Preparation of synthetic rutile from high titanium slag using microwave heating

In this work, we demonstrate a novel synthesis of synthetic rutile from high titanium slag. This rutile TiO₂ was obtained by a simple one-step microwave roasting route. The influence of microwave roasting temperature and duration on the phase transformation of high titanium slag has been assessed. X-ray diffraction (XRD) results indicate that the intensity of anosovite (Fe₃Ti₃O₁₀) phase, which were the major phase of high titanium slag of carbon thermal reduction of ilmenite ores, decreased rapidly while the peaks for rutile TiO₂ phase increased with increase in the microwave roasting temperature. The scanning electron microscope (SEM) images revealed formation and the particle-size distribution of rutile TiO₂ phase. Based on XRD and SEM analysis, confirmed the dependence of phase structure, composition and crystallite size on the process conditions of microwave roasting.     

Influence of the structure parameters on the gain and noise figure in silicon parametric amplifiers based on SOI Rib waveguides

Gain and Noise figure (NF) characteristics in dual-pump parametric amplifier based on silicon on insulator (SOI) Rib waveguides are numerically investigated in the presence of nonlinear losses. The impact of structure parameters of the silicon optical parametric amplifiers (SOPAs) on the gain and the NF are also analyzed. The results show that both the height and the width of the silicon on insulator (SOI) can affect the gain and the NF of SOPAs. 354 nm bandwidth (3 dB) and 8.135 maximum gain can be achieved by tailoring the structure parameters of the SOI rib waveguides. Moreover, the dispersion and the effective mode area of SOI are also analyzed.     

Design of high duty ratio nonlinear photonic crystal fiber with near-zero flattened dispersion after 1.205 μm

The paper presents a high nonlinear photonic crystal fiber (HN-PCF) with highly duty ratio for time-stretch analog-to-digital conversion (TSADC). The simulation results show that a nonlinear of 42.26 W⁻¹ km⁻¹ and the flattened dispersion of less than 1.0 ps/(nm km) are obtained in more than 495 nm waveband (1205–1700 nm). Owing to its high nonlinear coefficient and flattened dispersion, the high nonlinear PCF is expected to be suitable for supercontinuum (SC) generation. The numerical simulation results demonstrate that the proposed high duty ratio HN-PCF can generate wideband SC.     

(±)-5,3’-二羟基-7,8-(2,2-二甲基吡喃)-4’-甲氧基黄烷酮的首次全合成

以廉价的异香草醛和2,4,6-三羟基苯乙酮为起始原料,经过C-异戊烯基化、环化、选择性的保护酚羟基、羟醛缩合、催化环化等步骤,脱保护基,以6.7%的总收率首次完成了天然吡喃型黄烷酮(±)-5,3’-二羟基-7,8-(2,2-二甲基吡喃)-4’-甲氧基黄烷酮的全合成.所有新化合物的结构都经过IR,1H NMR,MS,HRMS确认.     

二极管爆炸发射阴极等离子体的膨胀扩展

分析了二极管中爆炸发射产生阴极等离子体的演化特征,在考虑了阴极等离子体朝阳极膨胀运动使二极管阴阳极间距缩短这一效应的同时,还计入了阴极等离子体沿发射表面径向扩展运动对二极管有效发射面积的影响。基于Child-Langmuir定律,利用在一个四脉冲强流电子束源装置上得到的电流、电压等实验数据,假定阴极等离子体轴向膨胀和径向扩展速度近似相等,研究了阴极等离子体的膨胀扩展动力学行为。计算结果表明,阴极等离子体朝阳极的膨胀和沿径向的扩展速度为0.9～2.8 cm/s。     

不同水温下的中子输运等效质量热运动模型

为了解决蒙特卡罗模拟S(, )模型只能求解特定温度条件下中子输运问题的局限性,建立了中子在不同温度液态水中输运的等效质量热运动模型。在分析自由气体热运动模型的基础上,采用不同的等效质量对中子与水中氢原子的弹性散射模拟过程进行改进,对中子穿过水层后的流量进行模拟计算,通过与S(, )模型的计算结果的比较,得到了5个不同的温度点水中氢原子的最佳等效质量。根据5个不同温度点的数据拟合给出了最佳等效质量和温度的函数关系。采用该模型计算得到的中子在不同温度条件下水中输运参数与S(, )模型相符。等效质量热运动模型突破了S(, )模型只能计算有限温度点的局限性,能有效处理300～800 K任意温度水中的中子输运问题。     

