Evaluation of an Economical Sunlamp that Emits a Near Solar UV Power Spectrum for Conducting Photoimmunological and Sunscreen Immune Protection Studies

Expense and inconvenience have restricted the use of the filtered xenon are lamp (solar simulator) as a UV source for conducting large-scale animal studies. Because sunscreen immunoprotective levels are significantly affected by the UV power spectrum of the source it is imperative that a solar simulating source be used for accurate measurements of sunscreen protection levels that are relevant to human UV exposures from sunlight. However, relatively inexpensive sunlamps, e. g. the UVA-340, that emit a UV power spectrum similar to that of a solar simulator are available. Unlike FS-type UVB sunlamps, which have a significant amount of effective immunosuppressive nonsolar UV energy at wavelengths below 295 nm, the immunosuppression effectiveness spectrum of UVA-340 sunlamps was nearly identical to that of a solar simulator. The purpose of this study was to evaluate this sunlamp for conducting photoimmunological and sunscreen immune protection studies. Groups of C3H mice were exposed to a range of UVA-340 sunlamp doses (0.25 KJ/m² to 20.0 KJ/m²) to establish a dose-response curve and determine the minimum immune suppression dose (MISD) for induction of local-type suppression of contact hypersensitivity (CH). The MISD, defined as the lowest UV dose given to produce ～50% suppression of the CH response in mice, was determined to be 1.0 kJ/m² for UVA-340 sunlamps. Immune protection tests on four marketed sunscreen lotions (sun protection factors [SPF] 4, 8, 15 and 30) were then conducted with UVA-340 sunlamps using MISD as the endpoint. The immune protection factors for these sunscreens were equivalent to the level of protection predicated by their labeled SPF. These results are similar to those we have previously obtained using a solar simulator. We conclude from these data that the immunosuppressive effects of UVA-340 sunlamps are similar to those of a solar simulator; however, further studies are needed to determine if UVA-340, or similar, sunlamps are a viable alternative to the solar simulator for conducting large-scale animal experiments that require a relevant UV solar spectrum.     

Fabrication of hollow palladium spheres and their successful application to the recyclable heterogeneous catalyst for suzuki coupling reactions

Novel palladium hollow spheres were synthesized using silica spheres as a template, and they were successfully applied as recyclable heterogeneous catalysts for Suzuki cross coupling reactions.     

Copolymerization characteristics of S-vinyl-O-tert-butylthiocarbonate

Poly-S-vinyl-O-tert-butylthiocarbonate is an excellent precursor to poly(vinyl mercaptan) because the tert-butyloxycarbonyl blocking group can be removed by either acid hydrolysis or thermolysis under conditions which minimize the oxidation of the liberated mercaptan to disulfide. Dilatometric studies of the homopolymerization of S-vinyl-O-tert-butylthiocarbonate demonstrated that the polymerization rate was directly proportional to the concentration of free-radical initiator; no thermal initiation was observed. The molecular weight of the homopolymers and copolymers ranged from 30,000 to 50,000 (GPC). Copolymerization of S-vinyl-O-tert-butylthiocarbonate (M₂) with styrene, (r₁ = 3.0, r₂ = 0.2), methyl methacrylate (r₁ = 1.40, r₂ = 0.17) and vinyl acetate (r₁ = 0.04, r₂ = 11.0) indicated that a sulfur atom adjacent to the vinyl group increases the resonance stability (Q₂ = 0.5) and the electron density (e₂ = ?1.4) of the double bond and the corresponding radical. Water-soluble copolymers could be prépared by incorporating either N-vinylpyrrolidone (r₁ = 0.12, r₂ = 3.94) or N-isopropylacrylamide (r₁ = 1.17, r₂ = 0.3) with M₂. The water solubility of the copolymers decreased markedly when the tert-butyloxycarbonyl group was removed. Copolymers of M₂ with N-vinyl-O-tert-butylcarbamate (r₁ = 0.13, r₂ = 5.10) were utilized to prepare crosslinked poly(vinyl amine–vinyl mercaptan); the crosslinking resulted from urea linkages formed during thermolysis of the copolymer.     

A Facile Construction of the Quadranoid Skeleton: Application to the Total Synthesis of (+/-)-Suberosenone

A tandem free radical cyclization-rearrangement sequence was designed and executed to produce tricyclo[4.3.2.0(1,5)]undecane 7 from cyclopentene 6A in a single operation. The total synthesis of suberosenone was accomplished from 7.     

