Characterization of oxide thin films using optical techniques

Thin films of oxide materials are playing a growing role as critical elements in optoelectronic devices and nanoscale devices. In this work, thin films of some typical oxides such as WO₃, Ga₂O₃ and SrTiO₃ were investigated. We present measurements of those films, using various optical techniques like photoconductivity transients over a wide time range and photo-Hall measurements. Analysis of the photo-Hall and photoconductivity data permits the determination of the contribution to the photoconductivity made by the carrier mobility and concentration. A model for dispersive carrier transport was proposed to explain the relaxation of the photoconductivity in oxide thin films. In addition, photoluminescence characterization was used to study microstructures and energy band in oxide thin films. The broad emission from oxide host, consisting of several band peaks, was likely due to a recombination process with several possible paths. The dependence of the luminescent intensity on the annealing atmosphere was associated with the presence of oxygen vacancies. It is suggested that our optical analysis efforts have improved the understanding of oxide thin films, and this should lead to the necessary advancements in a variety of devices.     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

The effect of surface crystalline layers on asymmetric off-diagonal magnetoimpedance in field-annealed CoFeSiB amorphous ribbons

The off-diagonal magnetoimpedance in field-annealed CoFeSiB amorphous ribbons was measured using a pick-up coil wound around the sample. One side of a ribbon was etched in hydrofluoric acid solution during various times in order to change the thickness of the surface crystalline layer appearing after annealing. The asymmetric two-peak field dependence of the off-diagonal impedance was observed for all samples. The evolution of the off-diagonal magnetoimpedance with the change in the ribbon thickness is analyzed.     

Solvothermal synthesis of TiO2: anatase nanocrystals and rutile nanofibres from TiCl4 in acetone

This work reports a new synthetic approach for single‐phase TiO₂ nanomaterials by solvothermal treatment of titanium tetrachloride in acetone at 80–110 °C. Small, uniform, and yet size‐tunable (5–10 nm) anatase titania nanocrystallites were obtained using a low concentration of TiCl₄ in acetone (i.e., at molar ratios of TiCl₄/acetone ≤ 1:15) in the temperature range of 80–110 °C, while rutile nanofibers were synthesized using a high concentration of TiCl₄ (e.g., TiCl₄/acetone = 1:10) at 110 °C. Copyright © 2007 John Wiley & Sons, Ltd.     

Viscometric properties of dilute polystyrene/dioctyl phthalate solutions

We report viscometric data collected in a Couette rheometry on dilute, single‐solvent polystyrene (PS)/dioctyl phthalate (DOP) solutions over a variety of polymer molecular weights (5.5 × 10⁵ ≤ M_w ≤ 3.0 × 10⁶ Da) and system temperatures (288 K ≤ T ≤ 318 K). In view of the essential viscometric features, the current data may be classified into three categories: The first concerns all the investigated solutions at low shear rates, where the solution properties are found to agree excellently with the Zimm model predictions. The second includes all sample solutions, except for high‐molecular‐weight PS samples (M_w ≥ 2.0 × 10⁶ Da), where excellent time–temperature superposition is observed for the steady‐state polymer viscosity at constant polymer molecular weights. No similar superposition applies at a constant temperature but varied polymer molecular weights, however. The third appears to be characteristic of dilute high‐molecular‐weight polymer solutions, for which the effects of temperature on the viscosity curve are further complicated at high shear rates. The implications concerning the relative importance of hydrodynamic interactions, segmental interactions, and chain extensibility with increasing polymer molecular weight, system temperature, and shear rate are discussed. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 787–794, 2006     

Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006     

Bipyridinophane‐containing conjugated polymers modulated with an intramolecular aromatic C?H/π interaction

Bipyridinophane–fluorene conjugated copolymers have been synthesized via Suzuki and Heck coupling reactions from 5,8‐dibromo‐2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane and suitable fluorene precursors. Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P7 ) exhibits large absorption and emission redshifts of 20 and 34 nm, respectively, with respect to its planar reference polymer Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐1,4‐(2,5‐dimethylbenzene)] ( P11 ), which bears the same polymer backbone as P7 . These spectral shifts originate from intramolecular aromatic C? H/π interactions, which are evidenced by ultraviolet–visible and ¹H NMR spectra as well as X‐ray single‐crystal structural analysis. However, the effect of the intramolecular aromatic C? H/π interactions on the spectral shift in poly[9,9‐dihexylfluorene‐2,7‐yleneethynylene‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P10 ) is much weaker. Most interestingly, the quenching behaviors of these two conjugated polymers are largely dependent on the polymer backbone. For example, the fluorescence of P7 is efficiently quenched by Cu²⁺, Co²⁺, Ni²⁺, Zn²⁺, Mn²⁺, and Ag⁺ ions. In contrast, only Cu²⁺, Co²⁺, and Ni²⁺ ions can partially quench the fluorescence of P10 , but much less efficiently than the fluorescence of P7 . The static Stern–Volmer quenching constants of Cu²⁺, Co²⁺, and Ni²⁺ ions toward P7 are of the order of 10⁶ M^?1, being 1300, 2500, and 37,300 times larger than those of P10 , respectively. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 4154–4164, 2006     

几种陆用惯性自寻北方案的比较

介绍几种目前广泛应用于军事及民用工业领域的高精度自寻北方案,同时讨论并分析了这些方案的精度和误差补偿方法,提出在兵器领域尤其是在陆用车辆上的适用性等问题。     

矩孔金属光栅矢量模式理论的数值计算

根据矩孔金属光栅的矢量模式理论，计算了不同入射方向，波长及偏振态情况下衍射场的分布，研究了不同光栅结构对衍射效率，偏振态变化的影响；同时，根据实际需要，加工制作了一批不同深度的矩孔光栅样品，进行了实验测量，并将计算值与实验值进行了比较，两者基本相符。