Improvement in Uranium Adsorption Properties of Amidoxime-Based Adsorbent Through Cografting of Amine Group

Amidoxime (AO)/amine co-functionalized polypropylene fiber adsorbents were prepared. The all-polymeric structures were characterized by using Fourier transform infrared spectroscopy (FTIR), optical microscope, contact angle meter and electron spin resonance (ESR) analysis methods, confirming the grafting, modification, and amidoximation stages gravimetrically, spectroscopically, and visually. The properties for the removal of uranyl(VI) from aqueous solutions were investigated. For amidoxime (AO) fiber, high adsorption rate was observed within the first 30 minutes and the plateau value of 40.6% uranium loading (0.0812 mg/g) was reached at around 30 minutes. The adsorption equilibrium for AO/amine fiber was attained within 20 minutes, resulting in the adsorption of 92.6% uranium loading (0.185 mg/g). The percentage of adsorption increases with increasing pH value (2–6), reaches a maximum at pH 6.0 and then remains almost constant for AO/amine fiber, whereas reduces slightly for AO fiber.     

Curcumin Inhibits the Sortase A Activity of the Streptococcus mutans UA159

Streptococcus mutans (S. mutans) forms part of the commensal microflora and is deemed to be the major pathogen responsible for the generation of dental caries. The enzyme, sortase A enzyme, modulates the surface properties and cariogenicity of S. mutans. Curcumin has been reported to be an inhibitor of Staphylococcus aureus sortase A. In this study, inhibition of a purified S. mutans UA159 sortase A by curcumin was evaluated. Curcumin exerted strong inhibitory activity with a half maximal inhibitory concentration (IC₅₀) of 10.2?±?0.7 μM which was lower than the minimum inhibitory concentration of 175 μM and the minimum bactericidal concentration of 350 μM. These results indicated that curcumin is a S. mutans UA159 sortase A inhibitor and therefore represents as a promising anticaries agent.     

PMAA microgel surface-supported phase transfer catalyst as reusable microreactors for ultra-deep desulfurization

The reusable microreactors, poly(methacrylic acid) (PMAA) microgels surfacely covered with 3-(trimethoxysilyl)-propyldimethyloctadecyl ammonium chloride (AEM) and K₂{W(=O)(O₂)₂(H₂O)}₂ (W2) complexes, have been synthesized by using an ion exchange reaction between AEM located on PMAA microgels and W2 in aqueous solution. The final composite microspheres and intermediate products are characterized by scanning electron microscopy, Fourier transform infrared spectroscopy, energy dispersive X-ray spectrophotometer, and thermogravimetric analysis, respectively. The results indicated the PMAA/AEM/W2 composite microspheres with surface-wrinkling morphology and core-shell structure. The feasibility of the composite microspheres used as reusable microreactors in catalytic oxidation of dibenzothiophene (DBT) was investigated. Additionally, the effects of some factors, including the amount of the microreactors, temperature, H₂O₂/DBT molar ratio, the loaded amount of AEM, DBT concentration, and recycling times, on the catalytic oxidation were examined. The results demonstrated that the prepared composite microspheres possess high catalytic performance and reusability in the catalytic oxidation of DBT.     

Impacts of some macromolecules on the characteristics of hydrogels prepared from pineapple peel cellulose using ionic liquid

Composite hydrogels were prepared from pineapple peel cellulose with the combinations of polyethylene glycol (PEG), polyvinyl alcohol (PVA), к-carrageenan (CN), or soluble starch (SH) in 1-allyl-3-methylimidazolium chloride solvent. Impacts of these macromolecules on the texture profile analysis (TPA) parameters, equilibrium swelling ratio (ESR), and sodium salicylate (NaSA) load of the prepared hydrogels were studied. The NaSA release kinetics of the composite hydrogels were also compared. The composite hydrogels exhibited differences in Fourier transform infrared spectroscopy (FTIR), TPA parameters, ESR, NaSA load ratio, and release kinetics. CN addition increased the hardness of the hydrogels, while PEG played an opposite role. SH and PVA could decrease hardness, gumminess, and resilience, and SH could increase the springiness and cohesiveness of the hydrogels. Most of the composite hydrogels exhibited the same basic FTIR features as the simple hydrogel. Freeze-dried composite hydrogels exhibited a markedly higher ESR than the oven-dried ones, and additions of PEG, PVA, CN, and SH showed the same effect. Addition of the PEG and PVA combination could lower the ESR of the hydrogels, whereas additions of the PEG and CN combination or PEG and SH combination could markedly increase the ESR of the hydrogels. Addition of PEG, PVA, CN, and SH respectively could increase the NaSA load ratio of the hydrogels. Oven-drying treatment, additions of the PEG and PVA combination or PEG and CN combination were propitious for extending the NaSA fast-release phase of the hydrogels.     

