硫胺的燐光研究

硫胺无燐光，在碱中氧化后才产生燐光。 λ激发＝３００ｎｍ，λ发射＝４１０ ｎｍ，燐光寿命为１．３ｓ．硫胺燐光受溶剂极性影响甚小，１５种金属离子中只有铜离子可增强流胺燐光，寿命变短为 ０． ９４ ｓ，但不影响燐光光谱。在开始３０ｍｉｎ内有ＣｕＳＯ４的作用较快，以后逐渐变慢，到 ４ｈ后达平衡与不用ＣｕＳＯ４的燐光相近，启示ＣｕＳＯ４具有催化硫胺的氧化作用，建立了硫胺的燐光分析方法，用于两种维生素Ｂ１片的分析，分别为９８．５％与９８％。     

PA.FPNS: its synthesis and use in spectrophotometric determination of magnesium

A new polymeric chromogenic reagent PA.FPNS has been synthesized by condensing polyallylamine (PA) with 3-(4-formylphenylazo)-4,5-dihydroxynaphthalene-2,7-disulfonic acid (FPNS) and its properties studied. In alkaline media, PA.FPNS reacts with magnesium to form a water-soluble blue complex, whose absorption maximum is at 604 nm. The molar absorptivity (varepsilon) of the complex is 5.2 x 10(4)l mol(-1) cm(-1), which is four times that of the FPNS-Mg complex, and Beer's law is obeyed over the range 0-0.35 mug ml(-1) magnesium. Compared to the corresponding low-molecular-weight FPNS and other chromogenic reagents, PA.FPNS offers considerably improved sensitivity and selectivity for magnesium, which may be attributed to incorporating FPNS into a water-soluble polymer and the effect of the polymeric chain on the reaction microenvironment. Also, a simple and sensitive spectrophotometric method for the determination of magnesium has been developed and applied to water and human fluid samples with satisfactory results.     

Oligodeoxyribonucleotide analogues with bridging dimethylene sulfide,sulfoxide, and sulfone groups. Toward a second-generation model of nucleic acid structure

Short DNA analogues with bridging dimethylene sulfide, sulfoxide, and sulfone groups replacing the phosphate diesters (S-DNAs) were synthesized from building blocks prepared via two routes, both starting from D-glucose. Building blocks for RNA analogues were prepared by stereoselective introduction of nucleobase into a 2'-acylated ribose analogue. The ribose analogues were converted to deoxyribose analogues by replacement of a 3'-OH group by a thioacetyl unit, followed by photolytic deoxygenation or radical-based 2'-deoxygenation. DNA analogues joined via CH(2)(-)S-CH(2) units were prepared by S(N)2 displacement of a 6'-mesyl group on one building block using a thiolate nucleophile of another. 4,4'-Dimethoxytrityl protection and deprotection schemes were established for both the thiol and hydroxyl groups. The corresponding sulfoxide DNA analogues were obtained by oxidation with hydrogen peroxide. Sulfone DNA analogues were obtained by oxidation of the sulfide DNA with persulfate or hydrogen peroxide in the presence of a titanium silicate catalyst. The physical properties of several representative oligonucleotide analogues were examined, and interpreted in light of a "second-generation" model for DNA strand-strand recognition, a model that emphasizes the role of the polyanionic backbone in diminishing unwanted tendencies of highly functionalized molecules to form "structure" in solution. Even short sulfide-linked DNA analogues displayed association properties different from those displayed by standard DNA molecules. Complex formation observed with sulfide-linked tetramers by HPLC study in different solvents suggested that the complex is formed using hydrogen bonding. Sulfone-linked dinucleotides display Watson-Crick behavior; the tetramer, however, displayed self-structure. Self-structure and self-aggregation become more prominent as the length of the oligonucleotide analogues increases. The tendency to self-aggregate can be decreased by adding a charged sulfonate group to the 3'-end of the DNA analogue. Features of the second-generation model are important for many areas of nucleic acid chemistry, from the design of nucleic acid therapeutic agents to the search for life on other planets.     

Inter- and intramolecular pathways for the formation of tetrahydrofurans from beta-(Phosphatoxy)alkyl radicals. Evidence for a dissociative mechanism

beta-(Phosphatoxy)alkyl radicals generated by photolysis of Barton PTOC esters in the presence of allyl alcohol and tert-butyl mercaptan undergo nucleophilic substitution followed by 5-exo-trig radical ring closure leading to tetrahydrofurans in good yield and with high trans selectivity. beta-(Phosphatoxy)alkyl radicals obtained by intramolecular hydrogen 1,5-abstraction with an alkoxyl radical undergo nucleophilic displacement providing tetrahydrofurans. The ensemble of results, including the effects of leaving groups and substituents, strongly support a dissociative mechanism for these radical nucleophilic displacement reactions.     

