层柱催化剂［Zn_2Al（OH）_2］［SiW_（11）O_（39）Co（H_2

层柱催化剂［Ｚｎ_２Ａｌ（ＯＨ）_２］［ＳｉＷ_（１１）Ｏ_（３９）Ｃｏ（Ｈ_２Ｏ）］_（０．８３）４Ｈ_２Ｏ的合成新途径及其对苯甲醛Ｈ_２Ｏ_２氧化的催化活性胡长文，贺庆林，张云峰，张继余，王恩波（东北师范大学化学系，长春１３００２４）关键词层柱催化剂，苯?..     

EFFECT OF MOLECULAR WEIGHT OF PDMS ON MORPHOLOGY AND MECHANICAL PROPERTIES OF PP/PDMS BLENDS

 A series of polydimethylsiloxane (PDMS) with varied molecular weights (Mw = 3  106, 1  106 and 0.5  106) were melt blended with PP to investigate the effect of PDMS molecular weight (MW) on the morphology and mechanical properties of PP/PDMS blends. Scanning electron microscopic (SEM) examination showed that the size of PDMS domains was dependent on the MW of PDMS. It was found that the lower the value of PDMS MW, the better dispersion of the PDMS domains in the PP matrix. Tensile and Izod impact tests revealed that the addition of PDMS with lower MW would lead to a more significant increase in impact strength of the blends compared with the blends with higher MW ones, while the influence of the molecular weight on tensile strengths of the blends was relatively small in the MW range studied. Differential scanning calorimetry (DSC) results also showed that the crystallization temperature of PP was increased with decreasing PDMS MW, indicating a better nucleation capability of lower MW of PDMS. Melting flow rate (MFR) measurements indicated that the processibility of PP could be enhanced by adding PDMS, and again the lower MW PDMS resulted in better data. Our work demonstrates that not only the processibility but also the mechanical properties of PP could be enhanced to a more significant degree by using low MW PDMS than the higher ones.     

强酸阳离子交换树脂催化性能的研究

通过叔丁醇脱水生成异丁烯的反应研究对比了国内外常见种类的凝胶型和大孔型强酸阳离子交换树脂的催化性能，并对树脂的性质，预处理方法，以及其用量和再生程度等因素对树脂催化活性的影响进行了研究。在此基础上，合成了具有较高催化活性的新型大孔强酸阳离子交换树脂。     

聚氯乙烯—丁腈橡胶—氯丁橡胶三元共混物的研究

测定了聚氯乙烯（ＰＶＣ）－丁脯橡胶（ＮＢＲ－２９）－氯丁橡胶（ＣＲ）三元共混物的冲击性能和应力－应变行为，用动态力分析、扫描电和透射电镜研究了共混物的相容性和形态结构。结果表明，ＮＢＲ－２９对ＰＶＣ，ＣＲ有良好的增容作用，三元共混物是部分相容的二相体系，具有良好的抗冲击性能。     

固定HCG抗体膜的跨膜电位

高分子膜作为一项新兴技术,在很多领域得到日益广泛的应用.近十几年,随着生物工程和生物传感器的迅速发展,高分子生物功能膜的研究倍受重视.高分子生物功能膜是采用固定化技术,将具有分子识别功能的材料(如酶、抗原、抗体等)固定在高分子膜上而制得的.在固定化膜表面发生的生物化学反应,可以引起膜的荷电状态的变化,从而导致跨膜电位的变化。有关固定化膜的报导较多,但主要限于固定化的方法及其应用方面的研究,而有关高分     

Ge—132与稀土离子的配合物及其对单核苷酸磷酯键的催化水解作用

Ｇｅ－１３２的羧酸阴离子与稀土离子螯合配位，生成３：１型配合物，在配合物中，Ｇｅ－１３２的ＧｅＯ３／２基团水解为Ｇｅ（ＯＨ）３，并且不参与稀土配位，系列稀土离子配合物的结构性质基本相同，在５０℃，ｐＨ值为６的水溶液中，该配合物选择性地催化５’－ＡＭＰ或５‘－ｄＡＭＰ的磷酯键水解断裂、生成相应的核苷和磷酸，而不影响碱基与戌糖之间的苷键。     

The Effects of M2O3 on Stabilizing Monocopper over the Surface of Cu-ZnO-M2O3 Catalysts for Mathanol Synthesis

The effects of M₃O₃ (M = Al, Sc etc.) in Cu-ZnO-M₂O₃ catalysts on methanol synthesis at low pressure were studied with ESR, XPS and TPR spectroscopy. The results of ESR showed that the generation of monovalent cationic defects was because the valence state and electronic charge on the ZnO lattice lost their balance as M³⁺ doped into ZnO. The induced effect by Sc³⁺ is stronger than that by Al³⁺. The results of XPS and TPR indicated that the amount and stabilization of Cu⁺ on the surface of reduced copper-based catalyst and its catalytic activity were affected by the monovalent cationic defects on the surface of ZnO.     

硫化物纳米级粒子化膜的形成与气相性质的影响

采用偏振光反光度、紫外及可见光谱、电子显微镜形貌观察、粒子大小测定及电子衍射等方法加以系统研究硫化锌纳米级粒子化膜的制备与气相性质的影响．     

4—叔丁基—β—氯—α甲基肉桂醛的合成

从苯和叔丁醇出发，经过３步反应合成得标题化合物，总收率在６８％以上。     

Determination of V(V), Nb(V) and Ta(V) as their 2-(5-bromo-2-pyridylazo)-5-diethylaminophenol chelates by reversed-phase HPLC

This paper reports the separation and determination of V(V), Nb(V) and Ta(V) by RP-HPLC using 5-Br-PADAP as a precolumn derivatizing reagent. On C(18) column, the three metal chelates can be separated on a baseline in 9 min with the mobile phase of methanol-water (59:41, v/v) containing tartaric acid (0.2%) and acetate buffer (pH 3.5, 10 mM). The detection limits of V(V), Nb(V) and Ta(V) are 0.13 ppb, 0.22 ppb and 1.79 ppb, respectively when S/N is 3. This method is simple and rapid, and has been used in mineral analysis with satisfactory results.