Lu2O3对球形Ni(OH)2高温充放电性能的影响

为了改善镍电极的高温充电效率，采用机械混合的方式将球形Ni(OH)2与不同比例的Lu2O3混合后制成粘结式镍正极。充放电测试、循环伏安和XRD等实验结果表明，掺杂Lu2O3后镍电极的析氧过电位明显提高，高温充电效率得到了很大改善，在充电后的电极中β-NiOOH生成；而且Lu2O3的掺杂比例对镍电极的高温性能在不同的充放电倍率下有不同程度的影响，3．5％是最好的掺杂比例，掺杂对高温小电流充电效率的改善作用要大于高温大电流充电。     

Crystalline Morphology and Polymorphic Phase Transitions in Electrospun Nylon 6 Nanofibers

Uniform nylon 6 nanofibers with diameters around 200 nm were prepared by electrospinning. Polymorphic phase transitions and crystal orientation of nylon 6 in unconfined (i.e., as-electrospun) and a high T(g) (340 degrees C) polyimide confined nanofibers were studied. Similar to melt-spun nylon 6 fibers, electrospun nylon 6 nanofibers also exhibited predominant, meta-stable gamma crystalline form, and the gamma-crystal (chain) axes preferentially oriented parallel to the fiber axis. Upon annealing above 150 degrees C, gamma-form crystals gradually melted and recrystallized into the thermodynamically stable alpha-form crystals, which ultimately melted at 220 degrees C. Release of surface tension accompanied this melt-recrystallization process, as revealed by differential scanning calorimetry. For confined nanofibers, both the melt-recrystallization and surface tension release processes were substantially depressed; gamma-form crystals did not melt and recrystallize into alpha-form crystals until 210 degrees C, only 10 degrees C below the T(m) at 220 degrees C. After complete melting of nano-confined crystals at 240 degrees C and recrystallization at 100 degrees C, only alpha-form crystals oriented perpendicular to the nanofiber axis were obtained. In the polyimide-confined nanofibers, the Brill transition (from the monoclinic alpha-form to a high temperature monoclinic form) was observed at 180-190 degrees C, which was at least 20 degrees C higher than that in unconfined nylon 6 at approximately 160 degrees C. This, again, was attributed to the confinement effect.     

Si4+Si3反应动力学：振动激发态对反应的影响

用准经典轨线方法研究了处于振动激发态的硅原子团簇与硅原子团簇碰撞的反应动力学，计算表明，对于Ｓｉ４＋Ｓｉ３反应，当反应物团簇处于振动激发态时，有利于生成更小团簇的碎片，而对生成Ｓｉ６＋Ｓｉ及Ｓｉ５＋Ｓｉ２的影响不大。     

盐卤硼酸盐化学──ⅩⅩⅧ.氯柱硼镁石的激光拉曼光谱

本文研究了氯柱硼镁石硼酸和硼砂的晶体和它们在水溶液中的激光拉曼光谱，并与某些阴酸盐的谱图进行对比．初步提出硼氧配阴离子的聚合形式，为进行氯柱硼镁石结构分析提供实验依据．     

Electrospun cellulose acetate fibers: effect of solvent system on morphology and fiber diameter

This paper reports an investigation of the effects of solvent system, solution concentration, and applied electrostatic field strength (EFS) on the morphological appearance and/or size of as-spun cellulose acetate (CA) products. The single-solvent systems were acetone, chloroform, N,N -dimethylformamide (DMF), dichloromethane (DCM), methanol (MeOH), formic acid, and pyridine. The mixed-solvent systems were acetone–DMAc, chloroform–MeOH, and DCM–MeOH. Chloroform, DMF, DCM, MeOH, formic acid, and pyridine were able to dissolve CA, forming clear solutions (at 5% w/v), but electrospinning of these solutions produced mainly discrete beads. In contrast, electrospinning of the solution of CA in acetone produced short and beaded fibers. At the same solution concentration of 5% (w/v) electrospinning of the CA solutions was improved by addition of MeOH to either chloroform or DCM. For all the solvent systems investigated smooth fibers were obtained from 16% (w/v) CA solutions in 1:1, 2:1, and 3:1 (v/v) acetone–DMAc, 14–20% (w/v) CA solutions in 2:1 (v/v) acetone–DMAc, and 8–12% (w/v) CA solutions in 4:1 (v/v) DCM–MeOH. For the as-spun fibers from CA solutions in acetone–DMAc the average diameter ranged between 0.14 and 0.37 μm whereas for the fibers from solutions in DCM–MeOH it ranged between 0.48 and 1.58 μm. After submersion in distilled water for 24 h the as-spun CA fibers swelled appreciably (i.e. from 620 to 1110%) but the physical integrity of the fibrous structure remained intact.     

