Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

Investigation on crosslinking behaviors of NBR/PVC filled with anhydrous copper sulfate particles by dynamic mechanical analysis

Crosslinking behaviors of acrylonitrile butadiene rubber (NBR)/poly (vinyl chloride) (PVC) alloy, filled with anhydrous copper sulfate (CuSO₄) particles, were investigated for the first time by dynamic mechanical analysis (DMA) under hetero and isothermal modes, respectively. In the heterothermal testing, (NBR/PVC)/CuSO₄ compound showed two marked increases in the storage modulus (E′), corresponding to coordination crosslinking of NBR-CuSO₄ and self-crosslinking of NBR and PVC respectively. During the isothermal testing, a dramatic increase in E′ was found at the initial stage while that of original NBR/PVC alloy was not detected. The marked increase in E′ of (NBR/PVC)/CuSO₄ compound was mainly due to the crosslinking induced by coordination between  CN and Cu²⁺. The increasing extent of E′ increased with the rise of CuSO₄ content, suggesting the formation of a greater number of crosslinks. Moreover, the activation energy (E_a) of crosslinking process was about 139 kJ/mol. In this work, fourier transform infrared spectrum (FT-IR) and equilibrium swelling method were also performed for the characterization of the compound. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 41–51, 2007     

REM树脂的制备及亲核加成应用研究

用Mitsunobu反应及丙烯酰氯酰化反应制备了用于固相有机合成的载体REM树脂，将REM树脂与苄胺加成，考查了所合成REM树脂的反应性能，并通过元素分析测定氮含量，推出REM树脂的烯丙基固载量。利用所合成的REM树脂进行了与胺、酚的加成反应动力学研究。结果表明，REM树脂与脂肪族伯胺和促胺的加成反应能够进行，与苯胺不发生反应；REM树脂与酚不能发生亲核加成反应。     

AnUV-algorithm for semi-infinite multiobjective programming

In this paper, we give an application ofUV-decomposition method of convex programming to multiobjective programming, and offer a new algorithm for solving semi-infinite multiobjective programming. Finally, the superlinear convergence of the algorithm is proved.     

边值问题的某些存在定理(英)

本文给出关于边值问题解的某存在唯一性定理及其应用．     

改性壳聚精膜用于醇水混合液分离的研究──Ⅲ．超细粉末填充壳聚精膜

首次制备了用Ｓｉ３Ｎ４，ＳｉＯ２，ＴｉＨ４超细粉末填充的改性壳聚精膜，并将其用于乙醇／水混合液的分离中。实验表明壳聚糖膜经超细粉末填充后强度增大，溶胀度减小。用于乙醇／水混合液渗透蒸发分离时，分离因子和渗透通量都有提高，并在填充量为１６．７％附近出现极大值。随着料液中乙醇含量的增大，渗透通量减小，分离因子增大；随着料液温度的升高渗透通量显著增大，分离因子则稍有下降。并简单讨论了超细粉末在乙醇／水混合液分离中的作用。     

正负系数中立型差分方程的正解的存在性

In this paper the sufficient conditions for the existence of positive solutions of the neutral difference equations with positive and negative coefficients are established. The results improve some known conclusions in the literature