QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Development of an LC‐MS/MS method for determining the pharmacokinetics of clonidine following oral administration of Zhenju antihypertensive compound

Zhenju antihypertensive compound (ZJAHC) is a combined Chinese–Western medicine formula including clonidine (CLO), hydrochlorothiazide (HCT), rutin, Chrysanthemum indicum extract and pearl powder. Compared with CLO preparations, ZJAHC shows improved activities and decreased adverse effects. It is believed that the side effects of CLO are caused by its high peak plasma concentration. Hence, study of the influence of ZJAHC on the pharmacokinetic behaviors of clonidine seems essential. In present study, the plasma concentrations of CLO were determined with a liquid chromatography–tandem mass spectrometry (LC‐MS/MS) method. The MS/MS transitions monitored for clonidine and internal standard were 230.2 → 213.1 and 152.2 → 110.2, respectively. The analyte was quantified in a single run within 3 min. The pharmacokinetic study showed that the area under the plasma concentration–time curve of CLO in ZJAHC (60 µg/kg CLO) was similar to that of CLO‐HCT‐high (120 µg/kg CLO) but the peak concentration was much lower than that in CLO‐HCT‐high. ZJAHC could enhance the bioavailability without greatly increasing peak concentration of clonidine. This comprehensive effect of enhancing the bioavailability and avoiding the high peak plasma concentration for CLO might mainly result from the co‐contribution of Western medicine and traditional Chinese medicine (TCM), while the effect of TCM was stronger than that of Western medicine. Copyright © 2014 John Wiley & Sons, Ltd.     

焦炉上升管内壁结焦炭层的光谱学分析及结焦机理研究

以焦炉上升管内壁结焦炭层块为研究对象，采用X射线荧光光谱仪（XRF）、X射线衍射仪（XRD）、傅里叶红外光谱仪（FTIR）和激光共聚焦拉曼光谱仪（Raman）对结焦炭层的元素组成，以及各结焦炭层的矿物组成、组成结构和分子结构进行测试。分析从结焦炭层块外表面向内表面过渡的各结焦炭层的差异性，揭示焦炉上升管内壁结焦机理。结果表明焦炉上升管内粉尘中Fe，S和Cr极易催化荒煤气中蒽、萘等稠环芳烃化合物成炭，在焦炉上升管内壁形成炭颗粒沉积，为焦油凝结挂壁提供载体，在荒煤气温度降至结焦温度时易结焦积碳。结焦炭层均含有芳香层结构，随着结焦炭层从外表面向内表面过渡，各结焦炭层的面层间距(d₀₀₂)逐渐降低、层片直径(L_a)先降低后增加、层片堆砌高度(Lc)和芳香层数(N)先稳定后增加。结焦炭层石墨化过程是由结焦炭层内表面向外表面进行，主要包括其片层外缘的羧基和部分C-O结构的降解剥离，从而形成高度规整的共轭结构。结焦炭层块中C元素是以结晶碳与无定型碳的混合物形式存在。以上研究为解决焦炉上升管内壁结焦及腐蚀问题，提高换热器换热效率，有效回收焦炉荒煤气显热，降低焦化企业能耗提供实验基础和理论依据。     

Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

非线性互补问题的一种全局收敛的显式光滑Newton方法

本针对Po函数非线性互补问题，给出了一种显式光滑Newton方法，该方法将光滑参数μ进行显式迭代而不依赖于Newton方向的搜索过程，并在适当的假设条件下，证明了算法的全局收敛性。     

相匹配契伦可夫辐射式倍频

用波导产生倍频波时,如果倍频波进入辐射模区,仍然有相匹配问题。契伦可夫辐射式倍频不是自动地实现相匹配的。相匹配要求导波基波模式场,倍频传输场(自由波),倍频触发场,以及经多次反射透射后的辐射场的迭加形成的总辐射场处于同步的相匹配状态。根据这个相匹配的分析,提出波导契伦可夫相匹配的特有的方法,那就是对波导的模色散进行设计,并指出非对称波导的特有优点,是改变一个边界上的反射相变,即选择不同色散的线性材料作包层,由此可得到相匹配的高效契伦可夫倍频辐射。     

关于绝对半素环和绝对半素根

本文了绝对半素环的概念，研究了绝对半素与与半素环及素环之间的关系，讨论了由全体绝对半素环类决定的上根－－绝对半半素根及其性质。     

原子吸收光谱法测定铝锂合金中锂

本文研究了用原子吸收光谱法在笑气－乙炔火焰中测定铝锂合金中锂的最佳条件。其电离干扰可通过加进钾进盐来控制。应用本法测定合金中 锂的含量，获得了满意结果。