteranion, leading to a colloidal solution of the microcrystals (MCs) with brilliant yellow phosphorescence and a quantum yield of 26% in n-hexane. Luminescence patterning of the NCs and MCs was also achieved successfully by electrophoretic deposition onto an indium tin oxide (ITO)-coated glass substrate, resulting in characteristic luminescence patterns on the ITO substrates with relatively high photoluminescence quantum yields.     

Non-surface activity and micellization behavior of cationic amphiphilic block copolymer synthesized by reversible addition-fragmentation chain transfer process

Cationic amphiphilic diblock copolymers of poly(n-butylacrylate)-b-poly(3-(methacryloylamino)propyl)trimethylammonium chloride) (PBA-b-PMAPTAC) with various hydrophobic and hydrophilic chain lengths were synthesized by a reversible addition-fragmentation chain transfer (RAFT) process. Their molecular characteristics such as surface activity/nonactivity were investigated by surface tension measurements and foam formation observation. Their micelle formation behavior and micelle structure were investigated by fluorescence probe technique, static and dynamic light scattering (SLS and DLS), etc., as a function of hydrophilic and hydrophobic chain lengths. The block copolymers were found to be non-surface active because the surface tension of the aqueous solutions did not change with increasing polymer concentration. Critical micelle concentration (cmc) of the polymers could be determined by fluorescence and SLS measurements, which means that these polymers form micelles in bulk solution, although they were non-surface active. Above the cmc, the large blue shift of the emission maximum of N-phenyl-1-naphthylamine (NPN) probe and the low micropolarity value of the pyrene probe in polymer solution indicate the core of the micelle is nonpolar in nature. Also, the high value of the relative intensity of the NPN probe and the fluorescence anisotropy of the 1,6-diphenyl-1,3,5-hexatriene (DPH) probe indicated that the core of the micelle is highly viscous in nature. DLS was used to measure the average hydrodynamic radii and size distribution of the copolymer micelles. The copolymer with the longest PBA block had the poorest water solubility and consequently formed micelles with larger size while having a lower cmc. The "non-surface activity" was confirmed for cationic amphiphilic diblock copolymers in addition to anionic ones studied previously, indicating the universality of non-surface activity nature.