Detection of vibration-rotational band 5-0 of 12C16O X 1sigma+ with cavity ringdown absorption near 0.96 microm

We have recorded extremely weak absorption in the overtone band 5-0 of 12C16O X 1sigma+ near 0.96 microm with cavity ringdown spectroscopy; the light source was a Raman-shifted dye laser pumped with a frequency-doubled Nd:YAG laser. This band shows lines in branch P to be much more intense than corresponding lines in branch R, in contrast to all lower overtone bands v-0 (v = 1-4). This reversal in relative intensity is explained quantitatively in terms of a radial function for the electric dipolar moment of CO. We have estimated absorption line strengths for P3-P18 in band 5-0 of 12C16O; these strengths are consistent with a pure vibrational matrix element <5/p(x)/0> = (3.6 +/- 0.3) x 10(-36) C m of the electric dipolar moment p(x), a Herman-Wallis coefficient C0(5) of about -0.1, and a band strength of (5.1 +/- 1.3) x 10(-29) m at 293 K.     

Conformational and Configurational Determination in 1,1,4,4-Tetrafluoro-2-Propylidene-3-Methyl-6-Tert-Butyl-1,4-Disila-5-Cyclohexene

A complete assignment of the ¹H, ¹³C and ¹⁹F NMR spectra of 1,1,4,4-tetrafluoro-2-propylidene-3-methyl-6-tert-butyl-1,4-disila-5-cyclohexene 3, the product of the cycloaddition reaction between tetrafluorodisilacyclobutene 1 and cis, trans-2,4-hexadiene mediated by (n⁵-C₅H₅)Mn(CO)₃, has been made by means of various 2D NMR chemical shift correlation methods and selective heteronuclear decoupling techniques. An analysis of the three bond ¹³C-¹H coupling constants and two bond ¹³C-¹⁹F coupling constants and the molecular modeling results enabled the determination of the conformation and configuration of compound 3. The conformation of 3 provides insight into mechanistic details of the Mn-mediated cycloaddition.     

Ligand exchange reactions of ferrocene with phenanthrene or 9,10-dimethylphenanthrene in the presence of aluminum chloride and aluminum

Ligand exchange reactions between phenanthrene or 9,10-dimethylphenanthrene with ferrocene effected in the presence of AlCl₃-Al were carried out under a variety of conditions. With phenanthrene (I), hydrogenation at the C-9 and C-10 positions could take place during the reaction and the cationic products obtained were the η⁶-phenanthrene-η⁵-cyclopentadienyliron and η⁶-9,10-dihydro-phenanthrene-η⁵-cyclopentadienyliron moncations (II and III), and the η⁶-phenanthrene-$\text{trans}$-$\text{bis}$-η⁵-cyclopentadienyliron and η⁶-9,10-dihydrophenanthrene-$\text{trans}$-$\text{bis}$-η⁵-cyclopentadienyliron dications (IV and V). With 9,10-dimethylphenanthrene (VI), reactions carried out in refluxing cyclohexane gave the non-hydrogenated η⁶-9,10-dimethylphenanthrene-η⁵-cyclopentadienyliron monocation (VII) and η⁶-9,10-dimethylphenanthrene-$\text{trans}$-$\text{bis}$-η⁵-cyclopentadienyliron dication (VIII). When higher temperatures were used in an attempt to promote hydrogenation, decomposition predominated and no cationic product could be obtained. These finding are discussed and contrasted with previous results obtained from similar reactions using anthracene or 9,10-dimethylanthracene.     

Triazine chemistry VIII. 2,5-dihydro-5-oxo-1,2,4-triazines

2,5-Dihydro-5-oxo-1,2,4-triazine and some of its alkylated derivatives have been prepared. Nmr spectroscopic analysis has established that the 2,5-dihydro-5-oxo tautomers are preferred over the 4,5-dihydro-5-oxo ones. This preference, and the behavior of 1,2,4-triazines in some other chemical reactions has been interpreted in terms of electron-electron repulsions between the lone pairs of electrons of N₁ and N₂ in this ring system.     

Preparation of Y2Ba4Cu7O15-δ Superconductor without High Oxygen Pressure

The synthesis of bulk Y₂Ba₄Cu₇O_15-δ superconductor at atmospheric oxygen pressure via solid state sintering is reported. Temperature ranging from 860 to 890 °C as well as time interval over 2 to 15 days were used to investigate the formation of the Y₂Ba₄Cu₇O_15-δ phase. A time-temperature profile characterizing the conditions for the preparation of Y₂Ba₄Cu₇O_15-δ phase suggests the optimal condition to be sintering at 890 °C for over 10 days. Detailed results of X-ray diffraction, electrical resistivity, iodometric titration and magnetization measurements are described.     

Triorganosilyl Ethers of Benzaldehyde,m-Methoxybenzaldehyde and Anisoles

Synthesis of six new triorganosiloxybenzaldehydes, two m-methoxy-(triorganosiloxy)benzaldehydes, and seven methoxy(triorganosiloxy)benzenes are reported. From comparison of the stability of these compounds in the atmosphere, it is concluded that formyl group shows unfavorable influence and methoxy group shows favorable influence on the stability of these compounds. The oposite influences of these two groups on phenoxysilane linkage seems to connect with the oposite directiones of inductive effect of formyl group and resonance effect of methoxy group on the benzene ring.