SiO2脊形条波导热极化引起的电光效应

通过理论模拟对具有上覆盖层的SiO2脊形条波导结构进行了优化,在此基础上利用微电子工艺制作了SiO2脊形波导Mach-Zehnder 型电光调制器,并进行热极化引起的电光和非线性效应的研究.热极化过程大幅增强了样品的电光及非线性效应,二次电光系数由热极化前的1.56×10-22(m/V)2提高到热极化后的8.50×10-22(m/V)2,极化后得到了0.093pm/V的线性电光系数,对热极化的物理机理进行了理论分析.     

纳米TiO_2∶Zn薄膜电极紫外光电特性研究

采用sol-gel法制备了Zn2 掺杂的锐钛矿相纳米TiO2薄膜电极.通过光电流作用谱和电流-电位(I-U)曲线研究了掺杂不同浓度Zn2 的TiO2薄膜电极的光电特性.由光电流作用谱可知,Zn2 的掺杂可显著影响薄膜电极的光电流大小,且掺杂的最佳浓度与薄膜晶粒尺度有关.在320nm单色光照射下,掺杂浓度(摩尔浓度)为0.1%的薄膜电极光电流最大,与未掺杂的本征薄膜电极相比增幅达40%.I-U曲线表明,光照下,随电极电位由正到负逐渐降低,不同掺杂浓度的TiO2薄膜电极中均出现了阳极电流向阴极电流转换的现象,且Zn2 掺杂浓度可影响电极阳极电流的初始电位.另外,无光照的暗态下,各薄膜在负电位区域观察到了相似的随电位降低而迅速增大的阴极暗电流.     

Study on measurement of linear electro-optic coefficient of a minute irregular octahedron cBN wafer

The cubic boron nitride (cBN) is a kind of artificial electro-optic (EO) crystal, and we have not found any relative reports so far. Because the artificial synthetic cBN wafers are very small and hard, the wafers cannot be cut into rectangular slabs. The polarizer-sample-λ/4 retardation plate (compensator)-analyzer (PSCA) transverse EO modulator has to be adjusted to the minute irregular octahedron of cBN wafers. When the applied voltage is along [1 1 1] direction of the wafer, due to refraction, the angle between the incident beam direction and the (1 1 1) plane (top or bottom plane) of the wafer should be 25.4°, and the angle between the polarization direction of the polarizer and the plane of incidence should be 50.8° by calculation, respectively. The half-wave voltage of the cBN sample was obtained for the first time, by means of detection of the output optic signals from the modulator with and without an applied electric field on the sample, respectively. Furthermore, the linear EO coefficient was obtained, . The analysis of the experimental resulting error was carried out.     

Influence of a single quantum dot state on the characteristics of a microdisk laser

We report a quantum dot microcavity laser with a cw sub-microW lasing threshold, where a significant reduction of the lasing threshold is observed when a single quantum dot (QD) state is aligned with a cavity mode. The quality factor exceeds 15,000 before the system lases. When no QD states are resonant, below threshold the cavity mode initially degrades with increasing pump power, after which saturation occurs and then the cavity mode recovers. We associate the initial cavity mode spoiling with QD state broadening that occurs with increasing pump power.     

Single-frequency 1.25 W monolithic lasers at 1123 nm

Experimental investigation ofd Nd:YAG monolithic nonplanar ring lasers operated at 1123 nm wavelength is presented. Stable single-frequency 1123 nm laser output has been obtained with successful suppression of the strong 1064 nm radiation. Single-frequency output power of 1.25 W is demonstrated with a pump power of 3.98 W at 808 nm, which gives a slope efficiency of 39%. The laser frequency tuning range is over 3 GHz, and the average tuning rate with temperature is -2.6 GHz/ degrees C. A strong iodine absorption line can be covered within the laser frequency tuning range.     

Single attosecond pulse generation from asymmetric molecules with a multicycle laser pulse

A new scheme for single attosecond pulse generation from asymmetric molecules with a multicycle laser pulse is proposed. It is shown that both even and odd harmonics are generated from the asymmetric molecules, and the attosecond pulses are produced every full cycle of the driving laser field rather than each half-cycle. By filtering the harmonics in the cutoff of the spectrum, a single attosecond pulse can be obtained with a multicycle laser pulse with a duration of 2 times longer than the few-cycle pulse conventionally used.     

Structures of Interaction of Non-selfsimilar Elementary Waves for 2D Scalar Conservation Law with Two Initial Discontinuities

Acta Mathematicae Applicatae Sinica, English Series - In this paper, we investigate the global solution and the structures of interaction between two dimensional non-selfsimilar shock wave and...     

带非线性源项的Riesz回火分数阶扩散方程的预估校正方法

本文针对带非线性源项的Riesz回火分数阶扩散方程,利用预估校正方法离散时间偏导数,并用修正的二阶Lubich回火差分算子逼近Riesz空间回火的分数阶偏导数,构造出一类新的数值格式.给出了数值格式在一定条件下的稳定性与收敛性分析,且该格式的时间与空间收敛阶均为二阶.数值试验表明数值方法是有效的.     

V2CN2负载过渡金属双原子电催化固氮的第一性原理研究

电催化剂固氮能够在温和条件下催化氮气还原制氨.本工作基于第一性原理计算,系统地探究了分散在二维V₂CN₂上过渡金属二聚体(Fe, Mo, Ru)形成的双原子催化剂用于电催化固氮的可行性.双原子的协同作用使氮气得到较好的活化.吉布斯自由能计算表明,在V₂CN₂负载双铁原子(Fe₂@V₂CN₂)体系进行的催化反应过电位最低,仅为0.25 eV.进一步的分子动力学计算表明Fe₂@V₂CN₂具有较好的结构稳定性,并且该体系能很好的抑制HER反应的发生.通过与Mo₂@V₂CN₂,Ru₂@V₂CN₂体系的比较可知,氮气分子的吸附构型以及HER反应的竞争对催化剂的选择影响很大.我们的计算能够为双原子催化剂的设计提供更多的依据.     

固液悬浮体系下超声波浓度测量技术进展

在工业生产和科学实验中,固液悬浮体系是一种非常重要的流体类型,其浓度与均匀性变化直接决定了最终制品的物理化学性能及服役稳定性,对其进行实时、原位、高精度测量具有重要意义。因为超声波技术其具有非接触、精度高、响应速度快等优点,所以本文重点介绍了基于该技术实现固液悬浮体系浓度测量的方法,回顾了其国内外发展状况,特别是对该技术在浆液混合过程监控方向的应用做出了介绍和总结。最后,对该领域的发展趋势进行了展望