Effect of Groundwater Composition on Arsenic Detection by Bacterial Biosensors

A luminescent bacterial biosensor was used to quantify bioavailable arsenic in artificial groundwater. Its light production above the background emission was proportional to the arsenite concentration in the toxicologically relevant range of 0 to 0.5 μM. Effects of the inorganic solutes phosphate, Fe(II) and silicate on the biosensor signal were studied. Phosphate at a concentration of 0.25 g L⁻¹ phosphate slightly stimulated the light emission, but much less than toxicologically relevant concentrations of the much stronger inducer arsenite. No effect of phosphate was oberved in the presence of arsenite. Freshly prepared sodium silicate solution at a concentration of 10 mg L⁻¹ Si reduced the arsenite-induced light production by roughly 37%, which can be explained by transient polymerization leading to sequestration of some arsenic. After three days of incubation, silicate did not have this effect anymore, probably because depolymerization occurred. In the presence of 0.4 mg L⁻¹ Fe(II), the arsenite-induced light emission was reduced by up to 90%, probably due to iron oxidation followed by arsenite adsorption on the less soluble Fe(III) possibly along with some oxidation to the stronger adsorbing As(V). Addition of 100 μM EDTA was capable of releasing all arsenic from the precipitate and to transform it into the biologically measurable, dissolved state. The biosensor also proved valuable for monitoring the effectiveness of an arsenic removal procedure based on water filtration through a mixture of sand and iron granules.     

Synthesis and structural characterization of new oxorhenium and oxotechnetium complexes with XN2S-tetradentate semi-rigid ligands (X = O, S, N)

Twelve novel oxo-technetium and oxo-rhenium complexes based on N2S2-, N2SO- or N3S-tetradentate semi-rigid ligands have been synthesised and studied herein. By reacting the ligands with a slight excess of suitable [MO]3+ precursor (ReOCl3(PPh3)2 or [NBu4][99gTcOCl4]), the monoanionic complexes of general formula [MO(Ph-XN2S)]- could be easily produced in high yield. The complexes have been characterized by means of IR, electrospray mass spectrometry, elemental analysis, NMR and conductimetry. The crystal structures of [PPh4][ReO(Ph-ON2S)] 1b and [NBu4][99gTcO(Ph-ON2S)] 1c have been established. The [MO]3+ moiety was coordinated via the two deprotonated amide nitrogens, the oxygen and the terminal sulfur atoms in 1b and 1c. In both compounds, the ON2S coordination set is in the equatorial plane, and the complexes adopted a distorted square-pyramidal geometry with an axial oxo-group. The chemical and structural identity of the different prototypic complexes (rhenium, 99gTc complexes and their corresponding 99mTc radiocomplexes) have been also established by a comparative HPLC study.     

Synthesis, structural, spectroscopic, and electrochemical characterization of high oxidation state diruthenium complexes containing four identical unsymmetrical bridging ligands

Six Ru2(6+) derivatives of the form Ru2(L)4(C[triple bond]CC6H5)(2), where L = 2-Fap, 2,3-F(2)ap, 2,4-F(2)ap, 2,5-F(2)ap, 3,4-F(2)ap, or 2,4,6-F(3)ap, are synthesized and characterized as to their electrochemical, spectroscopic, and/or structural properties. These compounds are synthesized from a reaction between LiC[triple bond]CC6H5 and Ru2(L)4Cl. Two of the investigated complexes exist in a (4,0) isomeric form while four adopt a (3,1) geometric conformation. These two series of geometric isomers are compared with previously characterized (4,0) Ru2(ap)4(C[triple bond]CC6H5)(2), (4,0) Ru2(F5ap)4(C[triple bond]CC6H5)(2), and (3,1) Ru2(F5ap)4(C[triple bond]CC6H5)(2). The overall data on the nine compounds thus provide an opportunity to systematically examine how the electrochemical and structural properties of these Ru2(6+) complexes vary with respect to isomer type and electronic properties of the bridging ligands.     

