The electrochemical reduction of perezone in the presence of benzoic acid in acetonitrile

An electrochemical study using transient techniques of a quinone-type natural product, perezone, has been performed in acetonitrile and in the presence of benzoic acid. Using linear sweep voltametry and single potential step chronoamperometry, it was possible to establish that the reduction mechanism of perezone involves a monoelectronic charge-transfer step, followed by a protonation step and homogeneous charge transfer due to disproportionation of the protonated intermediate. The mechanism for the homogeneous charge-transfer step was found to be of the type DISP1 (disproportionation order one) from the results of double potential step chronoamperometry experiments. The occurrence of the DISP1 mechanism was provoked by the mildly acidic medium used in this study.     

Analysis of atmospheric particular matter and water using atomic emission spectrometry with inductively-coupled plasma and two-jet plasmatron

Summary A method for the atomic emission spectrometric analysis of air and water with inductively coupled and two-jet direct current plasmas has been developed. The method has been applied to the determination of impurity contents with good accuracy and sensitivity.     

Improvement of the properties of polyarylate reinforced with liquid crystalline polymers

Blends of polyarylate of bisphenol A, PAr, with two commercial main chain liquid crystalline polymers, Vectra A950 and Vectra B950, are studied. From dynamic viscoelastic measurements it is deduced that both systems (PAr/Vectra A950 and PAr/Vectra B950) are immiscible and scanning electron microscopy (SEM) micrographs show the presence of spherical domains of the liquid crystalline polymer when PAr constitutes the matrix. Extrusion capillary measurements reveal that, under conditions of temperature and shear rate similar to those of processing, the viscosity is reduced to approximately 10% of its value when the content of liquid crystalline polymer is only 20%. This great improvement of the rheological properties is observed in both PAr/Vectra A950 and PAr/Vectra B950 blends. The effect of draw ratio on Young's modulus for different compositions is also analyzed, pointing out the reinforcing action of both liquid crystalline polymers on polyarylate: for instance, 20% of Vectra B950 in the blend gives rise to a 700% increase of the modulus of fibres prepared at a draw ratio of 50. SEM of the extrudates reveals that the spherical domains are elongated at the entrance of the capillary giving rise to a microfibrillar morphology which is related to the excellent rheological and mechanical properties of the blends.     

On error bounds for lower semicontinuous functions

We give some sufficient conditions for proper lower semicontinuous functions on metric spaces to have error bounds (with exponents). For a proper convex function f on a normed space X the existence of a local error bound implies that of a global error bound. If in addition X is a Banach space, then error bounds can be characterized by the subdifferential of f. In a reflexive Banach space X, we further obtain several sufficient and necessary conditions for the existence of error bounds in terms of the lower Dini derivative of f. Received: April 27, 2001 / Accepted: November 6, 2001?Published online April 12, 2002     

采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。     

Multicommuted fluorometric multiparameter sensor for simultaneous determination of naproxen and salicylic acid in biological fluids.

A combined approach based on solid-phase optosensing and multicommutation principles has been applied to develop a method for the simultaneous analysis of two pharmaceuticals (naproxen and salicylic acid) in biological fluids. The multicommuted flow-through optosensor was based on direct native fluorescence measurements of both analgesics using a non-polar sorbent (C18 silica gel) as a solid sensing zone. The flow system was controlled by Java-written home-made software and designed using three-way solenoid valves for an independent automated manipulation of sample and carrier solutions. Using an optimized sampling time, the method was calibrated in the range of 1 - 25 and 5 - 200 ng mL(-1). The obtained detection limits were 0.3 and 1.3 ng mL(-1) for naproxen and salicylic acid, respectively, with RSD (%) values of better than 2% for both analytes. The proposed methodology was successfully applied to urine, serum and pharmaceutical preparations. Recovery percentages ranging from 96.1 to 104% were obtained for both analytes.     

带有不等式约束的全局最优性条件

本文利用不连续罚函数方法将带有不等式约束的全局优化问题的求解转化为 讨论一非线性方程的求根问题,从而得到若干个全局最优性条件.     

矩阵方程（A^TXA，B^TXB=（C，D）的反对称解及其最佳逼近

本利用矩阵对的标准相关分解，得到了矩阵方程(A^TXB，B^TXB)=(C，D)反对称解存在的充分必要条件及通解表达式，同时给出了解关于已知矩阵的最佳逼近．     

Flow-injection spectrophotometric determination of sulfadiazine and sulfamethoxazole in pharmaceuticals and urine.

A rapid and sensitive flow-injection spectrophotometric method is proposed for the determination of sulfadiazine and sulfamethoxazole. This method is based on the diazotization of sulfonamide with sodium nitrite, and a coupling reaction of the diazo-compound with alpha-naphthylamine. The optimum experimental conditions are obtained by using the controlled and weighted centroid simplex method. The linear ranges for the determination of sulfadiazine and sulfamethoxazole are 0.2-20 microg ml(-1) and 0.1-20 microg ml(-1), and their detection limits are 0.06 microg ml(-1) and 0.05 microg ml(-1), respectively, and the sampling frequency is 130 samples per hour. The method has been used to determine sulfadiazine and sulfamethoxazole in pharmaceuticals and urine without separation. The results are in agreement with those obtained by a high-performance liquid chromatograph technique at the 95% confidence level.     

Optimal control of the obstacle in a quasilinear elliptic variational inequality

In this paper we consider an obstacle control problem where the state satisfies a quasilinear elliptic variational inequality and the control function is the obstacle. The state is chosen to be close to the desire profile while the H² norms of the obstacle is not too large. Existence and necessary conditions for the optimal control are established.