A comparison of master equation and Fokker-Planck equation in the thermodynamic limit

The master equation and the Fokker-Planck equation are compared thoroughly in both of the stationary and the time-dependent cases for a one-dimensional system. The comparison includes the master equation without detailed balance.     

纯生跳跃扩散型交换期权定价公式

在假定标的资产价格服从纯生跳跃过程的条件下,研究一类多资产期权——资产权重不同的交换期权,并在风险中性的条件下建立相应的定价方程,运用条件期望等相关知识得出交换期权的解析公式。文中最后列出一些特殊纯生跳跃扩散型交换期权的定价的例子.     

Matrix representation of three-dimensional astigmatic resonators

Three-dimensional astigmatic resonators, typical examples of which are the resonators bounded by cylindrical-spherical mirrors and cylindrical-cylindrical mirrors oriented at an arbitrary crossed angle, are investigated in detail by using a complex curvature tensor concept and generalized tensor ABCD law. Computerized numerical calculations illustrate some interesting characteristics of these astigmatic resonators.     

Effect of carbon content on the microstructure and the cracking susceptibility of Fe-based laser-clad layer

The laser cladding of Fe-based alloys on a medium carbon steel substrate was performed using a CO₂ laser and Ar shielding gas that was blown into a molten pool. The microstructure and cracking susceptibility of the laser-clad layers were studied in terms of carbon additions. Results show that the small change of the carbon content in the alloy powders can obviously change the microstructure and properties of the layers. When the carbon content is in the range of 0.3–0.4 wt.%, the decrease of the carbon content in alloy powders will increase the hardness and toughness of the layers simultaneously under the same process parameters. As a result, crack-free coatings with high hardness can be obtained. As the carbon content increases from 0.2 wt.% to 0.4 wt.%, the segregation ratio of chromium increases, while the segregation ratios of nickel, manganese, and silicon first decrease and then increase. At the same time, a new designing principle concerning the composition and microstructure has been put forward, and the principal mechanisms of strengthening and toughening of the layers are fine-grain strengthening and low carbon martensitic phase transformation strengthening.     

矩阵方程（A^TXA，B^TXB=（C，D）的反对称解及其最佳逼近

本利用矩阵对的标准相关分解，得到了矩阵方程(A^TXB，B^TXB)=(C，D)反对称解存在的充分必要条件及通解表达式，同时给出了解关于已知矩阵的最佳逼近．     

The influence of hard‐segments on two‐phase structure and shape memory properties of PCL‐based segmented polyurethanes

Poly(ε‐caprolactone)‐based segmented polyurethanes (PCLUs) were prepared from poly(ε‐caprolactone) diol, diisocyanates (DI), and 1,4‐butanediol. The DIs used were 4,4′‐diphenylmethane diisocyanate (MDI), 2,4‐toluenediisocyanate (TDI), isophorone diisocyanate (IPDI), and hexamethylene diisocyanate (HDI). Differential scanning calorimetry, small‐angle X‐ray scattering, and dynamic mechanical analysis were employed to characterize the two‐phase structures of all PCLUs. It was found that HDI‐ and MDI‐based PCLUs had higher degree of microphase separation than did IPDI‐ and TDI‐based PCLUs, which was primarily due to the crystallization of HDI‐ and MDI‐based hard‐segments. As a result, the HDI‐based PCLU exhibited the highest recovery force up to 6 MPa and slowest stress relaxation with increasing temperature. Besides, it was found that the partial damage in hard‐segment domains during the sample deformation was responsible for the incomplete shape‐recovery of PCLUs after the first deformation, but the damage did not develop during the subsequent deformation. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 557–570, 2007     

A Novel and Efficient Catalytic System for Aerobic Oxidative Coupling of 2-Naphthol Derivatives

The paper reported a novel and efficient aerobic oxidative coupling reaction of 2-naphthol derivatives catalyzed by CuCu (Ⅰ or Ⅱ)N-alkylimidazole complexes in excellent yields. The crystal structure of CuCu(Ⅱ)N-methylimidazole complex to be determined by X-Ray.