Longer-range distances by spinning-angle-encoding solid-state NMR spectroscopy

A new spinning-angle-encoding spin-echo solid-state NMR approach is used to accurately determine the dipolar coupling corresponding to a C-C distance over 4 ? in a fully labelled dipeptide. The dipolar coupling dependent spin-echo modulation was recorded off magic angle, switching back to the magic angle for the acquisition of the free-induction decay, so as to obtain optimum sensitivity. The retention of both ideal resolution and long-range distance sensitivity was achieved by redesigning a 600 MHz HX MAS NMR probe to provide fast angle switching during the NMR experiment: for 1.8 mm rotors, angle changes of up to ～5° in ～10 ms were achieved at 12 kHz MAS. A new experimental design that combines a reference and a dipolar-modulated experiment and a master-curve approach to data interpretation is presented.     

Miniaturization of a panel of high-throughput yeast-cell-based nuclear receptor assays in 384- and 1536-well microplates

A panel of luminescent Saccharomyces cerevisiae cell-based nuclear receptor assays, consisting of human estrogen receptors α and β, androgen receptor, and aryl hydrocarbon receptor, was miniaturized from the standard 96-well microplate format to high-throughput 384- and 1536-well microplate formats. In these assays, firefly luciferase lacking the peroxisome targeting sequence was used as a reporter and D-luciferin substrate was pre-mixed with the yeast cells before the incubation step, eliminating cell lysis and substrate addition steps, and allowing multiple readings at any desired time point. All of the assays were highly functional in the 384-well format, and most functioned well in the 1536-well format. The detection limit of the estrogen receptor α assay was even lower in the miniaturized microplate formats than in the original 96-well format. The panel of yeast-cell-based nuclear receptor assays can be used for high-throughput chemical testing and environmental monitoring of potential endocrine-disrupting activity of compounds and samples.     

Limitations of the permeability-limited compartment model in estimating vascular permeability and interstitial volume fraction in DCE-MRI

Dynamic contrast-enhanced magnetic resonance imaging commonly uses compartment models to estimate tissue parameters in general and perfusion parameters in particular. Compartment models assume a homogeneous distribution of the injected tracer throughout the compartment volume. Since tracer distribution within a compartment cannot be assessed, the parameters obtained by means of a compartment model might differ from the actual physical values.This work systematically examines the widely used permeability-surface-limited one-compartment model to determine the reliability of the parameters obtained by comparing them with their actual values. A computer simulation was used to model spatial tracer distribution within the interstitial volume using diffusion of contrast agent in tissue. Vascular parameters were varied as well as tissue parameters. The vascular parameters used were capillary radius (4 and 12 μm), capillary permeability (from 0.03 to 3.3 μm/s) and intercapillary distances from 30 to 300 μm. The tissue parameters used were tortuosity (λ), porosity (α) and interstitial volume fraction (v_e).Our results suggest that the permeability-surface-limited compartment model generally underestimates capillary permeability for capillaries with a radius of 4 μm by factors from ≈0.03 for α=0.04, to ≈ 0.1 for α=0.2, to ≈ 0.5 for α=1.0. An overestimation of actual capillary permeability for capillaries with a radius of 12 μm by a factor of ≥1.3 was found for α=1.0, while α=0.2 yielded an underestimation by a factor of ≈0.3 and α=0.04 by a factor of ≈ 0.03. The interstitial volume fraction, v_e, obtained by the compartment model differed with increasing intercapillary distances and for low vessel permeability, whereas v_e was found to be estimated approximately accurately for P=0.3 μm/s and P=3.3 μm/s for vessel distances <100 μm.     

