Annealing and measurement temperature dependence of W2B5-based rectifying contacts to n-GaN

The thermal stability and measurement temperature dependence of Schottky contact characteristics on n-GaN using a W₂B₅/Ti/Au metallization scheme was studied using current-voltage (I-V), scanning electron microscopy (SEM) and Auger electron spectroscopy (AES) measurements. The elemental profile obtained from samples annealed at 350 °C showed some titanium diffusion into the gold layer but little other difference from the as-deposited wafer. Annealing at 700 °C produced significant diffusion of titanium. The Schottky barrier height increased with anneal temperature up to 200 °C, reaching a maximum value of 0.65 eV, but decreased at higher annealing temperatures. The reverse breakdown voltage from diodes fabricated using the W₂B₅-based contacts showed a similar dependence. The reverse current magnitude was larger than predicted by thermionic emission alone. The barrier height showed only minor changes with measurement temperature up to 150 °C.     

A Rapid Solid-phase Synthesis to Soluble Oligothiophene Molecular Wires

A novel method for the preparation of oligothiophene molecular wires is described via a bi-directional solid-phase synthesis. Using an alternating sequence of bromination and Stille coupling reactions, oligomers were obtained up to the heptamer in excellent yield and purity.     

SiO2-羟基表面上金属原子的第一性原理研究

采用第一性原理方法研究了SiO2-羟基表面上几种金属原子的吸附性质,发现In和Ga在SiO2-羟基表面上的结合很弱,而Fe,Co,Ni在该表面上与Si,O形成强的化学键.等势能面和扩散势垒计算表明In(Ga)的扩散激活能只有0.1-0.3 eV,表明这两种原子容易在表面上扩散.这些结果可以定性地解释纳米合成中的一些实验现象.     

基于P-N结的太阳能电池伏安特性的分析与模拟

通过分析实际P-N结与理想模型之间的差别,建立了P-N结二极管及太阳能电池的数学模型;利用Matlab中的系统仿真模块库建立仿真模型,设置参量,求解模型方程并绘制了图形.对太阳能电池在一定光照下旁路电阻及串联电阻取不同数值时对其开路电压、短路电流及填充因子的影响做了模拟,并与实际测得的硅太阳能电池伏安特性进行了比较.模型分析与实验测量的结果表明:等效的旁路电阻和串联电阻分别影响电池的开路电压和短路电流.仿真结果与实验测量结果一致.     

300kVA高温超导变压器电流引线漏热损耗的测量

电流引线是高温超导变压器的主要外部漏热来源,它的漏热量直接影响了超导变压器的经济性能,因此,引线的设计与漏热测量一直备受关注。文中构建了一个实验方案,运用量热法测量低压引线的漏热,并将试验结果与仿真预期值进行了对比和分析,从而验证了仿真设计的正确性。     

交流源作用下介观RLC电路系统量子态随时间的演化

根据量子不变量理论，同时考虑介观电容器极板间电子波函数的耦合作用和电路的耗散,研究介观RLC电路系统在交流电流源作用下动力学的演化过程，并且得到描述系统量子态随时间的演化算符.进一步的分析结果表明，介观RLC电路系统的波函数将由任意的初态演化到一般的压缩态. 关键词： 介观RLC电路 交变电源 不变量理论 时间演化算符     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.     

退火温度对低温生长MgxZn1－xO薄膜光学性质的影响

用射频磁控溅射法在80℃衬底温度下制备出Mg_xZn_1-xO(x=0.16)薄膜，用X射线衍射(XRD)、光致发光(PL)和透射谱研究了退火温度对Mg_xZn_1-xO薄膜结构和光学性质的影响.测量结果显示，Mg_xZn_1-xO薄膜为单相六角纤锌矿结构，并且具有沿c轴的择优取向；随着退火温度的升高，(002)XRD峰强度、平均晶粒尺寸和紫外PL峰强度增大，(002)XRD峰半高宽(F 关键词： xZn_1-xO薄膜')" href="#">Mg_xZn_1-xO薄膜 射频磁控溅射 退火     

Preparation of antimicrobial poly(vinyl alcohol) nanofibers containing silver nanoparticles

Polyvinyl alcohol (PVA) nanofibers containing Ag nanoparticles were prepared by electrospinning PVA/silver nitrate (AgNO₃) aqueous solutions, followed by short heat treatment, and their antimicrobial activity was investigated for wound dressing applications. Since PVA is a water soluble and biocompatible polymer, it is one of the best materials for the preparation of wound dressing nanofibers. After heat treatment at 155 °C for 3 min, the PVA/AgNO₃ nanofibers became insoluble, while the Ag⁺ ions therein were reduced so as to produce a large number of Ag nanoparticles situated preferentially on their surface. The residual Ag⁺ ions were reduced by subsequent UV irradiation for 3 h. The average diameter of the Ag nanoparticles after the heat treatment was 5.9 nm and this value increased slightly to 6.3 nm after UV irradiation. It was found that most of the Ag⁺ ions were reduced by the simple heat treatment. The PVA nanofibers containing Ag nanoparticles showed very strong antimicrobial activity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2468–2474, 2006     

Scientist up to the highest level

Dr. Miroslav Kyrš, DrSc. passed away prematurely and unexpectedly in August 2006 at age of 75. He was a leading person of the Czech radiochemistry during the second half of the 20th century and his results have of world-wide impact. His diligence, intelligence and permanent activity led him to be at first a laboratory chief and subsequently for about 25 years to be a chief of the Radiochemical Department of Czech Nuclear Research Institute (NRI) at Řež near Prague.