对在建标技术报告中正确贯彻《测量不确定度表示指南》的理解

针对计量人员在贯彻《测量不确定表示指南》,尤其是在撰写“建标技术报告”时遇到的一些体问题,进行了探讨。     

Synthesis, characterization and protein adsorption behaviors of PLGA/PEG di-block co-polymer blend films

A series of poly(D,L-lactic-co-glycolic acid) (PLGA)/poly(ethyleneglycol) (PEG) di-block copolymers were synthesized by ring-opening polymerization of D,L-lactide and glycolide with different molecular weights of monomethoxy polyethyleneglycol (mPEG) 750, 2000 and 5000 as an initiator. The bulk properties of these co-polymers were characterized by using 1H NMR spectroscopy, gel permeation chromatography, differential scanning calorimetry (DSC). Electron spectroscopy for chemical analysis (ESCA) results, in which the blend films with the di-block copolymers showed increasing surface oxygen atomic percentage with increasing PEG chain length, indicate that PEG chain segment in the di-block copolymers is surface oriented and enriched onto the surface of the blend films. The extent of protein adsorption onto the surface of these blend films was studied, using iodine radio-labeled human serum albumin, gamma globulin and human growth hormone. The protein adsorption amount was reduced for the blend films prepared with PLGA/PEG 750 and 2000 di-block copolymers, but increased to a great extent for PLGA/PEG 5000 di-block copolymer. This is due to the increased water uptake capacity of the blend film, which absorbed more protein molecules into a swollen polymer matrix in addition to surface adsorption.     

重质油胶体聚集结构的耗散粒子动力学模拟

重质油是以沥青质为胶核分散于饱和油分中形成的极其复杂的胶体体系.本文采用耗散粒子动力学(DPD)方法研究重质油的胶体结构及其影响因素.根据重质油各组分的分子结构特征,构建了描述重质油组分的粗粒化模型化合物.模拟结果表明,本文构建的粗粒化模型能很好地反映重质油的胶体聚集结构.沥青质分子结构对胶体聚集结构有序性有显著影响,较高稠合程度的芳香环结构将使胶束结构有较高的有序性,烷基侧链则表现出分散作用.重质油中的胶质具有胶溶作用,胶质与沥青质的浓度比存在一个极限,当小于这个极限时,重质油将出现聚沉.     

海泡石原位晶化合成NaY分子筛的研究

首次用海泡石为硅源、高岭土为铝源,在水热条件下原位晶化合成NaY分子筛,采用粉末X射线衍射仪、电子扫描电镜等测试手段对所合成样品进行表征分析,着重考察晶化温度和投料配比对产品相对结晶度的影响.研究结果表明,NaY分子筛的形成受晶化温度的影响最大,随温度的升高,产品的相对结晶度显著提高,晶化温度升至100℃时,得到结晶度较高的NaY分子筛晶体.在原位晶化体系中,随n(SiO2)/n(Al2O3)减小,其相对结晶度增大;增加体系的n(Na2O)/n(SiO2)和减小n(H2O)/n(Na2O)都增大产品的相对结晶度;n(SiO2)/n(Al2O3)在投料比影响因素中占主导地位.     

层状二氧化锰和2,2'-联吡啶铁自组装膜的制备和光电性能研究

采用静电吸附层-层自组装方法制备了层状二氧化锰/2,2'-联吡啶铁自组装膜材料,借助扫描电镜(SEM),紫外可见光谱(UV-Vis)和电化学工作站等测试手段对自组装膜的结构与性能进行了表征.结果表明,该自组装膜具有均匀的表面和紧密的层状结构,在可见光照射条件下该自组装膜电极的氧化还原电流明显增加了.层状二氧化锰/2,2'-联吡啶铁自组装膜电极,在可见光照射条件下光电降解有机染料罗丹明B(1×10-5mol/L)反应80min降解率达到了57%.     

New Guaipyridine Sesquiterpene Alkaloids from Artemisia rupestris L.