A sensitive method for determination of allergenic fragrance terpene hydroperoxides using liquid chromatography coupled with tandem mass spectrometry

Different compositions of monoterpenes are utilized for their pleasant scent in cosmetics and perfumes. However, the most commonly used fragrance terpenes easily oxidize upon contact with air, forming strongly skin‐sensitizing hydroperoxides. Due to their thermolability and low UV absorbance, detection methods for hydroperoxides are scarce. For the first time, a simple and sensitive method using LC/ESI‐MS/MS was developed to quantitatively determine hydroperoxides from the common fragrance compounds linalool, linalyl acetate, and limonene. The method was applied to autoxidized petitgrain oil and sweet orange oil. A separation was accomplished using a C₃ column. The method LOD for the investigated hydroperoxides in the essential oils was below 0.3 μg/mL, corresponding to 0.3 ppm. For prevention purposes and according to EU regulations, concentrations in cosmetics exceeding 100 ppm in “rinse‐off” and 10 ppm in “stay‐on” products of linalool and limonene must be labeled. However, the products may still contain allergens, such as hydroperoxides, formed by oxidative degradation of their parent terpenes. The sensitivity and selectivity of the presented LC/MS/MS method enables detection of hydroperoxides from the fragrance terpenes linalool, linalyl acetate, and limonene. However, for routine measurements, the method requires further validation.     

Total Synthesis of (18S)‐ and (18R)‐Homolargazole by Rhodium‐Catalyzed Hydrocarboxylation

Homolargazole derivatives, in which the macrocycle of natural largazole is extended by one methylene group, were prepared by the recently developed rhodium‐catalyzed hydrocarboxylation reaction onto allenes. This strategy gives access to both the (18S)‐ and (18R)‐stereoisomers in high stereoselectivity under ligand control.     

Unexpected Formation of a [4]Radialene and Dendralenes by Addition of Tetracyanoethylene to a Tetraaryl[5]cumulene

The use of cumulenes in synthetic transformations offers the possibility to form structurally interesting and potentially useful conjugated molecules. The cycloaddition reaction of a tetraaryl[5]cumulene with the electron‐deficient olefin tetracyanoethylene affords unusual products, including functionalized dendralenes and alkylidene cyclobutanes, as well as a symmetric [4]radialene that shows unique solvatochromism, with λ_max values approaching the near‐IR region. These carbon‐rich products have been investigated spectroscopically and by X‐ray crystallographic analysis (five structures). The cycloaddition reaction sequence has also been explored by mechanistic and theoretical studies. The obtained results clearly demonstrate the potential of [5]cumulenes to serve as precursors for unprecedented conjugated structures.     

Conditions for sample preparation and quantitative HPLC/MS-MS analysis of bulky adducts to serum albumin with diolepoxides of polycyclic aromatic hydrocarbons as models

Stable adducts to serum albumin (SA) from electrophilic and genotoxic compounds/metabolites can be used as biomarkers for quantification of the corresponding in vivo dose. In the present study, conditions for specific analysis of stable adducts to SA formed from carcinogenic polycyclic aromatic hydrocarbons (PAH) were evaluated in order to achieve a sensitive and reproducible quantitative method. Bulky adducts from diolepoxides (DE) of PAH, primarily DE of benzo[a]pyrene (BPDE) and also DE of dibenzo[a,l]pyrene (DBPDE) and dibenzo[a,h]anthracene (DBADE), were used as model compounds. The alkylated peptides obtained after enzymatic hydrolysis of human SA modified with the different PAHDE were principally PAHDE-His-Pro, PAHDE-His-Pro-Tyr and PAHDE-Lys. Alkaline hydrolysis under optimised conditions gave the BPDE-His as the single analyte of alkylated His, but also indicated degradation of this adduct. It was not possible to obtain the BPDE-His as one analyte from BPDE-alkylated SA through modifications of the enzymatic hydrolysis. The BPDE-His adduct was shown to be stable during the weak acidic conditions used in the isolation of SA. Enrichment by HPLC or SPE, but not butanol extraction, gave good recovery, using Protein LoBind tubes. A simple internal standard (IS) approach using SA modified with other PAHDE as IS was shown to be applicable. A robust analytical procedure based on digestion with pronase, enrichment by HPLC or SPE, and analysis with HPLC/MS-MS electrospray ionisation was achieved. A good reproducibility (coefficient of variation (CV) 11 %) was obtained, and the achieved limit of detection for the studied PAHDE, using standard instrumentation, was approximately 1 fmol adduct/mg SA analysing extract from 5 mg SA.