Hydroxyapatite coating on porous silicon substrate obtained by precipitation process

Hydroxyapatite Ca₁₀(PO₄)₆(OH)₂ (HAP) is known as a bioactive and biocompatible material, HAP coatings were used to improve the biocompatible of substrate by many researcher, In this work, HAP thin films on porous silicon (PS) substrates have been prepared by aqueous precipitation method with rapid thermal annealing (RTA) processes. The HAP films had been prepared under the annealing temperature ranging from 300 to 1000 °C. By the measurement of X-ray diffraction (XRD), it was found that for the crystallinity optimization, the heat-treatment at 850–950 °C for 1 h would be favorable. Atomic force microscopy (AFM) and scanning electron microscope (SEM) measurements reveal a dense and smooth surface of the HAP film, and tightly adherence of the coating on porous silicon substrate after sintered. Thus, by this method, porous silicon could be increased its bioactivity and so that could be used in the biomedical area.     

MEASUREMENTS OF Fe AND Cu K-Shell IONIZATION CROSS SECTIONS BY SLOW ELECTRON IMPACT

ＭＥＡＳＵＲＥＭＥＮＴＳＯＦＦｅＡＮＤＣｕＫ－ＳｈｅｌＩＯＮＩＺＡＴＩＯＮＣＲＯＳＳＳＥＣＴＩＯＮＳＢＹＳＬＯＷＥＬＥＣＴＲＯＮＩＭＰＡＣＴＬｉＴａｉｈｕａＡｎＺｈｕＬｕｏＺｈｅｎｇｍｉｎｇＣｅｎｔｅｒｆｏｒＲａｄｉａｔｉｏｎＰｈｙｓｉｃｓ，Ｉｎｓ...     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

二元合金微观偏析的相场法数值模拟

使用耦合溶质场的相场模拟研究了Ni-Cu二元合金枝晶生长过程中固相溶质扩散系数D_s 对枝晶形貌和微观偏析等的影响.计算结果表明，随着D_s的减少，固液界 面前沿溶质扩散层越薄，枝晶生长越有利，枝晶尖端生长的速度越大，侧向分支越发达；D< sub>s越小，固相中溶质成分的波动越强烈，随着D_s的增大，固相中溶质 成分的波动相应减小；溶质微观偏析程度随D_s的增大而减小. 关键词： 相场方法 微观偏析 固相扩散系数 数值模拟     

Preparation and characterization of optically active polystyrene via a chiral nitroxide‐mediated polymerization

2,2,6,6‐Tetramethyl‐4‐[d‐(+)‐10‐camphorsulfonyl]‐1‐piperidinyloxy was synthesized and used as a chiral nitroxide for the bulk polymerizations of styrene initiated with benzoyl peroxide (BPO), tetraethylthiuram disulfide (TETD), and thermal initiation. The results showed that the polymerizations proceeded in a controlled/living way; that is, the kinetics presented approximately first‐order plots, and the number‐average molecular weights of the polymers with narrow molecular weight distributions (weight‐average molecular weight/number‐average molecular weight) increased with the monomer conversion linearly. The molecular weight distributions in the case of thermal initiation were narrower than those in the case of BPO and TETD, whereas the polymerization rate with BPO or TETD as an initiator was obviously faster than that with thermal initiation. In addition, successful chain‐extension reactions were carried out, and the structures of the obtained polymers were characterized by gel permeation chromatography and ¹H NMR. The specific rotations of the polymers were also measured by polarimetric analysis. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1522–1528, 2006     

半导体激光泵浦预激光锁模调Q固体激光器研究

报道半导体激光侧面泵浦预激光锁模调Ｑ的Ｎｄ：ＹＡＧ固体板条激光器，预激光锁模调Ｑ的激光脉冲宽度为３６ｐｓ，调Ｑ包纤各心的锁模单脉冲能量超过７μＪ，相应的峰值功率达２００ｋＷ。     

Riemannian geometry of strong-laser plasma

The optical metric for a strong-laser plasma is derived. The affine connection and curvature related to the optical metric are given and their spatial distributions are studied numerically.     

The convergence rate of Euler means sequence

Let denote the Euler means of the Fourier series of the 2π-perodic function f(x). For an integer q>0, setting ℰ _nq (ω)=sup‖f−ℰ _n (q,f)‖, the precise value of is obtained.