Broadband spectral shaping in a Ti:sapphire regenerative amplifier

A birefringent crystal quartz plate of known thickness has been used as a spectral filter for spectral shaping in a Ti:sapphire regenerative amplifier. The spectral profile of the amplified pulse ejected from the regenerative amplifier was observed while adjusting the birefringent crystal plate in the cavity. By altering the gain spectrum, the bandwidth of the regeneratively amplified pulse was increased from 18 to 35 nm by using a 0.34-mm thick birefringent plate. The output pulse spectrum from the regenerative amplifier neared the bandwidth of the seed pulse. As a comparison, we used a coated filter outside the regenerative amplifier cavity, and the bandwidth of the regeneratively amplified pulse was stretched to 28 nm. When the bandwidth was stretched to 35 nm, the pulse was compressed to 35 fs.     

A Comparative Study on Dynamic and Static Sparsity Patterns in Parallel Sparse Approximate Inverse Preconditioning

Sparse approximate inverse (SAI) techniques have recently emerged as a new class of parallel preconditioning techniques for solving large sparse linear systems on high performance computers. The choice of the sparsity pattern of the SAI matrix is probably the most important step in constructing an SAI preconditioner. Both dynamic and static sparsity pattern selection approaches have been proposed by researchers. Through a few numerical experiments, we conduct a comparable study on the properties and performance of the SAI preconditioners using the different sparsity patterns for solving some sparse linear systems. This revised version was published online in July 2006 with corrections to the Cover Date.     

Kinetics of phenyl radical reactions with propane,n‐butane,n‐hexane,and n‐octane: Reactivity of C6H5 toward the secondary C?H bond of alkanes

The kinetics of C₆H₅ reactions with n‐C_nH_2n+2 (n = 3, 4, 6, 8) have been studied by the pulsed laser photolysis/mass spectrometric method using C₆H₅COCH₃ as the phenyl precursor at temperatures between 494 and 1051 K. The rate constants were determined by kinetic modeling of the absolute yields of C₆H₆ at each temperature. Another major product C₆H₅CH₃ formed by the recombination of C₆H₅ and CH₃ could also be quantitatively modeled using the known rate constant for the reaction. A weighted least‐squares analysis of the four sets of data gave k (C₃H₈) = (1.96 ± 0.15) × 10¹¹ exp[?(1938 ± 56)/T], and k (n‐C₄H₁₀) = (2.65 ± 0.23) × 10¹¹ exp[?(1950 ± 55)/T] k (n‐C₆H₁₄) = (4.56 ± 0.21) × 10¹¹ exp[?(1735 ± 55)/T], and k (n?C₈H₁₈) = (4.31 ± 0.39) × 10¹¹ exp[?(1415 ± 65)T] cm³ mol^?1 s^?1 for the temperature range studied. For the butane and hexane reactions, we have also applied the CRDS technique to extend our temperature range down to 297 K; the results obtained by the decay of C₆H₅ with CRDS agree fully with those determined by absolute product yield measurements with PLP/MS. Weighted least‐squares analyses of these two sets of data gave rise to k (n?C₄H₁₀) = (2.70 ± 0.15) × 10¹¹ exp[?(1880 ± 127)/T] and k (n?C₆H₁₄) = (4.81 ± 0.30) × 10¹¹ exp[?(1780 ± 133)/T] cm³ mol^?1 s^?1 for the temperature range 297‐‐1046 K. From the absolute rate constants for the two larger molecular reactions (C₆H₅ + n‐C₆H₁₄ and n‐C₈H₁₈), we derived the rate constant for H‐abstraction from a secondary C? H bond, k_s?CH = (4.19 ± 0.24) × 10¹⁰ exp[?(1770 ± 48)/T] cm³ mol^?1 s^?1. © 2003 Wiley Periodicals, Inc. Int J Chem Kinet 36: 49–56, 2004     

Effects of barium on the nonlinear electrical characteristics and dielectric properties of SnO2-based varistors

The effects of barium on electrical and dielectric properties of the SnO_2·Co_2O_3·Ta_2O_5 varistor system sintered at 1250℃ for 60min were investigated. It is found that barium significantly improves the nonlinear properties. The breakdown electrical field increases from 378.0 to 2834.5V/mm, relative dielectric constant (at 1kHz) falls from 1206 to 161 and the resistivity (at 1kHz) rises from 60.3 to 1146.5kΩ·cm with an increase of BaCO_3 concentration from 0mol% to 1.00mol%. The sample with 1.00mol% barium has the best nonlinear electrical property and the highest nonlinear coefficient (α=29.2). A modified defect barrier model is introduced to illustrate the grain-boundary barrier formation of barium-doped SnO_{2}-based varistors.     

Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Influence of Turbid Medium Parameters on Back Scattered Intensity and Pulsewidth of Picosecond Pulse

In this paper, we simulate a practical in vivo technique in which is produced influence of turbid medium parameters on backscattered intensity and pulsewidth of picosecond for turbid tissue surface of a semiinfinite medium by a small narrow linewidth laser beams. It is shown that the interaction of the ultra short pulse and the turbid tissue is very used as researching the optical parameters of the turbid medium.     

Bio-antioxidant of Anthraquinone Derivatives

The Rubiaceae family is well known for containing anthraquinones. More specifically, lapachol and its analogues are known to possess antitumor, antibiotic, antimalarial and antiulceric activities.[1] Several report indicated that some quinones containing OH in its structure were found to have higher bio-activity than quinines lacking the OH group.     

On the evaluation of the nonisothermal kinetic parameters of (GeS2)0.3(Sb2S3)0.7 crystallization using the IKP method

The isoconversional method suggested by Friedman and the invariant kinetic parameters method (IKP) were used in order to examine the kinetics of the nonisothermal crystallization of (GeS₂)_0.3(Sb₂S₃)_0.7. The objective of the paper is to show the usefulness of the IKP method both for determining the activation parameters as well as the model of the investigated process. It was shown that the kinetic triplet [(E, A, f(α), where E is the activation energy, A is the preexponential factor, and f(α) is the differential function of conversion], which results through the application of the IKP method, depends on the set of kinetic models considered. For different sets of kinetic models, proportional values of f(α) are obtained. A criterion for the selection of this set, the use of which lead to the true kinetic triplet corresponding to the analyzed process (E = 163.2 kJ mol^?1; A = 2.47 × 10¹² min^?1 and the Avrami‐Erofeev model, A_m, for m = 2.5–2.6 was suggested. © 2004 Wiley Periodicals, Inc. Int J Chem Kinet 36: 309–315, 2004     

Pervaporation of benzene/cyclohexane mixtures using ion-exchange membrane containing copper ions

The sorption, diffusion, and pervaporation (PV) properties of benzene/cyclohexane (Bz/Cx) mixtures on cation-exchange membranes containing copper ions (Cu(II)) were investigated. The equilibrium sorption isotherms of pure vapors in the membranes and the partial solubility of binary solutions in the membranes were described using the UNIQUAC model. The τ_iM and τ_Mi values were 0.978 and 0.591 for Bz, and 0.922 and 0.475 for Cx. The transient regimes of vapor sorption were employed to calculate the concentration-dependent diffusion coefficients. Long’s model sufficiently explained the diffusivity of Bz and Cx in the membranes. The pre-exponential factors were 3×10⁻¹³ m²/s and the plasticization factors were 3.0 and 3.6 for Bz and Cx, respectively. Excellent agreement was found with the experimental results applying the solubility and diffusivity data to simulate the pervaporation performance (flux and selectivity) using the modified Maxwell–Stefan equation. The membrane containing Cu(II) demonstrates better facilitating capability for Bz transport than that with Na(I), mainly due to its preferential sorption property toward Bz. Replacing Na(I) with Cu(II) into a Neosepta membrane resulted in better separation efficiency and higher Bz flux throughout the entire Bz concentration range.     

多元χ演算运行时错误的不可判定性

针对多元χ演算运行时刻通信安全的判定性问题进行了研究．通过从Lazyλ项到χ项的编码，将判定一个Lazyλ项是否有范式的问题归约为进程是否有通信错误的问题．证明了在多元χ演算中，通讯错误也是不可判定的．结论说明不存在算法直接来检测进程的通信安全性，而只有通过其他间接的手段(如构造类型系统)才能部分达到预防运行时错误的目的．