Processes associated with ionic current rectification at a 2D-titanate nanosheet deposit on a microhole poly(ethylene terephthalate) substrate

Films of titanate nanosheets (approx. 1.8-nm layer thickness and 200-nm size) having a lamellar structure can form electrolyte-filled semi-permeable channels containing tetrabutylammonium cations. By evaporation of a colloidal solution, persistent deposits are readily formed with approx. 10-μm thickness on a 6-μm-thick poly(ethylene-terephthalate) (PET) substrate with a 20-μm diameter microhole. When immersed in aqueous solution, the titanate nanosheets exhibit a p.z.c. of − 37 mV, consistent with the formation of a cation conducting (semi-permeable) deposit. With a sufficiently low ionic strength in the aqueous electrolyte, ionic current rectification is observed (cationic diode behaviour). Currents can be dissected into (i) electrolyte cation transport, (ii) electrolyte anion transport and (iii) water heterolysis causing additional proton transport. For all types of electrolyte cations, a water heterolysis mechanism is observed. For Ca²⁺ and Mg²⁺ions, water heterolysis causes ion current blocking, presumably due to localised hydroxide-induced precipitation processes. Aqueous NBu₄⁺ is shown to ‘invert’ the diode effect (from cationic to anionic diode). Potential for applications in desalination and/or ion sensing are discussed.

     

Macrocycle synthesis strategy based on step-wise “adding and reacting” three components enables screening of large combinatorial libraries

Macrocycles provide an attractive modality for drug development, but generating ligands for new targets is hampered by the limited availability of large macrocycle libraries. We have established a solution-phase macrocycle synthesis strategy in which three building blocks are coupled sequentially in efficient alkylation reactions that eliminate the need for product purification. We demonstrate the power of the approach by combinatorially reacting 15 bromoacetamide-activated tripeptides, 42 amines, and 6 bis-electrophile cyclization linkers to generate a 3780-compound library with minimal effort. Screening against thrombin yielded a potent and selective inhibitor (K_i = 4.2 ± 0.8 nM) that efficiently blocked blood coagulation in human plasma. Structure–activity relationship and X-ray crystallography analysis revealed that two of the three building blocks acted synergistically and underscored the importance of combinatorial screening in macrocycle development. The three-component library synthesis approach is general and offers a promising avenue to generate macrocycle ligands to other targets.

Combination of three efficient chemical reactions allows for solution-phase synthesis of 3780 macrocycles and identification of potent thrombin inhibitor.     

Decomposition of Gaseous Sulfide Compounds in Air by Pulsed Corona Discharge

The effectiveness of applying a pulsed corona discharge to the destruction of olfactory pollution in air was investigated. This paper presents a comparative study of the decomposition of three representative sulfide compounds in diluted concentrations: hydrogen sulfide (H₂S), dimethyl sulfide (DMS), and ethanethiol (C₂H₅SH), which could be completely removed when a sufficient but reasonable energy density was deposited in the gas. DMS showed the lowest energy cost (around 30 eV/molecules); C₂H₅SH and H₂S had an EC of respectively 45 eV and 115 eV. The efficiency of the non-thermal plasma process increased with decreasing the initial concentration of sulfide compounds, while the energy yield remained almost unchanged. SO₂ was the only identified byproduct of H₂S decomposition, but the sulfur balance suggests the formation of undetected SO₃. The byproducts analyzed during the degradation of DMS and C₂H₅SH enabled to propose a reaction mechanism, starting with radical attack and breaking of C–S bonds.     

Comparative study of the bonding in the first series of transition metal 1:1 complexes M-L (M = Sc, ..., Cu; L = CO, N(2), C(2)H(2), CN(-), NH(3), H(2)O, and F(-))

The nature of the chemical bonding in the 1:1 complexes formed by the fourth period transition metals (Sc, ..., Cu) with 14 electrons (N(2), CN(-), C(2)H(2)) and 10 electrons (NH(3), H(2)O, F(-)) ligands has been investigated at the ROB3LYP/6-311+G(2d) level by the ELF topological approach. The bonding is ruled by the nature of the ligand. The 10 electrons and anionic ligands are very poor electron acceptors and therefore the interaction with the metal is mostly electrostatic and for all metal except Cr the multiplicity is given by the [Ar]c(n)() configuration of the metallic core (n = Z - 20). The electron acceptor ligands which have at least a lone pair form linear or bent complexes involving a dative bond with the metal and the rules proposed previously for monocarbonyls hold. In the case of ethyne, it is not possible to form a linear complex and the cyclic C(2)(v)() structure imposed by symmetry possesses two covalent M-C bonds, therefore the multiplicity is given by the local core configuration [Ar]c(n)() for all metals except Mn and Ni.