Sorption of 241Am by Aspergillus nigerspore and hyphae

Biosorption of ²⁴¹Am by a fungus A. niger, including the spore and hyphae, was investigated. The preliminary results showed that the adsorption of ²⁴¹Am by the microorganism was efficient. More than 96% of the total ²⁴¹Am could be removed from ²⁴¹Am solutions of 5.6-111 MBq/l (C _o) by spore and hyphaeof A. niger, with adsorbed ²⁴¹Am metal (Q) of 7.2-142.4 MBq/g biomass, and 5.2-106.5 MBq/g, respectively. The biosorption equilibrium was achieved within 1 hour and the optimum pH range was pH 1-3. No obvious effects on ²⁴¹Am adsorption by the fungus were observed at 10-45 °C, or in solutions containing Au³⁺ or Ag⁺, even 2000 times above the ²⁴¹Am concentration. The ²⁴¹Am biosorption by the fungus obeys the Freundlich adsorption equation. There was no significant difference between the adsorption behavior of A. nigerspore and hyphae. This revised version was published online in July 2006 with corrections to the Cover Date.     

Molecular weight distribution studies. I. Radiation-induced polymerization of liquid α-methylstyrene

The concentration of water in purified and BaO-dried α-methylstyrene was found to be 1.1 × 10^?4M. The radiation-induced bulk polymerization of the α-methylstyrene thus prepared was studied in the temperature range of ?20°C to 35°C. The polymerization rate varied as the 0.55 power of the dose rate. The theoretical molecular weights and molecular weight distribution were calculated from a proposed kinetic scheme and these values were then compared with those found experimentally. The agreement between these two was reasonably close, and therefore it was concluded that, from the molecular weight distribution point of view, the proposed kinetic scheme for the cationic polymerization of α-methylstyrene is an acceptable one. The rate constant for chain transfer to monomer k_f changed with temperature and was found to be responsible for the decrease in the molecular weight of the polymer with increase in temperature. k_f and k_p at 20°C were found to be 0.95 × 10⁴ l./mole-sec and 0.99 × 10⁶ l./mole-sec, respectively.     

Biosorption of americium-241 by Saccharomyces cerevisiae

The biosorption of radionuclide ²⁴¹Am from solution by Saccharomyces cerevisiae (S. cerevisiae), and the effects of experimental conditions on the adsorption were investigated. The preliminary results showed thatS. cerevisiae is a very efficient biosorbent. An average of more than 99% of the total ²⁴¹Am could be removed by S. cerevisiae of 2.1 g/l (dry weight) from ²⁴¹Am solutions of 17.54–4386.0 mg/l (2.22 MBq/l–555 MBq/l) with adsorption capacities of 7.45–1880.0 mg/g biomass (dry weight) (0.94 MBq/g–237.9 MBq/g). The adsorption equilibrium was achieved within 1 hour and the optimum pH ranged 1–3. No significant differences on ²⁴¹Am adsorption were observed at 10–45 °C, or in solutions containing Au³⁺ or Ag⁺, even 2000 times above ²⁴¹Am concentration. The relationship between concentrations and adsorption capacities of ²⁴¹Am indicated the biosorption process should be described by the Freundlich adsorption isotherm.     

Synthesis and optical resolution of a series of inherently chiral calix[4]crowns with cone and partial cone conformations

A series of inherently chiral calix[4]arenes with cone and partial cone conformations and with crown ether moieties of variable size have been readily synthesized. By taking advantage of the carboxy appendage on the lower rim, these were condensed with the chiral auxiliary (S)-BINOL to form diastereomers which, in most cases, could be separated by preparative TLC, or more desirably, by column chromatography on silica gel (diastereomeric excess >99 % based on HPLC analysis). Seven enantiopure antipodes of inherently chiral calix[4]crowns were obtained after hydrolysis. It has been found that both the size of the crown moiety and alkylation of the last phenolic hydroxy group (accompanied with or without a change in the conformation) affect the separation of the diastereomers.     

Studies on the reactions of silyl enol ether with perfluoroorganic compounds1 III. Synthesis of perfluoroalkylated α, β-unsaturated aldehydes and their derivatives

Per- and poly-fluoroalkylated α, β-unsaturated alkenals were synthesized by the reaction of silyl enol ether of alkanals with per- and poly-fluoroalkyl iodide initiated by Na₂S₂O₄ conveniently in high yield. Their corresponding alkenol and 2,4-dinitrophenylhydrazone were also synthesized.     

Increased throughput in quantitative bioanalysis using parallel-column liquid chromatography with mass spectrometric detection

The feasibility of quantitative bioanalysis by parallel-column liquid chromatography in conjunction with a conventional single-source electrospray mass spectrometer has been investigated using plasma samples containing a drug and its three metabolites. Within a single chromatographic run time, sample injections were made alternately onto each of two analytical columns in parallel at specified intervals, with a mass spectrometer data file opened at every injection. Thus, the mass spectrometer collected data from two sample injections into separate data files within a single chromatographic run time. Therefore, without sacrificing the chromatographic separation or the selected reaction monitoring (SRM) dwell time, the sample throughput was increased by a factor of two. Comparing the method validation results obtained using the two-column system with those obtained using the corresponding conventional single-column approach, the methods on the two systems were found to be equivalent in terms of accuracy and precision. The parallel-column system is simple and can be implemented using existing laboratory equipment with no additional capital outlays. A parallel-column system configured in this manner can be used not only for the within-a-run analysis of two samples containing two different sets of chemical entities, but also for the within-a-run analysis of two samples containing the same set of chemical entities.