Determination of oxidized and reduced glutathione, by capillary zone electrophoresis, in Brassica juncea plants treated with copper and cadmium

A rapid method of capillary zone electrophoresis is described to determine the oxidized (GSSG) and reduced (GSH) form of glutathione in plant tissue. In order to separate both analytes in a fused-silica capillary, the pH and composition of the electrolyte solution were optimized. The electrolyte composition was 100 mmol/L, borate 25 mmol/L Tris, and 0.2% w/v metaphosphoric acid (MPA), pH 8.2. Some instrumental conditions used to run the samples were hydrostatic injection for 30 s, 30 kV applied voltage, and UV detection (185 nm) at 25 degrees C. Linearity and useful range obtained for the calibration curves were optimum, with correlation coefficients about 0.999 in the 0-120 micromol/L range. The migration time was highly reproducible, less than 5 min being afforded to run a sample. Electrolyte buffer and samples required a careful pH control for optimal separation of both analytes. This aspect constitutes a critical analytical step when acids are used in the procedure for sample preparation. Simultaneous analysis of GSH and GSSG may provide a useful tool for comparative studies of plants in order to select those species with a potential capacity for detoxification from toxic elements or those appearing promising from phytoremediation for these elements.     

Transport in ceria electrolytes modified with sintering aids: effects on oxygen reduction kinetics

Small (2 mol%) cobalt oxide additions to ceria-gadolinia (CGO) materials considerably improve sinterability, making it possible to obtain ceramics with 95–99% density and sub-micrometre grain sizes at 1,170–1,370 K. The addition of Co causes a significant shift of the electrolytic domain to lower pO₂. This modification to the minor electronic conductivity of the electrolyte material has influence on the cathodic oxygen reduction reaction. The impedance technique is shown to provide information not only about polarisation resistance, but also about the active electrode area from analysis of the current constriction resistance. It is demonstrated that this current constriction resistance can be related to the minor electronic contributions to total conductivity in these materials. A simple imbedded grid approach gives control of the contact area allowing the properties of the electrolyte materials to be studied. A much lower polarisation resistance for the Co-containing CGO electrolyte is observed, which can be clearly attributed to an increased three-phase reaction area in the Co-containing material, as a consequence of elevated p-type conductivity.     

Annulative π-extension of BODIPYs made easy via gold(i)-catalyzed cycloisomerization

Here we report gold(i)-catalyzed cycloisomerization as a new powerful synthetic tool for the preparation of π-extended BODIPY derivatives. The catalytic system PPh^F₃AuCl/AgSbF₆ enables the synthesis of [b]-[2,1]naphtho-fused-BODIPYs (2a–2c) under mild conditions, in excellent yields and short reaction times. The reaction is totally regioselective to the 6-endo-dig product and for the α-position of the BODIPY, which is both the kinetically and thermodynamically favored pathway, as supported by the free energy profile calculated by means of Density Functional Theory (DFT). Moreover, this methodology also allows the synthesis of two new families of [b]-aryl-fused-BODIPYs, namely, [3,4]phenanthro- (2e and 2f) and [1,2]naphtho-fused (2g) BODIPYs. Their molecular and electronic structures were established by NMR and UV-vis spectroscopies as well as single-crystal X-ray diffraction analysis. As can be noted from the X-ray structures, 2a, 2e and 2g present interesting structural differences at both the molecular and packing level. Interestingly, despite being isomers, the UV/vis spectra of 2a and 2g revealed significant differences in their electronic structures. The origin of this finding was studied by Time-Dependent DFT calculations. Calculated DFT Nuclear Independent Chemical Shift (NICS(0)) values also supported the different electronic structures of 2a and 2g.

Here we report gold(i)-catalyzed cycloisomerization as a new powerful synthetic tool for the preparation of π-extended BODIPY derivatives.     

NADH Electrooxidation Using Bis(1,10-phenanthroline-5,6-dione) (2,2'-bipyridine)ruthenium(II)-Exchanged Zirconium Phosphate Modified Carbon Paste Electrodes

We present a carbon paste electrode (CPE) modified using the electron mediator bis(1,10‐phenanthroline‐5,6‐dione)(2,2′‐bipyridine)ruthenium(II) ([Ru(phend)₂bpy]²⁺) exchanged into the inorganic layered material zirconium phosphate (ZrP). X‐Ray powder diffraction showed that the interlayer distance of ZrP increases upon [Ru(phend)₂bpy]²⁺ intercalation from 10.3 Å to 14.2 Å. The UV‐vis and IR spectroscopies results showed the characteristic peaks expected for [Ru(phend)₂bpy]²⁺. The UV‐vis spectrophotometric results indicate that the [Ru(phend)₂bpy]²⁺ concentration inside the ZrP layers increased as a function of the loading level. The exchanged [Ru(phend)₂bpy]²⁺ exhibited luminescence even at low concentration. Modified CPEs were constructed and analyzed using cyclic voltammetry. The intercalated mediator remained electroactive within the layers (E°′=–38.5 mV vs. Ag/AgCl, 3.5 M NaCl) and electrocatalysis of NADH oxidation was observed. The kinetics of the modified CPE shows a Michaelis–Menten behavior. This CPE was used for the oxidation of NADH in the presence of Bakers' yeast alcohol dehydrogenase. A calibration plot for ethanol is presented.     

