Low temperature fired Ni-Cu-Zn ferrite with Bi4Ti3O12

The Ni-Cu-Zn ferrites with different contents of Bi₄Ti₃O₁₂ ceramics (1-8 wt%) as sintering additives were prepared by the usual ceramic technology and sintered at 900 °C to adapt to the low temperature co-fired ceramic (LTCC) technology. The magnetic and dielectric properties of the ferrite can be effectively improved with the effect of an appropriate amount of Bi₄Ti₃O₁₂. For all samples, the ferrite sintered with 2 wt% Bi₄Ti₃O₁₂ has relatively high density (98.8%) and permeability, while the ferrite with 8 wt% Bi₄Ti₃O₁₂ has relatively good dielectric properties in a wide frequency range. The influences of Bi₄Ti₃O₁₂ addition on microstructure, magnetic and dielectric properties of the ferrite have been discussed.     

Schemes to generate and distinguish a type of genuine four-qubit entangled states in a cavity QED system

We propose a scheme to generate a type of genuine four-qubit entangled states, which were firstly introduced by Yeo et al. [Y. Yeo, W. K. Chua, Phys. Rev. Lett. 96 (2006) 060502]. These states have many interesting entanglement properties and possess possible applications in quantum information processing and in fundamental tests of quantum physics. We show that such a type of 16 orthonormal basis states can be deterministically distinguished by a cavity QED system.     

Distributed strain measurement using a tellurite glass fiber with Brillouin optical correlation-domain reflectometry

A tellurite glass fiber with a high Brillouin gain was employed for distributed strain measurement with Brillouin optical correlation-domain reflectometry (BOCDR). First, the spatial resolution of BOCDR was evaluated using the tellurite fiber. With the high Brillouin gain of the fiber, it was confirmed clearly in the experiment that the spatial resolution is limited by the Rayleigh scattering-induced noise. Then, the dependence of the Brillouin frequency shift (BFS) on strain in the tellurite fiber was investigated, showing a negative dependence with a coefficient of −0.023 MHz/με. Using this tellurite fiber, the distribution of the BFS around a 1-cm strain-applied section was successfully measured with BOCDR of a nominal spatial resolution of 6 mm.     

Density-functional study of Si<Subscript><Emphasis Type="Italic">n</Emphasis></Subscript>C<Subscript><Emphasis Type="Italic">n</Emphasis></Subscript> (<Emphasis Type="Italic">n</Emphasis> = 10–15) clusters

Density-functional theory with generalized gradient approximation for the exchange-correlation potential has been used to calculate the structural and electronic properties of Si _n C _n (n = 10–15) clusters. We find that the Si _n C _n clusters prefer cagelike structures. An extensive isomer search shows that the lowest-energy arrangements are those in which the silicon atoms and the carbon atoms form two distinct subunits. It is found that the carbon atoms favor to form fullerene-like structure due to the sp ²-like bond. The silicon atoms are trying to cope with an unfavorable sp ² environment, but distorted tetrahedra still show up somewhere of the cagelike structures. On the basis of the lowest-energy geometries obtained, the binding energy, HOMO–LUMO gap, Mulliken charge, ionization potential and electron affinity of the clusters have been computed and analyzed. An electronic charge transfer from the Si-populated to the C-populated regions is observed.     

170 keV Proton radiation effects on low-frequency noise of bipolar junction transistors

In this paper, the electrical properties and low-frequency noise for bipolar junction transistors irradiated by 170?keV proton are examined. The result indicates that for the sample under proton irradiation with fluence 1.25?×?10^14?p/cm², base current I_B in low bias range (V_BE < 0.7?V) increases due to superimposition of radiation-induced recombination current, while the gain decreases significantly. Meanwhile, the low-frequency noise increases in the proton-irradiated sample. By analysis of evolution of parameters extracted from low-frequency noise power spectra, it is demonstrated that radiation-induced noise is mainly originated from carrier fluctuation modulated by generation–recombination centers (G–R centers) located at the interface of Si/SiO₂, which are introduced by proton-radiation-induced defects. It is also confirmed that the electrical properties and noise behavior of irradiated sample are mostly affected by the carrier recombination process caused by G–R centers at the interface of Si/SiO₂ than by G–R centers in EB junctions.     

