Determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel by high performance liquid chromatography and photodiode-array detection

An oxidation method (sulfone method) for the determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel is presented. The aromatic fraction of a diesel fuel, isolated by solid phase extraction, is oxidized under controlled conditions with hydrogen peroxide. The oxidation products, mainly methylated dibenzosulfone, are determined and quantified directly, without further clean-up, by HPLC with photodiode-array detection.     

Optisch aktive übergangsmetall-komplexe : XXXIX. Stereospezifische phenyl-addition an das C5H5(CO)2 Mo-Pyridin-Carbaldimin-Kation

The addition of C₆H₅^? to the NN' ligand (NN' = Schiff base of pyridine carbaldehyde-(2) and (S)-(—)-α-phenylethylamine) in [C₅H₅ Mo(CO)₂ NN'] PF₆ occurs stereospecific from the side opposite to the C₅H₅-ring.     

Methode calorimetrique de mesure des enthalpies de formation des alliages liquides a forte tension de vapeur

The heat effects corresponding to the dissolution of solid PbSe in liquid Pb-Se alloys starting from pure Pb were measured with a direct reaction calorimeter. The partial enthalpy of formation of PbSe in the melt and the integral enthalpy of formation of the Pb-PbSe system in the liquid state referred the liquid Pb and PbSe were deduced. Then, from a very simple change of reference state, and in the knowledge of the enthalpy of PbSe, the integral enthalpy of formation of Pb-Se liquid alloys with reference to pure liquid components could be derived. The results agreed very well with those obtained previously on the dissolution of Se in Pb. The method used can be applied whenever the component to be added to the bath has a high vapor pressure.

---

Zusammenfassung Die bei der Überführung von festem PbSe in flüssige Pb-Se-Legierungen auftretenden Wärmeeffekte wurden mittels direkter Reaktionskalorimetrie bestimmt. Die auf flüssiges Pb und PbSe bezogene partielle Bildungsenthalpie des Pb-PbSe-Systems im flüssigen Zustand wurde ermittelt. Durch eine geringfügige Veränderung des Referenzzustandes konnte bei Kenntnis der Enthalpie von PbSe die integrale Bildungsenthalpie von flüssigen Pb-Se-Legierungen in Bezug auf die reinen Komponenten abgeleitet werden. Die Ergebnisse stimmen gut mit denen überein, die früher für die Auflösung von Se in Pb erhalten wurden. Die Methode ist anwendbar, wenn dem Bade zuzugebende Komponenten einen hohen Dampfdruck haben.

---

Pb-Se Pb-Se, . Pb-Se Pb-PbSe Pb Pb-Se. PbSe, Pb-Se . , . , .

     

Fluorescence study of the sol-gel process in hybrid precursors: evidence of concentration fluctuations at the local scale

Hybrid sol-gel materials have been prepared by hydrolytic polycondensation of an alkoxysilane. The sol-gel process of methacryloxypropyltrimethoxysilane (MAPTMS) has been followed by fluorescence spectroscopy with 2-naphthol as a probe. The experimental results showed that this photoprobe was dramatically sensitive to the microenvironment polarity. Spectroscopic studies revealed fluctuations of the maximum emission intensity and wavelength as a function of time. These fluctuations were attributed to the amphiphilic behavior of the hydrolyzed precursor. The maximum emission wavelength of the probe corresponding to its protonated form was higher than in pure water. All the results suggest that the presence of water molecules, tightly bonded to the polar head of the silanols, increased locally the sol polarity and induced a red-shifted emission. Fluorescence spectroscopy emphasized the reversibility of monomeric silanol aggregates and the changes in hydroxy group number of the silica network during the sol maturation. The behavior of this system upon shaking confirmed this statement.     

Direct Identification of the Carbon Skeleton of Organic Compounds using Double Quantum Coherence 13C-NMR Spectroscopy. The INADEQUATE Pulse Sequence

NMR spectroscopy plays an important part in the determination of the structures of organic compounds. The parameters of importance here are the chemical shifts of the ¹H and ¹³C nuclei and the spin-spin interactions both between ¹H nuclei and between ¹H and ¹³C nuclei. Couplings between ¹³C nuclei were almost completely neglected until a few years ago, since they were extremely difficult to observe because of the low natural abundance of ¹³C. However, it is these couplings which afford information directly on the carbon-carbon connectivities in the molecule. It is now possible to use a special NMR pulse sequence to make these couplings more readily visible: the result of using this sequence is a ¹³C-NMR spectrum from which the carbon skeleton concerned can be directly read off. Two-dimensional spectra in particular are very easy to evaluate. The pulse sequence involved, which bears the somewhat puzzling name INADEQUATE, produces double-quantum coherences from which the NMR signals of the coupled carbon nuclei can be obtained. In this article the principle of double-quantum coherence is described and a number of examples for the application of the INADEQUATE pulse sequences to problems in synthetic organic chemistry, biosynthesis and natural products chemistry are presented; in addition, the possibility of applying the INADEQUATE method to other nuclei is considered.     

Formation of protonic defects in perovskite-type oxides with redox-active acceptors: case study on Fe-doped SrTiO(3)

The thermodynamics of water incorporation into Fe-doped SrTiO(3) was investigated by thermogravimetric measurements. Changes in valence states of redox-active dopant ions (Fe(3+)/Fe(4+)) with water vapor pressure were taken into account in the defect chemical analysis. The proton solubility was significantly enhanced by the presence of the redox centers. The hydration enthalpies and entropies were -60 kJ mol(-1) and -122 J mol(-1) K(-1). The defect chemical model was applied to describe the water vapor dependence of the electrical conductivity in mixed ionic and electronic conducting Fe-doped SrTiO(3) single crystals.     

Bestimmung von Wasser in Dichloressigsäure

Water concentrations in dichloroacetic acid in the range of 0<C <1 % (C = percent by weight) can be determined directly by photometry at 1425 nm. The absorbance A at this maximum is described by the function A=1.267×C^0.93 (cell path d=5 cm, correlation coefficient r=0.997). The variation coefficient for water concentrations of ≈0.06% was found to be V=6.5%.     

Organometallphosphin-substituierte übergangsmetallkomplexe XVII. Tetracarbonyl-di(organometallphosphin)-chrom-, -molybdän- und -wolfram-komplexe

Bicyclo[2.2.1]-2,5-heptadiene complexes of transition metal carbonyls have been treated with organometallic phosphines, to give the disubstituted compounds [(R₃M′)₃P]₂M(CO)₄ [R = CH₃; M′ = Ge, Sn; M = Cr, Mo, W] by exchange of ligands. The chemical and spectroscopic properties of the new compounds are reported.