Influences of permeation of vanadium ions through PVDF-g-PSSA membranes on performances of vanadium redox flow batteries

The preparation and physical characterization of a poly(vinylidene fluoride)-graft-poly(styrene sulfonic acid) (PVDF-g-PSSA) membrane prepared by a solution-grafting method were described. These membranes exhibited high conductivity with a value 3.22 x 10(-2) S/cm at 30 degrees C. ICP studies revealed that the PVDF-g-PSSA membrane showed dramatically lower vanadium ion permeability compared to Nafion 117. Trivalent vanadium ions had the highest permeability through all these membranes in contrast to pentavalent vanadium ions with the lowest. The VRB with the low-cost PVDF-g-PSSA membrane exhibited a higher performance than that with Nafion 117 under the same operating conditions, and its energy efficiency reached 75.8% at 30 mA/cm(2). The performance of VRB with the PVDF-g-PSSA membrane can be maintained after more than 200 cycles at a current density of 60 mA/cm(2).     

拟静态法测定混合溶剂的汽化热和汽化熵

讨论了沸点升高法测定混和溶剂化热和汽化熵的原理，并用拟静态法测定了乙醇－丙酮，并－四氯化碳和苯，甲苯三组混和溶剂在不同组成下的正常沸点，根据沸点数据求得了混和泶微分汽化热和汽化熵，实验结果表明，二元混和溶剂与理想溶液偏离不大时，其正常汽化熵符合Ｔｒｏｕｔｏｎ规则。     

极性有机化合物在电解质水溶液中盐效应的研究(II)应用Pitzer方程关联二(2-乙基已基)磷酸在碱金属氯化物水溶液中的活度系数

本文将用放射性磷32标记法测得的二(2-乙基己基)磷酸在碱金属氯化物水溶液(LiCl、NaCl、KCl、RbCl、CsCl和NH_4Cl)中的溶解度数据~[1], 分别用Pitzer(1973年)方程和Pitzer-Li(1983年)方程进行活度系数的关联. 计算结果表明, 由于Pitzer-Li方程考虑了溶质-溶剂间的短程作用能, 所得参数更能反映盐效应的本质, 故优于Pitzer方程. 同时还表明, 上述体系中离子-水之间的作用能远大于离子-有机化合物之间的作用能。     

An extended two‐dimensional copper–molybdate compound with mixed dicarboxyl and organodiamine ligands

The title complex, poly[di‐μ₃‐oxo‐hepta‐μ₂‐oxo‐tetra­oxo­bis(1,10‐phenanthroline)‐μ₄‐terephthalato‐dicopper(II)­tetra­molybdate(VI)], [Cu₂Mo₄(C₈H₄O₄)O₁₃(C₁₂H₈N₂)₂], represents a novel two‐dimensional copper–molybdate compound with mixed ligands. Tetra­nuclear molybdenum oxide clusters are joined through corner‐sharing into a ribbon‐like chain, with [Cu(phen)]²⁺ (phen is 1,10‐phenanthroline) complexes grafted onto either side. The terephthalate ligand lies about an inversion centre and links these chains to form a layer via Cu—O and Mo—O bonds. Face‐to‐face π–π stacking inter­actions between adjacent phen ligands stabilize the structure.     

Reactivity of organolanthanide and organolithium complexes containing the guanidinate ligands toward isocyanate or carbodiimide: synthesis and crystal structures

The direct reactions of (C5H5)2LnCl with LiN=C(NMe2)2 proceeded at room temperature in THF under pure nitrogen to yield the lanthanocene guanidinate complexes [(C5H5)2Ln(mu-eta1:eta2-N=C(NMe2)2)]2 (Ln = Gd (1), Er (2)). Treatment of phenyl isocyanate with complexes 1 and 2 results in monoinsertion of phenyl isocyanate into the Ln-N(mu-Gua) bond to yield the corresponding insertion products [(C5H5)2Ln(mu-eta1:eta2-OC(N=C(NMe2)2)NPh)]2 (Ln = Gd (3), Er (4)), presenting the first example of unsaturated organic small molecule insertion into the metal-guanidinate ligand bond. Further investigations indicate that N,N'-diisopropylcarbodiimide does not react with complexes 1 and 2 under the same conditions; however, it readily inserts into the lithium-guanidinate ligand bond of LiN=C(NMe2)2. As a synthon of the insertion product Li[(iPrN)2C(N=C(NMe2)2)], its reaction with (C5H5)2LnCl gives the novel organolanthanide complexes containing the guanidinoacetamidinate ligand, (C5H5)2Ln[(iPrN)2C(N=C(NMe2)2)] (Ln = Yb (5), Er (6), Dy (7)). All complexes were characterized by elemental analysis and spectroscopic properties. The structures of complexes 1, 3, 5 and 7 were determined through X-ray single-crystal diffraction analysis.     

Studies of synergism for lowering dynamic interfacial tension in sodium alpha-(n-alkyl) naphthalene sulfonate/alkali/acidic oil systems

Alkylnaphthalene sulfonates with high purity were selected as model components to research synergism for lowering interfacial tension (IFT) in surfactant/alkali/acidic oil systems. The dynamic IFTs between alkylnaphthalene sulfonates with different alkyl chain length and n-decane, oleic acid model oil, or Shengli crude oil were measured. The results showed that the alkylnaphthalene sulfonates with different alkyl chain lengths had different synergism with different acidic components and their ionized acids under the same conditions. The synergism for lowering dynamic IFT in alkylnaphthalene sulfonate/alkali/acidic oil systems was controlled by alkylnaphthalene sulfonate concentration, alkyl chain length, alkali concentration, alkali type, and oleic acid concentration: optimal physicochemical conditions were necessary to the best synergism. This indicates that the synergism among added surfactant acidic components in crude oil and their ionized acids is controlled by the ratio of their interfacial concentrations.     

