K_2(9~1∑~+_g)高位电子态与H_2碰撞中H_2的能量分布

光学-光学双共振激发K2到91∑+g高位态,研究了K2(91∑+g)与H2的电子-振转碰撞能量转移。利用相干反斯托克斯(CARS)光谱技术探测H2的振转态分布,扫描CARS谱表明H2在(1,1)、(2,1)、(2,2)、(3,1)、(3,2)、(3,3)和(3,5)能级上有布居。由时间分辨CARS轮廓得到H2各振转能级上粒子数之比,得到H2的平均振动能和平均转动能分别为9063cm-1和388cm-1。从91∑+g→11∑+u、11∑+u→11∑+g、33∏g→13∑+u跃迁的时间分辨激光感应荧光(LIF)强度得到它们的自发辐射率和碰撞转移率。在H2压强为3×103Pa时,K2(91∑+g)与H2的碰撞转移能为16930cm-1。H2的平均振转能占平均转移能的56%。     

Preparation of BA/ST/AM nano particles by ultrasonic emulsifier-free emulsion polymerization

A kind of nano particle of butyl acrylate (BA)/styrene (ST)/acrylamide (AM) was prepared through a new method that was ultrasonic emulsifier-free emulsion polymerization, which was a kind of environmental protection and economical method. And no any volatile organic solvent (VOC), emulsifier and initiator were used in this method. Only water was used as solvent. The effects of sonic intensity, sonic time, inorganic salt content, N2 flow velocity, etc. on monomer conversion were studied. TEM photographs showed that its particles size was about 80 nm, which was less than particles size (about 140 nm) through conventional emulsifier-free emulsion polymerization method. The FTIR spectrum showed that after extracted by water for 48 h, CHCl3 for 48 h and THF for 48 hr, respectively, the sample obtained by this way was a ternary copolymer of BA, ST and AM, but not a blend of poly(butyl acrylate), polystyrene and polyacrylamide.     

Experiments and analysis of thin tungsten slice and W/Cu brazing for primary collimator scraper in CSNS/RCS

According to the requirements for the beam collimation system of the rapid cycling synchrotron(RCS)of China Spallation Neutron Source(CSNS),the main structure of a scraper of primary collimator is made by W/Cu brazing,in which the thickness of tungsten slice is 0.17 mm.In order to get the best mechanical properties,the brazing temperature is suggested to be controlled under the recrystallization temperature of tungsten,while the recrystallization temperature is affected directly by the thickness of tungsten.Because of little research and application on the brazing of thin tungsten slice of 0.17 mm and copper,tensile tests are done to get the mechanical properties of tungsten slices which experience different brazing temperatures.In keeping the inner relationships between the mechanical properties and temperature,another experiment is done by using SEM to scan the microstructures including the size and distribution of crystals.Finally we determine the recrystallization temperature of tungsten slice of 0.17 mm,and get the best parameters of W/Cu brazing for scrapers of primary collimator in CSNS/RCS.     

Local chemical distribution and electronic structure of Ge1−xTx DMS single crystals (T=Cr,Mn, Fe)

The spatial concentration distribution and local electronic structure of ferromagnetic Ge_1−xT_x (T=Cr, Mn, Fe) DMS single crystals have been investigated by using scanning photoelectron microscopy (SPEM), X-ray absorption spectroscopy (XAS), and photoemission spectroscopy (PES). It is found that doped T ions in Ge_1−xT_x crystals are chemically phase-separated, suggesting that the observed ferromagnetism arises from the phase-separated T-rich phases in Ge_1−xT_x.     

Observation of two resonant structures in e+ e- -->pi+ pi- psi(2S) via initial-state radiation at Belle

The cross section for e+ e- --> pi+ pi- psi(2S) between threshold and sqrt[s]=5.5 GeV is measured using 673 fb(-1) of data on and off the Upsilon(4S) resonance collected with the Belle detector at KEKB. Two resonant structures are observed in the pi+ pi- psi(2S) invariant-mass distribution, one at 4361 +/- 9 +/- 9 MeV/c2 with a width of 74 +/- 15 +/- 10 MeV/c2, and another at 4664 +/- 11 +/- 5 MeV/c2 with a width of 48 +/- 15 +/- 3 MeV/c2, if the mass spectrum is parametrized with the coherent sum of two Breit-Wigner functions. These values do not match those of any of the known charmonium states.     

Study of decay mechanisms in B--->Lambdac+ppi- decays and observation of low-mass structure in the Lambdac+p system

Using a sample of 152 x 10(6) BB pairs accumulated with the Belle detector at the KEKB e+e- collider, we study the decay mechanism of three-body charmed decay B- --> Lambdac+ ppi-. The intermediate two-body decay B--->Sigmac (2455)0 p is observed for the first time with a branching fraction of (3.7 +/- 0.7 +/- 0.4 +/- 1.0) x 10(-5) and a statistical significance of 8.4sigma. We also observe a low-mass enhancement in the (Lambdac+p) system, which can be parametrized as a Breit-Wigner function with a mass of (3.35(-0.02)(+0.01) +/-0.02) GeV/c2 and a width of (0.07(-0.03)(+0.04) +/-0.04) GeV/c2. We measure its branching fraction to be (3.9(-0.7)(+0.8) +/- 0.4 +/- 1.0) x 10(-5) with a statistical significance of 6.2sigma. The errors are statistical, systematic, and that of the Lambdac+-->pK- pi+ decay branching fraction.     

Sidewall-insert compound based on ZnO-treated aramid pulp fibers for run-flat tires

Abstract

To improve the endurance performance of run-flat tires by preventing the sidewall from folding at zero air pressure, a master batch of natural rubber and ZnO-treated aramid pulp (AP) is applied to the rubber sidewall-insert-layer compound. The mechanical, viscoelastic, and fatigue properties of the compounds are investigated by varying the AP content, and the endurance performance of actual run-flat tires is assessed. The results indicate that the mechanical properties are improved and the hysteresis is reduced as the AP content increased. The overall trend of the endurance times of the run-flat tires is consistent with the results of the DeMattia tests, constant-strain fatigue tests, and high-temperature tensile tests. The run-flat endurance time of the tire containing one part per hundred rubber (phr) of AP is superior to that of the tire containing 3 phr of AP because of the enhanced dispersion of the AP fibers.     

利用混沌信号幅值实现混沌同步

构造了一个三维混沌系统, 简要分析了该混沌系统的平衡点性质、混沌吸引子相图和Lyapunov指数等特性. 在此基础上, 利用反馈同步思想设计了一种利用混沌信号部分信息实现混沌同步的方法, 完成了三维混沌系统的同步. 该方法仅利用混沌信号幅值信息即可实现两个混沌系统的同步, 其同步建立与混沌信号的极性无关, 此特性可有效提高混沌通信质量. 通过分析系统的条件Lyapunov指数证实该方法的有效性, 数值仿真表明该方法与利用混沌信号全部信息的线性反馈同步法相比, 同步建立时间基本相同.