反相高效液相色谱法测定肾复康胶囊中的野黄芩苷和芦丁

建立了肾复康胶囊中野黄芩苷和芦丁的反相高效液相色谱测定方法。以甲醇-水为提取溶剂,采用超声提取法对样品进行前处理。以0.02 mol/L磷酸二氢钾缓冲溶液(含1.0％（体积分数）冰醋酸)-甲醇（体积比为63∶37）为流动相,于330 nm波长下检测,肾复康提取液中野黄芩苷和芦丁可达基线分离,分析时间在20 min内。野黄芩苷和芦丁在10 ~300 mg/L内,其峰面积与浓度之间线性关系良好,目标物的加标回收率大于98％。该方法适用于肾复康胶囊及相关药材中野黄芩苷和芦丁黄酮类化合物的测定和质量控制。     

沥青基球状活性炭气相吸脱附行为研究

本文利用热重法研究了一系列沥青基球状活性炭对蒸汽及正已烷蒸汽的动态吸脱附曲线。结果表明,PSAC对苯蒸汽的吸附及再生性能优良。随吸附温度的降低、比表面积的增大、总孔容及微孔容的增大,PSAC对苯蒸汽的吸附容量增大。PSAC对正已烷的吸附速度大于对苯蒸汽的吸附速度,但其对正已烷的平衡吸附容量小于对苯蒸汽的平衡吸附容量。     

An efficient high-speed counter-current chromatography method for the preparative separation of sesquiterpenoids from the rhizomes of Cyperus rotundus L. combined with evaluation of the anti-inflammation activity in vitro and molecular docking

Cyperus rotundus L. has been extensively used in ancient medication for the treatment of different disorders worldwide, in which sesquiterpenes are the most representative components. In this study, sesquiterpenes were effectively purified by two-dimensional counter-current chromatography in combination with continuous injection and inner-recycling mode with a solvent system of n-hexane/ethyl acetate/methanol/water (1:0.2:1:0.2, v/v/v/v). For one-dimension separation, continuous injection mode was used with three times injection and the inner-recycling mode was adopted for the separation of two mixtures for two-dimensional separation. Finally, four sesquiterpenoids, including scariodione ( 1 ), cyperenoic acid ( 2 ), scariodione ( 3 ), and α-cyperone ( 4 ), were obtained with purities over 98%. Mass spectrometry and nuclear magnetic resonance were applied to identify their structures. The results from the anti-inflammation effect with zebrafish demonstrated that cyperenoic acid exhibited stronger anti-inflammation activity. Molecular docking results suggested that cyperenoic acid possessed lower binding energies –9.4545 kcal/mol with 1CX2 to form formed hydrogen bond interaction with ARG120. In general, all the obtained findings proved that the strong anti-inflammation capacity of cyperenoic acid can have the potential of being adopted for treating diseases resulting from inflammation.     

Combined effect of chemically compound graphene oxide‐calcium pimelate on crystallization behavior,morphology and mechanical properties of isotactic polypropylene

The combined nucleation effect of graphene oxide (GO) and calcium pimelate (CaPi) which are chemically compound together (expressed in GO ? CaPi) in isotactic polypropylene (iPP) was investigated. Fourier transform infrared (FTIR), X‐ray diffraction (XRD) and thermogravimetric analysis (TGA) verified that CaPi was chemically compound with GO by chelate bonds. The crystallization behavior and crystalline morphologies of iPP nucleated with different mass ratio of GO and CaPi were investigated. The crystallization peak temperature of iPP nucleated with 0.2 wt% GO ? CaPi with the mass ratio of 1:5 (GO1 ? C5) was increased by 8.3°C when compared with that of pure iPP, and the relative content of β‐crystal reached up to 0.7962. Whereas, the crystallization peak temperature of iPP nucleated with 0.2 wt% GO and CaPi which are blended together by mechanical force (expressed in GO + CaPi) with the mass ratio of 1:5 (GO1 + C5) was only increased by 5.0°C. It was attributed to that the aggregation of GO + CaPi caused the decrease of the crystallization peak temperature, while the GO1 ? C5 uniformly dispersed in the iPP matrix. Unexpectedly, the relative content of β‐crystal of iPP nucleated with 0.02 wt% GO1 ? C5 reached up to 0.8094, and the crystallization peak temperature was increased by 6.7°C compared with that of pure iPP. Meanwhile, the impact strength, tensile strength and heat deflection temperature of iPP nucleated with 0.02 wt% GO1 ? C5 increased by almost 45.86%, 2.03% and 7.7°C, respectively. The iPP nucleated with GO1 ? C5 obtained a balance between stiffness and toughness and the thermo‐mechanical property of nucleated iPP was improved.     