Cold tests of open coaxial resonators in the range 9–17 GHz

A study of selective properties of coaxial open cylindrical resonators have been conducted experimentally and compared with theory. The resonator consists of an inner circular cylinder symmetrically located inside an outer weakly irregular open waveguide. Several fundamental TE modes were identified over the range 9 to 17 GHz through measurements of the resonant frequencies and the associated loaded quality factors. It has been verified that the structure and the number of resonant modes are both strongly dependent on the diameter of the coaxial insert. Such an electrodynamical system proves to be useful in guided wave applications requiring, for example, filters, frequency-tunable resonators and devices for analyzing the modal composition of a signal.     

Ab initio molecular dynamics simulation of a room temperature ionic liquid

Ab initio molecular dynamics simulations have been performed for the first time on the room-temperature organic ionic liquid dimethyl imidazolium chloride [DMIM][Cl] using density functional theory. The aim is to compare the local liquid structure with both that obtained from two different classical force fields and from neutron scattering experiments. The local structure around the cation shows significant differences compared to both the classical calculations and the neutron results. In particular, and unlike in the gas-phase ion pair, chloride ions tend to be located near a ring C-H proton in a position suggesting hydrogen bonding. The results are used to suggest ways in which the classical potentials may be improved.     

Use of highly efficient Draper-Lin small composite designs in the formal optimisation of both operational and chemical crucial variables affecting a FIA-chemiluminescence detection system

A new formal strategy in the multidimensional optimisation of the experimental variables affecting the chemiluminescence (CL) detection in flow injection analysis (FIA) is proposed here. The strategy implies several steps, being the most significant: selection of the variables to be studied and their experimental domain; use of a screening design to detect significant variables and interactions into the experimental region; study of the main effect of variables and second-order interactions; and finally application of a Draper-Lin small composite design (orthogonal) to obtain the optimum values of the significant variables. The methodology is applied to the determination of methylamine by FIA based on the use of the peroxyoxalate CL (PO-CL) reaction. Considering the high number of experiments required due to the different chemical and instrumental variables to be taken account and their adequate compatibility to obtain maximum sensitivity, the methodology offers a rigorous study of the main effects and interactions, achieving a reduction of experimental work.     

Electroreductive polymerization of phenylmethyldichlorosilane in a divided cell using a neutral membrane

Electrochemical formation of poly(phenylmethylsilane) in a divided cell containing a Teflon® neutral membrane was studied. The electrolysis of dichlorosilanes was carried out in a solution containing tetrahydrofuran + hexamethylphosphoramide as the solvent, tetrabutylammonium perchlorate as the support electrolyte and stainless steel as the cathode, with Pt and graphite as the resistant anodes or stainless steel as the sacrificial anode. Polysilanes with a number-average molecular weight in the range from 2,600 to 130,000 g/mol were obtained, depending on the conditions used.     

Synthesis of 2,3,8,9-tetramethoxy-11-phenyl-5,6-dihydrodibenz[2,3;7,8]indolizine

2,3,8,9-Tetramethoxy-11-phenyldibenz[2,3;7,8]indolizine was obtainedinhighyieldfrom (6,7-dimethoxyisoquinolin-1-yl)-(3,4-dimethylphenyl)phenylcarbinol by cyclization in the presence of formic acid. The behavior of (6,7-dimethoxyisoquinolin-1-yl)-(3,4-dimethoxyphenyl)methylcarbinol and (6,7-dimethoxyisoquinolin-1-yl-(3,4-dimethoxyphenyl)carbinol was studied under these same conditions. 2,3,7,8-Tetramethoxy-11-phenyl-5,6-dihydrodibenz[2,3;7,8]indolizine was obtained by hydrogenation on rhenium heptasulfide.Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 9, pp. 1233–1238, September, 1993.     

New butenolides in plantlets of Virola surinamensis (Myristicaceae)

A phytochemical investigation in plantlets of the Brazilian medicinal tree Virola surinamensis resulted in the isolation and structural determination of four new compounds: 3-hydroxy-4-methyl-2-(11'-piperonyl-n-undecyl)-butenolide; 3-hydroxy-4-methyl-2-(7'-piperonyl-n-heptyl)-butanolide; 9'-(3,4-methylenedioxy-phenyl)-nonanoic acid and 13'-(3,4-methylene-dioxyphenyl)-tridecanoic acid. Thirteen compounds previously isolated from seeds and adult plants were also reported.