Determination of zinc by flow injection with fluorimetric detection in a micellar medium

A room-temperature flow injection spectrofluorimetric method is presented for the determination of Zn(II), based on the use of salicylaldehyde thiocarbohydrazone in the presence of Triton X-100 and sodium acetate-acetic acid buffer. Various physical and chemical variables affecting the reaction in the flow system were evaluated. The proposed method is very selective. The calibration graph is linear over the range 10-1000 ng/ml, with a detection limit of 5 ng/ml and a relative standard deviation at the 50 ng/ml level of 1.8 %. The method was successfully applied to the determination of Zn(II) in drinking waters and biological samples.     

Supercritical fluid extraction of polycyclic aromatic hydrocarbons from liver samples and determination by HPLC-FL

An extraction/clean-up procedure by SFE was developed for isolating PAHs from liver samples for subsequent HPLC-FL determination of ten PAHs in the enriched extract. Recoveries (90-115%) and RSD % (< or =7.7) were satisfactory. When applied to 11 samples of bird of prey (Tyto alba) protected species and classified of special interest, from the Galicia (Northwest to Spain), benzo[ghi]perylene and indeno[1,2,3-cd]pyrene were undetectable; chrysene and benzo[a]pyrene are only detected in one sample; benzo[a]anthracene and benzo[k]fluoranthene are only quantified in one sample and benzo[b]fluoranthene in two samples. The other PAHs, anthracene, fluoranthene and pyrene are present in almost all the samples.     

Reactivity of pyrrole pigments. Part 9 MINDO/3 calculations on dipyrrolic partial models of bile pigments

The applicability of the MINDO/3 method is evaluated for calculations on dipyrrolic partial structures of bile pigments. It is shown that this method cannot be used for an accurate conformational analysis. However, when applying the frontier orbital model for reactivity parameters, a good picture of the HOMO and the LUMO distribution can be obtained in this type of molecules.

---

Reaktivität von Pyrrolpigmenten, 9. Mitt. MINDO/3-Rechnungen von dipyrrolischen Partialmodellen von Gallenpigmenten

Zusammenfassung Es werden die Einsatzmöglichkeiten von MINDO/3 für den Fall dipyrrolischer Partialstrukturen der Gallenpigmente aufgezeigt. Die Methode ist für eine genaue Konformationsanalyse nicht geeignet. Unter Verwendung der Reaktionsparameter des Frontier-Orbital-Modells läßt sich jedoch ein gutes Bild der HOMO- und LUMO-Verteilung für diesen Verbindungstyp gewinnen.

     

Comparison of a radiation counting method and ICP-MS for the determination of99Tc in environmental samples

Results of⁹⁹Tc measurements between radiation and non-radiation counting methods were compared using four radiation sources for which⁹⁹Tc has been previously determined with a gas-flow proportional counter or a GM counter. Each⁹⁹Tc source consisted of a stainless steel planchet bound by mylar films. Seaweeds collected from the Irish Sea were analyzed and⁹⁹Tc was electroplated on the planchet. The⁹⁹Tc in each sample was separated and measured again by inductively coupled plasma mass spectrometry (ICP-MS). Tc was continuously removed from each sample with 2M HNO₃ and 2M NaOH. After the solution containing Tc was adjusted to 0.1M HNO₃, Tc was extracted on a novel extraction chromatographic resin to separate it from Ru. The total recoveries for Tc on the planchet samples were almost the same with an average of 91%. The results of⁹⁹Tc measurements by both radiation and non-radiation counting methods agreed well with each other.     

HPLC separation of hydrogenated derivatives of buckminsterfullerene

Summary The effect of composition and flow rate of the mobile phase on the HPLC separation of hydrogenated buckminsterfullerene (C₆₀H_n n=2–38) was investigated on BuckySep column. Toluene was used as the basic solvent and hexane, heptane, cyclohexane, THF, acetonitrile, acetone, ethanol and 2-propanol as co-solvents. The fraction of co-solvents was varied 10–80%, and the flow rate 1–0.1 mL min⁻¹. Toluene-acetonitrile 65∶35 and toluene-acetone 50∶50 provided the best separation. Under the best conditions complete separation of C₆₀H₂ and almost complete separation of the four most abundant isomers of C₆₀H₄ were achieved. Separation of derivatives with higher hydrogen content was very poor. Presented at: Balaton Symposium on High-Performance Separation Methods, Siófok, Hungary, September 3–5, 1997     