Triple Self‐Sorting in Constitutional Dynamic Networks: Parallel Generation of Imine‐Based CuI,FeII, and ZnII Complexes

Three imine‐based metal complexes, having no overlap in terms of their compositions, have been simultaneously generated from the self‐sorting of a constitutional dynamic library (CDL) containing three amines, three aldehydes, and three metal salts. The hierarchical ordering of the stability of the three metal complexes assembled and the leveraging of the antagonistic and agonistic relationships existing between the constituents within the constitutional dynamic network corresponding to the CDL were pivotal in achieving the sorting. Examination of the process by NMR spectroscopy showed that the self‐sorting of the Fe^II and Zn^II complexes depended on an interplay between the thermodynamic driving forces and a kinetic trap involved in their assembly. These results also exemplify the concept of “simplexity”—the fact that the output of a self‐assembling system may be simplified by increasing its initial compositional complexity—as the two complexes could self‐sort only in the presence of the third pair of organic components, those of the Cu^I complex.     

Two‐Step Oxidation Synthesis of Sulfur with a Red Aggregation‐Induced Emission

Sulfur is not normally considered a light‐emitting material, even though there have been reports of a dim luminescence of this compound in the blue‐to‐green spectral region. Now, it is shown how to make red‐emissive sulfur by a two‐step oxidation approach using elemental sulfur and Na₂S as starting materials, with a high photoluminescence quantum yield of 7.2 %. Polysulfide is formed first and is partially transformed into Na₂S₂O₃ in the first step, and then turns back to elemental S in the second step. The elevated temperature and relatively oxygen‐deficient environment during the second step transforms Na₂S₂O₃ into Na₂SO₃ incorporated with oxygen vacancies, thus resulting in the formation of a solid‐state powder consisting of elemental S embedded in Na₂SO₃. It shows aggregation‐induced emission properties, attributed to the influence of oxygen vacancies on the emission dynamics of sulfur by providing additional lower energy states that facilitate the radiative relaxation of excitons.     

Charge‐Induced Unzipping of Isolated Proteins to a Defined Secondary Structure

Here we present a combined experimental and theoretical study on the secondary structure of isolated proteins as a function of charge state. In infrared spectra of the proteins ubiquitin and cytochrome c, amide I (C=O stretch) and amide II (N–H bend) bands can be found at positions that are typical for condensed‐phase proteins. For high charge states a new band appears, substantially red‐shifted from the amide II band observed at lower charge states. The observations are interpreted in terms of Coulomb‐driven transitions in secondary structures from mostly helical to extended C₅‐type hydrogen‐bonded structures. Support for this interpretation comes from simple energy considerations as well as from quantum chemical calculations on model peptides. This transition in secondary structure is most likely universal for isolated proteins that occur in mass spectrometric experiments.     

Relationship between grain boundary diffusion in nanocrystals and amorphous microstructure

The effects of microstructure on diffusion behaviors of Ni in Zr₄₈Cu₃₆Ag₈Al₈ alloy were investigated by transmission electron microscope and secondary ion mass spectrum. The temperature dependence of Ni diffusivities in Zr₄₈Cu₃₆Ag₈Al₈ alloy with different states (metallic glass, nanocrystals and coarse crystals) has been measured in the temperature range of 693–723 K. The results show that diffusion behavior is microstructure dependence, and the relations between the microstructure and diffusion are discussed. The activity energy of the grain boundary diffusion in nanocrystals calculated by the Suzuoka solution is about 1.433 eV/atom. It is equivalent with that of metallic glass, which is attributed to the similar microstructure between the two. Copyright © 2016 John Wiley & Sons, Ltd.     

A Mini Review on the Functional Biomaterials Based on Poly(lactic acid) Stereocomplex

Poly(lactic acid) stereocomplex (sc-PLA) prevails over homo-poly(lactic acid)s in many aspects and showed great potential as biomaterials depending on its extraordinary biological, thermal, and mechanical properties. In the past few years, sc-PLA has gained tremendous attention as a new approach to the development of new types of functional biomaterials. This paper summarizes recent progress in the application of the concept of sc-PLA in the design and fabrication of stabilized nanoparticles and in situ gelling hydrogels for biomedical applications.     

Ultrathin Alternating Copolymer Nanotubes with Readily Tunable Surface Functionalities

Well‐defined ultrathin nanotubes (30 nm in diameter and of micrometer‐scale length) were generated through the self‐assembly of a novel alternative copolymer synthesized using an epoxy–thiol click‐chemistry reaction. The self‐assembly mechanism was investigated both by experiments and using dissipative particle dynamics (DPD) simulations. The obtained nanotubes can be readily functionalized with carboxy groups, amino groups, peptides, or other groups by simple modular click copolymerization.