Two-photon excited intramolecular energy transfer and light-harvesting effect in novel dendritic systems

Two-photon absorption excited intramolecular energy transfer and light-harvesting effects are demonstrated in three novel dendritic systems. These systems contain both an antenna structure that can effectively absorb two-photon energy at approximately 800 nm and emit fluorescence at approximately 515 nm and a core moiety that can absorb one-photon energy at approximately 520 nm and emit at approximately 590 nm. Covalently combining the core and antenna functionalities intrinsically changes the optical behavior of the component pieces. The two-photon energy absorbed by the antenna structure is resonantly transferred to the core, where the core's emission intensity is enhanced by 8, 20, and 34 times for the three dendritic systems.     

A comparative in vitro study of the digestibility of heat- and high pressure-induced gels prepared from industrial milk whey proteins

We undertook this study to compare the digestibility of heat- and high pressure-induced gels produced from whey protein isolate (WPI). To simulate in vivo gastrointestinal digestion of WPI gels, a pepsin–trypsin digestion system was used. The in vitro protein digestibility of WPI gels induced by high pressure (400 MPa and 30 min; P-gel) and those induced by heat (80°C and 30 min; H-gel) was compared using a protein concentration of 0.14 g mL^?1. The in vitro protein digestibility of P-gels was significantly greater than that of H-gels (p<0.05). The size-exclusion chromatography profiles of the hydrolysates showed that the P-gel generated more and smaller peptides than natural WPI and H-gels. Furthermore, Sodium dodecyl sulfate–polyacrylamide gel electrophoresis analysis showed some soluble disulfide-mediated aggregation in the P-gel, while there was more insoluble aggregation in the H-gel than the P-gel. The P-gel was more sensitive to proteinase than the H-gel, which was related to the content of S–S bonds, and this in turn could be attributed to the differences in the gelation mechanism between the H-gel and P-gel.     

Study on the Interaction Between Oxymatrine and Tungstosilicic Acid by Resonance Rayleigh Scattering and Its Analytical Applications

In the 0.1 mol · L^?1 hydrochloric acid solution, oxymatrine reacted with tungstosilicic acid to form a 2:1 ion-association complexes. This results in a great enhancement of resonance Rayleigh scattering. The maximum resonance Rayleigh scattering wavelength was located at 393 nm. Resonance Rayleigh scattering intensity was proportional to the concentration of oxymatrine in the range of 1.5–26.4 µg · mL^?1, and the detection limit (3σ) was 0.23 µg · mL^?1. The optimum conditions and the effects of coexisting substances on the reaction were investigated. The method shows a wide linear range and high sensitivity, and was applied to the determination of oxymatrine in marine capsules and human urine samples with satisfactory results. Therefore, a highly sensitive, simple, and quick method has been developed for the determination of oxymatrine.     

Resonance Light Scattering Study on the Formation of a Manganese (II) Coordination Supramolecular Polymer and Its Analytical Application

The formation of a manganese (II) coordination supramolecular polymer was studied by resonance light scattering spectra for manganese (II) detection. Bis-sulfosalophen (a ditopic tetradentate Schiff base ligand) and bis-phenanthroline-glutaraldehyde (a ditopic bidentate ligand) were prepared for the construction of the supramolecular polymer. In a procedure of manganese (II) detection, manganese (II) ion reacts with bis-sulfosalophen to form a binuclear manganese (II) complex. The binuclear complex then self-assembles with bis-phenanthroline-glutaraldehyde to form the supramolecular polymer, resulting in the production of strong resonance light scattering signal. The amount of manganese was detected by measuring the resonance light scattering intensity. Under optimal conditions, a linear range was found to be 0.5–50.0 ng/mL, with a detection limit of 0.1 ng/mL. The method has been successfully applied to determine manganese in vegetable and tea samples with relative standard deviations of less than 5% and recoveries of 95.8–105.7%.