Insertion reactions of [M(SR)3(PMe2Ph)2] with CS2 (M = Ru, Os; R = C6F4H-4, C6F5). X-ray structures of [Ru(S2CSC6F4H-4)2(PMe2Ph)2], trans-thiolates [M(SR)2(S2CSR)(PMe2Ph)2] (M = Ru; R = C6F5 and M = Os; R = C6F4H-4), and trans-thiolate-phosphine [Os(SC6F5)2(S2CSC6F5)(PMe2Ph)2

Reactions of [M(SR)(3)(PMe(2)Ph)(2)] (M = Ru, Os; R = C(6)F(4)H-4, C(6)F(5)) with CS(2) in acetone afford [Ru(S(2)CSR)(2)(PMe(2)Ph)(2)] (R = C(6)F(4)H-4, 1; C(6)F(5), 3) and trans-thiolates [Ru(SR)(2)(S(2)CSR)(PMe(2)Ph)(2)] (R = C(6)F(4)H-4, 2; C(6)F(5), 4) or the isomers trans-thiolates [Os(SR)(2)(S(2)CSR)(PMe(2)Ph)(2)] (R = C(6)F(4)H-4, 5; C(6)F(5), 7) and trans-thiolate-phosphine [Os(SR)(2)(S(2)CSR)(PMe(2)Ph)(2)] (R = C(6)F(4)H-4, 6; C(6)F(5), 8) through processes involving CS(2) insertion into M-SR bonds. The ruthenium(III) complexes [Ru(SR)(3)(PMe(2)Ph)(2)] react with CS(2) to give the diamagnetic thiolate-thioxanthato ruthenium(II) and the paramagnetic ruthenium(III) complexes while osmium(III) complexes [Os(SR)(3)(PMe(2)Ph)(2)] react to give the paramagnetic thiolate-thioxanthato osmium(III) isomers. The single-crystal X-ray diffraction studies of 1, 4, 5, and 8 show distorted octahedral structures. (31)P [(1)H] and (19)F NMR studies show that the solution structures of 1 and 3 are consistent with the solid-state structure of 1.     

Photochemical syn-anti isomerization reactions in N2-hydroxyisocytosines--an experimental matrix isolation and theoretical study

N2-hydroxyisocytosine and 1-methyl-N2-hydroxyisocytosine were studied using a matrix isolation technique combined with infrared absorption spectroscopy. For N2-hydroxyisocytosine isolated in an Ar matrix (at 10 K), two imino-oxo isomers, one with the hydroxyimino =N-OH group directed toward the N1-H group (the form called further anti) and the second with the =N-OH group directed toward N3-H (syn), were observed in the ratio 1.4:1. The syn isomer is converted totally to the anti form after UV (lambda > 295 nm) irradiation of the matrix. A small amount of the N(3)H-hydroxy-amino tautomer of N2-hydroxyisocytosine was also detected in the matrix. This form did not react photochemically. For 1-methyl-N2-hydroxyisocytosine, only the syn form of the imino-oxo tautomer was observed after deposition of the matrix. UV (lambda > 295 nm) irradiation induced a photoreaction converting this isomer into the anti form. After 15% of the starting material had been converted into the product, a photostationary state was achieved, and no further progress of the reaction was observed. Subsequent UV irradiation (lambda > 335 nm) caused a back reaction, leading to a disappearance of the anti form and to the recovery of the initial syn isomer. All isomers were identified by comparing their experimental IR spectra with the spectra theoretically calculated at the DFT(B3LYP)/6-31G(d,p) level, where DFT is the density functional theory. Good agreement between the observed and predicted patterns of the spectral lines allowed for reliable identification. The experimental IR spectra were interpreted and discussed. The relative energies of the 12 isomers of N2-hydroxyisocytosine were calculated at the MP2/6-31G(d,p) and MP4//MP2/6-31G(d,p) levels. For six isomers of 1-methyl-N2-hydroxyisocytosine, the calculations were carried out at the MP2/6-31G(d,p) level. The anti form of the imino-oxo tautomer of N-hydroxyisocytosine and the syn form of the imino-oxo tautomer of 1-methyl-N2-hydroxyisocytosine were predicted to be the most stable.     