Thermochemical Properties and Decomposition Kinetics of Ammonium Magnesium Phosphate Monohydrate

Ammonium magnesium phosphate monohydrate NH4MgPO4·H2O was prepared via solid state reaction at room temperature and characterized by XRD, FT-IR and SEM. Thermochemical study was performed by an isoperibol solution calorimeter, non-isothermal measurement was used in a multivariate non-linear regression analysis to determine the kinetic reaction parameters. The results show that the molar enthalpy of reaction above is （28.795 ± 0.182） kJ/mol （298.15 K）, and the standard molar enthalpy of formation of the title complex is （-2185.43 ± 13.80） kJ/mol （298.15 K）. Kinetics analysis shows that the second decomposition of NH4MgPO4·H2O acts as a double-step reaction： an nth-order reaction （Fn） with n=4.28, E1=147.35 kJ/mol, A1=3.63×10^13 s^-1 is followed by a second-order reaction （F2） with E2=212.71 kJ/mol, A2= 1.82 × 10^18 s^-1.     

Voltammetric Reduction of alpha- and gamma-[S2W18O62]4- and alpha-, beta-, and gamma-[SiW12O40]4-: isomeric dependence of reversible potentials of polyoxometalate anions using data obtained by novel dissolution and conventional solution-phase processes

Comparative studies on the voltammetric reduction of the alpha and gamma isomers of Dawson [S(2)W(18)O(62)](4)(-) and alpha, beta, and gamma forms of Keggin [SiW(12)O(40)](4)(-) polyoxometalate anions have been undertaken. For the six reversible one-electron [S(2)W(18)O(62)](4)(-)(/5)(-)(/6)(-)(/7)(-)(/8)(-)(/9)(-)(/10)(-) processes in acetonitrile, reversible potentials (E(0)(')) were found to be independent of isomeric form within experimental error (+/-5 mV). However, because both the alpha and gamma* isomers of [Bu(4)N](4)[S(2)W(18)O(62)] are insoluble in water, solid-state voltammetric studies with microcrystals adhered to electrode surfaces in contact with aqueous Et(4)NCl and Bu(4)NCl electrolyte media were also possible. Although no isomeric distinction was again detected in the solid-state studies, it was found that reduction of adhered solid by four or more electron equivalents led to rapid dissolution. When Et(4)NCl was the electrolyte, this dissolution process coupled with potential cycling experiments enabled conventional solution-phase data to be obtained in water for the analogous six one-electron reduction steps previously detected in acetonitrile. A strong medium effect attributed to Lewis acidity effects was apparent upon comparison with E(0)(') data obtained in water and acetonitrile. In contrast, with the [SiW(12)O(40)](4)(-) system, E(0)(') values for the [SiW(12)O(40)](4)(-)(/5)(-)(/6)(-)(/7)(-) processes in acetonitrile exhibited a larger (about 70 mV) dependence on isomeric form, and the isomerization step, [gamma-SiW(12)O(40)](6)(-)--> [alpha-SiW(12)O(40)](6)(-), was detected on the voltammetric time scale. The influence of isomeric form on reversible potential data is considered in terms of structural and charge density differences exhibited in the [S(2)W(18)O(62)](4)(-) and [SiW(12)O(40)](4)(-) systems studied in this paper and published data available on the alpha, beta, gamma, and gamma isomers of [As(2)W(18)O(62)](6)(-) and [P(2)W(18)O(62)](6)(-) Dawson anions and Keggin systems.     

Chloride substitution of [CpRu(dppf)Cl] with sulfur-containing ligands

The reactions of CpRu(dppf)Cl (1) with the sulfur-containing ligands, thiophenol HSPh, 2-mercaptopyridine C₅H₄N(SH), thiourea SC(NH₂)₂, vinylene trithiocarbonate SCS(CH)₂S and ethylene trithiocarbonate SCS(CH₂)₂S, yielded chloro-substituted derivatives, viz. the mono-ruthenium(II) complexes CpRu(dppf)(SPh) (2), [CpRu(dppf)(SC₅H₄NH)]BPh₄ (3)BPh₄, [CpRu(dppf)(SC(NH₂)₂]PF₆ (4)PF₆, [CpRu(dppf)(SCS(CH)₂S)]Cl (5)Cl and [CpRu(dppf)(SCS(CH₂)₂S)]Cl (6)Cl, respectively. Treatment of 1 with AuCl(SMe₂) in the presence of NH₄PF₆ gave [(CpRu(dppf)(SMe₂)]PF₆ (7)PF₆. The reaction of 1 or 6 with SnCl₂ resulted in cleavage of chloro and dithiocarbonate ligands, respectively, to give CpRu(dppf)SnCl₃ (8). All complexes were spectroscopically characterized and the structures of 2 and cationic complexes 4-7 were determined by single-crystal diffraction analyses.     

微孔中简单流体粘度的分子动力学模拟及关联模型

用分子动力学模拟计算了微孔介质中流体氩在不同温度、不同密度和不同孔径下的剪切粘度.并根据Chapman-Enskog关于硬球流体传递性质的理论以及Heyes的关于Lennard-Jones流体粘度的表达式,提出了两个描述微孔介质中流体粘度的模型,该模型可以计算微孔中流体氩在不同状态下的粘度值.通过与计算机模拟值的比较,证明这两个微孔流体粘度模型是可用的.