用^3HNMR波谱法分析微波激发催化交换制备的^3H标记颠茄类生物碱

用~3H NMR波谱法测定了微波激发催化交换制备的四种~3H标记颠茄类生物碱示踪剂的氚标记位置及其相对百分含量。并在用~1H NMK归属原料纯度及标记物分子各基因化学位移时采用了水峰抑制技术(简称WEFT),既能同时消除溶剂氘代甲醇及水峰的影响;又能提高灵敏度(近10倍),从而计算出所得标记产物的化学纯度值与放化纯度值。为快速、准确寻找制备标记生物碱的最佳实验条件和控制标记物质量提供了唯一的物理无损分析方法。     

电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

5''''-鸟苷酸与茜素红S的反应及其在分析化学中的作用

采用UV-Vis光谱法研究了茜素红S(ARS)与5'-鸟苷酸(5'-GMP)在pH 4.80的弱酸性缓冲溶液中生成络合物的结合反应.与试剂比较,络合物的最大吸收峰红移92 nm,测得络合物和表观摩尔吸光系数为ε＝1.3×104 L·mol-1·cm-1;最大结合数n=10;浓度线性范围0.2～16 mg/L;检出限为6.1×10-8 mol/L.研究了ARS与5'-GMP是分子间作用力的结合反应,并对时间、温度、离子强度对结合反应的影响,以及无机物、生物物质对反应体系的干扰情况进行了初步研究.     

工业废水中微量铜（Ⅱ）和氰化物的流动注射光度分析

采用ＦＩＡ技术，以光度比色法为基础，建立了工业废水中微量Ｃｕ＾２＋和ＣＮ＾－的顺序自动分析方法和装置。其对二种离子的测定频率为６０样／ｈ，相对标准偏差＜１．０％，工作曲线的ｒ值≥０．９９９，各项分析技术指标均优于手工法操作。     

Rapid determination of acetone in human blood by derivatization with pentafluorobenzyl hydroxylamine followed by headspace liquid-phase microextraction and gas chromatography/mass spectrometry

In the current work, a simple, rapid, accurate and inexpensive method was developed for the determination of acetone in human blood. The proposed method is based on derivatization with O-(2,3,4,5,6-pentafluorobenzyl)hydroxylamine hydrochloride (PFBHA), followed by headspace liquid-phase microextraction (HS-LPME) and gas chromatography/mass spectrometry (GC/MS). In the present method, acetone in blood samples was derivatized with PFBHA and acetone oxime formed in several seconds. The formed oxime was enriched by HS-LPME using the organic solvent film (OSF) formed in a microsyringe barrel as extraction interface. Finally, the enriched oxime was analyzed by GC/MS in electron ionization (EI) mode. HS-LPME parameters including solvent, syringe plunger withdrawal rate, sampling volume, and extraction cycle were optimized and the method reproducibility, linearity, recovery and detection limit were studied. The proposed method was applied to determination of acetone in diabetes blood and normal blood. It has been shown that derivatization with HS-LPME and GC/MS is an alternative method for determination of the diabetes biomarker, acetone, in blood samples.     

Reaction of porous silicon with both end-functionalized organic compounds bearing alpha-bromo and omega-carboxy groups for immobilization of biomolecules

Both end-functionalized (alpha-bromo and omega-carboxy) compounds were first tested for the radical reaction on the silicon-hydride (Si-H) terminated porous silicon (PSi) with/without the presence of diacyl peroxide initiator under microwave irradiation. Then the carboxylic acid monolayers (CAMs) assembled on PSi through the robust Si-C bonds were converted to amino-reactive linker, N-hydroxysuccinimide (NHS)-ester, terminated monolayers. And finally two proteins of bovine serum albumin (BSA) and lysozyme (Lys) were immobilized through amide bonds. The optimum PSi membrane for protein immobilization without collapse, with parameters of porous radii 4-10 nm and depth 0.2-4.6 mum, was prepared from the (100)-oriented p-type silicon wafer. The chemically converted surface products were monitored with Fourier transform infrared spectroscopy (FTIR), X-ray photoelectron spectroscopy (XPS), and field emission scanning electron microscopy (FESEM).     

Electrodeposition of nanocrystalline zinc from acidic sulfate solutions containing thiourea and benzalacetone as additives

Nanocrystalline zinc coatings were produced by pulse electrodeposition in acid sulfate bath containing thiourea and benzalacetone additives and characterized by X-ray diffraction and scanning electron microscopy techniques. The influence of benzalacetone concentration and pulse peak current density on the grain size and crystallographic orientation of zinc deposits was investigated. Zinc electrodeposited from additive-free solutions or with one of the two additives is not composed of nanosized crystals. The mixture additives of thiourea and benzalacetone give rise to the formation of particle-like nanocrystalline zinc with a (10ī1) random orientation. A change in peak current density from 2 to 1 A/cm² only increases the grain size from 60 to 62 nm.     

反应条件对Mo2C/Al2O3催化的POM制合成气的影响

考察了反应温度、气体空速和进料中CH4：O2比值对Mo2C／Al2O3催化的POM反应制合成气的影响．结果发现较高的温度具有较高的甲烷转化率、CO和H2的选择性；而在较低的温度下，对CO的选择性比对H2的影响更大．反应气体的空速较小时对于甲烷的转化率、CO和H2的选择性是有利的；而在较高的气体空速下，氢气的选择性则更低．进料中CH4：O2比值稍高于2：1时有利于获得高的甲烷转化率、CO和H2的选择性．并且还可以增加催化剂的稳定性．当CH4：O2比值低于2：1时．甲烷转化率、CO和H2选择性随反应的进行急剧下降．而当此比值调整到高于2：1时．转化率和选择件都可以得到恢复。     

A facile electrochemical synthesis of caffeic acid derivatives in the presence of acetylacetone or methyl acetoacetate in aqueous medium

The anodic oxidation of caffeic acid in the presence of acetylacetone or methyl acetoacetate in aqueous solution has been studied by cyclic voltammetry and controlled-potential electrolysis techniques. The result showed that caffeic acid was oxidized to the corresponding o-benzoquinone, which underwent further Michael-addition with acetylacetone or methyl acetoacetate to produce caffeic acid derivative 3,4-dihydroxy-6-(1-acetylacetone)-yl cinnamic acid 4a or 3,4-dihydroxy-6-(1-acetyl-methylacetate)-yl cinnamic acid 4b.