Diverse evolution of [[Ph(2)P(CH(2))(n)PPh(2)]Pt(mu-S)(2)Pt[Ph(2)P(CH(2))(n)PPh(2)]] (n = 2, 3) metalloligands in CH(2)Cl(2)

The nucleophilicity of the [Pt(2)S(2)] core in [[Ph(2)P(CH(2))(n)PPh(2)]Pt(mu-S)(2)Pt[Ph(2)P(CH(2))(n)PPh(2)]] (n = 3, dppp (1); n = 2, dppe (2)) metalloligands toward the CH(2)Cl(2) solvent has been thoroughly studied. Complex 1, which has been obtained and characterized by X-ray diffraction, is structurally related to 2 and consists of dinuclear molecules with a hinged [Pt(2)S(2)] central ring. The reaction of 1 and 2 with CH(2)Cl(2) has been followed by means of (31)P, (1)H, and (13)C NMR, electrospray ionization mass spectrometry, and X-ray data. Although both reactions proceed at different rates, the first steps are common and lead to a mixture of the corresponding mononuclear complexes [Pt[Ph(2)P(CH(2))(n)PPh(2)](S(2)CH(2))], n = 3 (7), 2 (8), and [Pt[Ph(2)P(CH(2))(n)PPh(2)]Cl(2)], n = 3 (9), 2 (10). Theoretical calculations give support to the proposed pathway for the disintegration process of the [Pt(2)S(2)] ring. Only in the case of 1, the reaction proceeds further yielding [Pt(2)(dppp)(2)[mu-(SCH(2)SCH(2)S)-S,S']]Cl(2) (11). To confirm the sequence of the reactions leading from 1 and 2 to the final products 9 and 11 or 8 and 10, respectively, complexes 7, 8, and 11 have been synthesized and structurally characterized. Additional experiments have allowed elucidation of the reaction mechanism involved from 7 to 11, and thus, the origin of the CH(2) groups that participate in the expansion of the (SCH(2)S)(2-) ligand in 7 to afford the bridging (SCH(2)SCH(2)S)(2-) ligand in 11 has been established. The X-ray structure of 11 is totally unprecedented and consists of a hinged [(dppp)Pt(mu-S)(2)Pt(dppp)] core capped by a CH(2)SCH(2) fragment.     

An electropolymerized aniline-based fiber coating for solid phase microextraction of phenols from water

An aniline-based polymer was electrochemically prepared and applied as a new fiber coating for solid phase microextraction (SPME) of some priority phenols from water samples. The polyaniline (PANI) film was directly electrodeposited on the platinum wire surface in sulfuric acid solution using cyclic voltammetry (CV) technique. The efficiency of new coating was investigated using a laboratory-made SPME device and gas chromatography with flame ionization detection for the extraction of some phenols from the headspace of aqueous samples. The scanning electron microscopy (SEM) images showed the homogeneity and the porous surface structure of the film. The results obtained proved the ability of this polymer as a suitable SPME fiber coating for trapping the selected phenols. Influential parameters affecting the extraction process were optimized and an extraction time of 50 min at 50 °C gave maximum efficiency, when the aqueous sample was saturated with NaCl and adjusted at pH 2. This new coating can be prepared easily in a reproducible manner and it is rather inexpensive and stable against most of organic solvents. The PANI thickness can be precisely controlled by the number of CV cycles. At the optimum conditions, the R.S.D. for a double distilled water spiked with phenol and chlorophenols at ppb level were 4.8-17% (n = 3) and detection limits for the studied compounds were between 0.69 and 3.7 ng ml⁻¹, except for phenol and 4-chlorophenol. The optimized method was successfully applied to some real-life water samples.     

Copper-catalyzed enantioselective conjugate addition of grignard reagents to acyclic enones

A highly enantioselective Cu-catalyzed addition of Grignard reagents to acyclic aliphatic enones is described. In the presence of 5 mol % of CuBr.SMe2 and 6 mol % of JosiPhos diphosphine aliphatic enones react with Grignard reagents to provide beta-substituted linear ketones with high yields, regio-, and enantioselectivities.