Studies on metal — protein interactions: Inter-comparison among various approaches

Binding ability of mercury, thallium, lead and bismuth with Erythrina variegata seed protein have been investigated using tracer packet technique. Due to the lack of standard methods, inter-comparisons have been made among three different approaches, like trichloroacetic acid (TCA) precipitation, isoelectric precipitation and dialysis of protein after incubation with the metals. Good agreement was observed for all the cases except that of lead.     

Structure of inhomogeneous attractive and repulsive hard-core yukawa fluid: grand canonical Monte Carlo simulation and density functional theory study

A density functional theory is proposed for an inhomogeneous hard-core Yukawa (HCY) fluid based on Rosenfeld's perturbative method. The excess Helmholtz energy functional is derived from a modified fundamental measure theory for the hard-core repulsion and a quadratic functional Taylor expansion for the long-ranged attractive or repulsive interactions. To test the established theory, grand canonical ensemble Monte Carlo simulations are carried out to simulate the density profiles of attractive and repulsive HCY fluid near a wall. Comparison with the results from the Monte Carlo simulations shows that the present density functional theory gives accurate density profiles for both attractive and repulsive HCY fluid near a wall. Both the present theory and simulations suggest that there is depletion for attractive HCY fluid at low temperature, but no depletion is found for repulsive HCY fluid. The calculated results indicate that the present density functional theory is better than those of the modified version of the Lovett-Mou-Buff-Wertheim and other density functional theories. The present theory is simple in form and computationally efficient. It predicts accurate radial distribution functions of both attractive and repulsive HCY fluid except for the repulsive case at high density, where the theory overestimates the radial distribution function in the vicinity of contact.     

用峰鉴别技术反相高效液相色谱法测定火锅汤料中微量吗啡

本文报道了以峰鉴别技术为定性依据的测定火锅汤料中微量吗啡的反相高效液相色谱法。本法采用改良的Ｓｔａｓ－ｏｔｔｏ法分离提取复杂样品中的微量吗啡。由于采用峰鉴别技术，增加了定性参数，大大提高了定性方法的准确性。本法简便、快速。最低检出浓度为０．０４ｍｇ／Ｌ。在数十例样品分析中，与其它仪器分析结果比照，非常符合。     

硝酸镧与冠醚(2, 2)配合物的晶体及电子结构研究

用X-射线单晶衍射法测定了硝酸镧与冠醚(2,2)配合物的晶体结构,发现其具有与报道的Eu(NO_3)_3(2,2)配合物不同的配位方式.晶体属于三斜晶系,空间群P(?),晶胞参数为a=10.312(2)(?);b=12.745(3)(?);c=8.917(2)(?);α=103.79(2)°;β=112.73(2)°;γ=83.68(2)°;V=1049.5(5)(?)~3;F(000)=587.88;Z=2.结构用重原子法解出;R值为0.0292.用INDO法计算了配合物的净电荷分布,电子结构、键级.结果表明,镧与配位原子间的键具有一定程度的共价性.镧的5d轨道对共价性的贡献最大,而4f轨道基本上不参与成键.La-N比La-O(醚)间存在较强的作用,增大了配合物的稳定性.     

Quantum dot nanocrystals for in vivo molecular and cellular imaging

Semiconductor quantum dots (QD) are nanometer-sized crystals with unique photochemical and photophysical properties that are not available from either isolated molecules or bulk solids. In comparison with organic dyes and fluorescent proteins, QD are emerging as a new class of fluorescent labels with improved brightness, resistance against photobleaching and multicolor fluorescence emission. These properties could improve the sensitivity of biological detection and imaging by at least 10- to 100-fold. Further development in high-quality near-infrared-emitting QD should allow ultrasensitive and multicolor imaging of molecular targets in deep tissue and living animals. Here, we discuss recent developments in QD synthesis and bioconjugation, applications in molecular and cellular imaging as well as promising directions for future research.