Three new guaipyridine sesquiterpene alkaloids, rupestine A, B, C ( 1 – 3 , resp.), and the new nor‐sesquiterpne alkaloid rupestine D ( 4 ) were obtained from the flowers of Artemisia rupestris L. Their structures were elucidated on the basis of sepectroscopic data and by comparison with those of the related compounds reported in the literature. In addition, the absolute configurations of 2 and 4 were determined by single‐crystal X‐ray diffraction analyses.     

Spatially Controllable DNA Condensation by a Water‐Soluble Supramolecular Hybrid of Single‐Walled Carbon Nanotubes and β‐Cyclodextrin‐Tethered Ruthenium Complexes

A supramolecular hybrid is prepared by the supramolecular surface modification of single‐walled carbon nanotube (SWCNT) with cationic β‐cyclodextrin‐tethered ruthenium complexes through a spacer molecule that contains both an adamantane and a pyrene moiety. By employing the supramolecular hybrid, spatially controllable DNA condensation along the SWCNT skeleton is achieved by anchoring cationic ruthenium complexes on the surface. Furthermore, because of the unique physiological properties of SWCNTs, the cationic supramolecular hybrid can be used as a nonviral gene delivery system with the ruthenium complexes as a fluorescent probe to monitor uptake of DNA by cells.     

Hydrodynamic chromatography of polystyrene microparticles in micropillar array columns

We report on the possibility to perform HDC in micropillar array columns and the potential advantages of such a system. The HDC performance of a pillar array column with pillar diameter = 5 μm and an interpillar distance of 2.5 μm has been characterized using both a low MW tracer (FITC) and differently sized polystyrene bead samples (100, 200 and 500 nm). The reduced plate height curves that were obtained for the different investigated markers all overlapped very well, and attained a minimum value of about h_min = 0.3 (reduction based on the pillar diameter), corresponding to 1.6 μm in absolute value and giving good prospects for high efficiency separations. The obtained reduced retention time values were in fair agreement with that predicted by the Di Marzio and Guttman model for a flow between flat plates, using the minimal interpillar distance as characteristic interplate distance.     

Experimental study of the depth influence on the band broadening effect in a cyclo-olefin polymer column containing an array of ordered pillars

An experimental study of a micromachined non-porous pillar array column performance under non-retentive conditions is presented. The same pillar structure has been fabricated in cyclo-olefin polymer (COP) chips with three different depths via hot embossing and pressure-assisted thermal bonding. The influence of the depth on the band broadening along with the already known contribution arising from the top and bottom cover plates has been studied. The experimental results exhibit reduced plate heights as low as 0.2, which are in agreement with the previous experimental work. Moreover, the constant values of the reduced Van Deemter expression are also in accordance with the previous studies. A more exhaustive study of the C-term band broadening is also presented, showing that comparing the space between the pillars with different open tubular rectangular channels offers a good estimation of the C-term band broadening that is obtained experimentally. These experimental results, hence, confirm that micromachined pillar array columns fabricated in COP can achieve the same performance as the ones fabricated in silicon for the presently studied pillar channel design.     

Excited‐State Dynamics of the Metal String Complex Co3(dpa)4(NCS)2 from Femtosecond Transient Absorption Spectra

Transient absorption spectroscopy is used to study the excited‐state dynamics of Co₃(dpa)₄(NCS)₂, where dpa is the ligand di(2‐pyridyl)amido. The ππ*, charge‐transfer, and d–d transition states are excited upon irradiation at wavelengths of 330, 400 and 600 nm, respectively. Similar transient spectra are observed under the experimental temporal resolution and the transient species show weak absorption. We thus propose that a low‐lying metal‐centered d–d state is accessed immediately after excitation. Analyses of the experimental kinetic traces reveal rapid conversion from the ligand‐centered ππ* and the charge‐transfer states to this metal‐centered d‐d state within 100 fs. The excited molecule then crosses to a second d–d state within the ligand‐field manifold, with a time coefficient of 0.6–1.4 ps. Because the ground‐state bleaching band recovers with a time coefficient of 10–23 ps, we propose that an excited molecule crosses from the low‐lying d–d state either directly within the same spin system or with spin crossing via the state ²B to the ground state ²A₂ (symmetry group C₄). In this trimetal string complex, relaxation to the ground electronic surface after excitation is thus rapid.