电子束产生大尺度等离子体过程的数值模拟研究

建立了一个四组分一维混合模型，对电子束注入大气产生大尺度等离子体的过程进行了数值模拟.结果表明了能量为140keV、流强为50mA/cm²的注入电子束，可以产生线度为0.5m，密度为10¹²cm^-3量级的大气环境下等离子体.电子束所伴随的空间电荷效应由于等离子体的产生会很快消失，不影响后续的等离子体产生过程.电子束注入流强主要影响产生等离子体的密度，而电子束能量则同时影响其空间线度和密度. 关键词： 电子束 碰撞 电离     

V3+:YAG晶体的生长、色心与光谱性能研究

采用石墨电阻加热的温梯法生长了V:YAG晶体,晶体的不同部位呈现两种不同的颜色:浅绿色和黄褐色.通过对比分析不同颜色V:YAG晶体的室温吸收光谱,推断出石墨发热体高温下扩散出来的C可以起到还原作用,提高晶体中V3+tetra离子的浓度,同时诱导了F心的形成.在1300℃下,对不同颜色的V:YAG晶体进行真空退火处理,发现处于八面体格位中的V3+离子在热激发作用下与近邻的四面体格位Al3+离子存在置换反应,由此产生一定浓度的四面体格位V3+离子.同时,F心在退火过程中被完全消除,释放出来的自由电子被高价态的V离子俘获,可以进一步提高晶体中四面体格位V3+离子的浓度.     

FeS2多晶薄膜电子结构的实验研究

用磁控溅射方法制各纯Fe薄膜,并硫化合成FeS2.采用同步辐射X射线近边吸收谱与X射线光电子能谱研究了薄膜的电子结构.结果表明,合成的FeS2薄膜,在费米能级附近,有较强的Fe 3d态密度存在,同时,在价带谱中2-10eV处有强度较大的S 3p态密度存在;Fe的3d轨道在八面体配位场作用下分别为t2g和eg轨道,实验中由Fe的吸收谱计算得到两分裂能级之差为2.1eV;实验测得FeS2价带结构中导带宽度约为2.4eV,导带上方仍存在第二能隙,其宽度约为2.8eV.     

SiOx纳米管的制备及其发光特性

以液态金属镓为媒介,利用热蒸发法合成大量非晶SiOx纳米管,这些纳米管管径均匀分布,平均约80 nm,长度大于10μm,且管内外径比例较小．分析发现,在实验过程中,熔入金属镓液滴中的硅元素和氧元素结合并从液滴的表面饱和析出,形成以镓为中心的非晶SiOx纳米管状结构．在室温中,利用260 nm的激发光源激发SiOx纳米管,发现在蓝光波段附近发出强而稳定的PL谱线,这可能与样品中的氧缺陷和空位有关．     

Nd0.5Ca0.5Mn1-xAlxO3 (x=0,0.03)体系中电荷有序态的超声研究

系统研究了Nd0．5Ca0．5Mn1-xAlxO3(x=0,0．03)单相多晶样品在低温下的电磁性质和超声特性．电阻和磁化率测量表明,Nd0．5Ca0.5O3体系在TCO-257 K处发生了电荷有序相变．超声声速从室温开始随着温度的降低逐渐减小,并在TCO附近达到最小,之后,随着温度的进一步降低,声速急刷增加,同时伴随着一个尖锐的超声衰减峰出现.TCO附近的超声异常表明体系中存在着强烈的电-声子相互作用,该电-声子耦合来源于Mn3 的Jahn-Teller效应．在低温下,出现了另一个超声衰减峰,它的出现归结为反铁磁相与顺磁相之间的相分离现象.随着Al在Mn位的掺入,超声声速的最低点和衰减峰向低温移动,表明体系中的电荷有序态和反铁磁相均被部分抑制,     

Asymmetric synthesis of homo-apioneplanocin A from d-ribose

Homo-apioneplanocin A was efficiently synthesized via stereoselective hydroxymethylation, regio- and chemoselective hydroboration, and chemoselective oxidation as key steps from d-ribose.     

Novel route to 5-position vinyl derivatives of thiolactomycin: Olefination vs. deformylation

Vinyl and diene derivatives of thiolactomycin have been prepared via Horner-Wadsworth-Emmons olefination from protected 5-formyl-3,5-dimethylthiotetronic acid. Several 4-position protecting groups and a variety of phosphonates were evaluated, with MOM protection and β-ketophosphonates yielding the highest ratio of the desired product to deformylated product.     

自制金割效应物理摆的研究性实验

金割效应物理摆是将数学中的优选法与物理实验中的复摆结合起来并用计算机处理数据的自制教学仪器.把金割效应物理摆作为研究性实验进行开设,更有利于培养学生的开拓精神和创新能力.     

Fuzzy convex sets in median algebras

The fuzzification of convex sets in median algebras is considered, and some of their properties are investigated. A characterization of finite valued fuzzy convex set is given.     

Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.