C?H Functionalization/Asymmetric Michael Addition Cascade Enabled by Relay Catalysis: Metal Carbenoid Used for C?C Bond Formation

A combination of either ruthenium(II) or rhodium(II) complexes and quinine‐derived squaramide enables 3‐diazooxindoles, indoles, and nitroalkenes to undergo highly efficient asymmetric three‐component reactions, thus affording optically active 3,3′‐bis(indole)s through a consecutive C C bond‐forming sequence, which turned out to be applicable to the facile total synthesis of (−)‐folicanthine.     

Palladium‐Catalyzed C(sp3)?H Activation: A Facile Method for the Synthesis of 3,4‐Dihydroquinolinone Derivatives

3,4‐Dihydroquinolinones were synthesized by the palladium‐catalyzed, oxidative‐addition‐initiated activation and arylation of inert C(sp³) H bonds. Pd(OAc)₂ and P(o‐tol)₃ were used as the catalyst and ligand, respectively, to improve the efficiency of the reaction. A further advantage of this reaction is that it could be performed in air. A relatively rare seven‐membered palladacycle was proposed as a key intermediate of the catalytic cycle.     

One-pot reaction for the concise synthesis of spiro[benzofuran-2,2′-naphthalen]-1′-one derivatives

A novel one-pot two-step protocol has been developed to synthesize various spiro[benzofuran-2,2′-naphthalen]-1′-one derivatives from the three-component reaction of tetralones, 2-hydroxyphenyl functionalized α,β-unsaturated ketones, and iodine. One C–C bond and one C–O bond have formed during this process. The notable features of this protocol are simple and mild reaction conditions, applicable to a wide range of readily available starting materials, good yields (up to 91%), and excellent stereoselectivities (up to 97:3).     

A Furan-based Phosphaphenanthrene-containing Derivative as a Highly Efficient Flame-retardant Agent for Epoxy Thermosets without Deteriorating Thermomechanical Performances

In order to reduce greenhouse gas emissions, developing flame retardants from bio-based resources has aroused extensive interest in recent years. In this work, we utilized furfural(biomass) and 9,10-dihydro-9-oxa-10-phosphaphenanthrene-10-oxide(DOPO) to synthesize a biobased co-curing agent(FGD) to combine with 4,4'-diaminodiphenyl methane(DDM) for obtaining a low-phosphorus loading flame-retardant epoxy thermosets. The introduction of FGD decreased the activation energy of the curing progress, enhanced the mechanical properties of the epoxy thermosets, and did not affect the glass transition temperature of the epoxy thermosets. EP-5.0 had a lower thermal degradation rate and a doubled char yield compared with EP-0. The phosphorus content of EP-5.0 was only 0.45 wt%, while EP-5.0 reached the UL-94 V-0 rating with a high LOI value of 32%. Compared with EP-0, the PHRR of EP-2.5 and EP-5.0 decreased by 22.3% and 31.3%, respectively. The SEM results showed that the addition of FGD made the char residues more uniform and denser, which could effectively prevent combustible volatiles from escaping from the degradation area to the flame area and isolate the heat transfer so that the epoxy thermosets had an excellent flame-retardant performance.     

Investigation on the Interaction of Dy(Ш)/Rutin Complexes with Bovine Serum Albumin by Spectroscopic Methods

Journal of Solution Chemistry - The interaction between Dy(Ш)/Rutin complexes and bovine serum albumin (BSA) was studied by fluorescence, ultraviolet (UV) absorption, three-dimensional...     

The Total Solubility of the Co-Solubilized PAHs with Similar Structures Indicated by NMR Chemical Shift

The synergism/inhibition level, solubilization sites and the total solubility (S_t) of co-solubilization systems of phenanthrene, anthracene and pyrene in Tween 80 and sodium dodecyl sulfate (SDS) are studied by ¹H-NMR, 2D nuclear overhauser effect spectroscopy (NOESY) and rotating frame overhauser effect spectroscopy (ROESY). In Tween 80, inhibition for phenanthrene, anthracene and pyrene is observed in most binary and ternary systems. However, in SDS, synergism is predominant. After analysis, we find that the different synergism or inhibition situation between Tween 80 and SDS is related to the different types of surfactants used and the resulting different co-solubilization mechanisms. In addition, we also find that three polycyclic aromatic hydrocarbons (PAHs) have similar solubilization sites in both Tween 80 and SDS, which are almost unchanged in co-solubilization systems. Due to the similar solubilization sites, the chemical shift changes of surfactant and PAH protons follow the same pattern in all solubilization systems, and the order of chemical shift changes is consistent with the order of changes in the St of PAHs. In this case, it is feasible to evaluate S_t of PAHs by chemical shift. In both Tween 80 and SDS solutions, the ternary solubilization system has relatively high S_t rankings. Therefore, in practical applications, a good overall solubilization effect can be expected.