磺胺甲噁唑的二阶导数差示脉冲极谱法测定

建立了磺胺甲噁唑的二阶导数差示脉冲极谱定量分析方法,磺胺甲噁唑在10% HCl-(硼酸-氯化钾缓冲溶液)-水(5:5:90)的底液中,于-1.45 V(vs.Ag/AgCl)处出现一良好的二阶导数差示脉冲极谱峰,磺胺甲噁唑浓度与其峰高在0.08～0.80 mmol/L范围内呈线性关系(p＜0.01),检测限为8.6 nmol/L.本法简便、快速、灵敏,结果准确.     

Low Water Swelling and High Proton Conducting Sulfonated Poly(arylene ether) with Pendant Sulfoalkyl Groups for Proton Exchange Membranes

Novel side‐chain‐type sulfonated poly(arylene ether) with pendant sulfoalkyl group copolymers (PSA‐SPAE‐6F) have been synthesized by direct copolymerization from a new sulfonated monomer, sodium 3‐(4‐(2,6‐difluorobenzoyl)phenyl)propane‐1‐sulfonate. The sulfonate content could be easily controlled by adjusting the sulfonated and the unsulfonated monomer feed ratio. The obtained copolymers all show good thermal and mechanical properties. It should be noted that the most highly sulfonated copolymer, PSA‐SPAE‐6F90 with an ion exchange capacity of 1.30 mequiv · g⁻¹, shows a proton conductivity of 0.11 S · cm⁻¹ and a water swelling ratio of only 12.9% at 100 °C, which indicates its high proton conductivity and excellent dimensional stability in hot water.

     

K+掺杂双钙钛矿Cs2AgInCl6的发光性质

采用固相球磨法制备了K⁺掺杂双钙钛矿Cs₂AgInCl₆纳米材料,该方法无需配体辅助,绿色环保。通过X射线衍射和拉曼光谱对晶体结构进行研究,通过激发光谱、发射光谱和时间分辨光谱对其发光性能进行研究。结果表明,Cs₂AgInCl₆为立方晶体,属于Fm3m空间群,由于宇称禁戒跃迁,其荧光量子产率(PLQY)低,小于0.1%。低于60%的K⁺掺杂主要取代Ag⁺的位置,引起Cs₂AgInCl₆的晶格膨胀,消除了晶格结构的反演对称性,打破了宇称禁戒跃迁,掺杂后Cs₂AgInCl₆的光致发光强度显著增强。K⁺的最佳掺杂比例为40%,Cs₂Ag_0.6K_0.4InCl₆材料发射中心波长为640 nm,半高宽为180 nm,平均荧光寿命达到29.2 ns,PLQY达到10.5%。当K⁺掺杂比例超过60%,K⁺开始取代Cs⁺的位置,产物发生相变,出现立方相的Cs_2-xK_1+x-yAg_yInCl₆和单斜相的Cs_2-xK_1+xInCl₆产物,这些产物由于强电子-声子耦合,非辐射复合占据主导地位。     

Multi-focus optical fiber lens based on all-dielectric metasurface

A multi-focus optical fiber lens is numerically demonstrated based on an all-dielectric metasurface structure. The metasurface consists of an array of rectangular silicon resonators with varying widths in order to obtain the required phase distribution. The core diameter of the multimode fiber is large enough to contain sufficient resonance units. The spatial distribution of the dielectric resonators is dictated by spatial multiplexing, including interleaving meta-atoms and lens aperture division, to achieve multi-focus properties. The proposed optical fiber metalens can produce two or three focal points along the longitudinal direction with high focusing efficiency. The size of every focal point is close to the diffraction limit, and the relative intensity on each focus can be controlled by adjusting the number of the respective resonators. The proposed optical fiber lens will have a great potential in the fields of integrated optics and multifunctional micro/nano devices.