Modeling and calculation of thermal explosion time to ignition of cylindrical fireworks and crackers

To analyze the thermal safety of cylindrical fireworks and crackers in storage and transportation, this article establishes a physical model and a mathematical model of thermal explosion time to ignition of finite cylindrical fireworks and crackers. And in order to simplify the thermal explosion model, effective Biot number about boundary condition is deduced according to the theory of heat transfer. The partial differential equation of thermal explosion model are calculated with difference method in Matlab program, to obtain the time to ignition as well as the temperature–time history before explosion system explodes. The rationality of effective Biot number and calculation method is proved through comparison of calculation solution and literature solution. Being the first to solve the problem of two-dimensional thermal explosion unsteady-state model of fireworks and crackers, where the upper surface, lower surface, and side surface have different heat dissipation conditions. Meanwhile, calculation steps were shown about a type of fireworks.     

Development and validation of an LC/MS/MS method for simultaneous determination of shionone and epi‐friedelinol in rat plasma for pharmacokinetic study after oral administration of Aster tataricus extract

A rapid and sensitive liquid chromatography tandem mass spectrometry (LC/MS/MS) method was developed and validated using spinasterol as the internal standard (IS) for the simultaneous determination of shionone and epi‐friedelinol in rat plasma. Plasma samples were pretreated using liquid–liquid extraction with ethyl ether. Chromatographic separation was achieved on a C₁₈ column (100 × 2.1 mm, 5 μm) with an isocratic elution consisting of acetonitrile–0.1% formic acid water (75:25, v/v) at a flow rate of 0.30 mL/min. Detection was performed under the selected reaction monitoring scan using an electrospray ionization in the positive ion mode. The mass transitions were as follows: m/z 427.4 → 95.1 for shionone, m/z 411.4 → 205.2 for epi‐friedelinol and m/z 395.3 → 105.2 for IS. All calibration curves exhibited good linearity (r > 0.995) over the concentration range for both components. The intra‐ and inter‐day precisions at three QC and lower limit of quantitation levels were both <10.21% in terms of relative standard deviation, and the accuracy ranged from ?7.13 to 8.02% in terms of relative error. The extraction recoveries of the compounds ranged from 82.07 to 89.81%. The developed method was successfully applied to the pharmacokinetic study of shionone and epi‐friedelinol after oral administration of Aster tataricus extract to rats. Copyright © 2015 John Wiley & Sons, Ltd.     

Relationship between liquid crystalline phase stability and ingredient composition in liquid crystal oil–water emulsion

In this study, we postulated that the optical retardation magnitude could be used to evaluate the stability of the LC phase through the Mueller matrix polarimeter method in LC emulsion. In addition, we found that the increase of cetearyl alcohol concentration induced the more periodic dense lattice structure in crystalline phase of LC lamellae and the sorbitan olivate was relatively more responsible for higher ordering in LC phase compared to C12–20 alkyl glucoside in terms of molecular parallel packing on the basis of the optical retardation magnitude. Furthermore, it was confirmed that the LC emulsion had higher skin barrier function owing to lower TEWL and higher reflectance than ordinary emulsion on human skin and maintained a uniform phase without phase separation for 8 weeks.     

A Facile Route to Synthesize α,α′-bis(Substituted-benzylidene) Cycloalkanones Promoted by SmI3

Promoted by SmI₃ cycloalkanone trimethylsilyl enol ethers were reacted with aldehydes to give α,α′-bis (substituted-benzylidene) cycloalkanones.     

还原氧化石墨烯@泡沫镍载CoO纳米花电极制备及催化CO2性能

本文以氧化石墨烯包覆泡沫镍电极(GO@NF)作为基底,采用水热法在GO@NF基底上原位生长CoO纳米花,同时GO在水热过程中被同步热还原为还原氧化石墨烯(RGO),从而一步制得还原氧化石墨烯包覆泡沫镍负载CoO纳米花电极(CoO/RGO@NF)。使用XRD和SEM对CoO/RGO@NF电极进行表征,发现CoO纳米花均匀生长在泡沫镍三维网络结构上,CoO纳米花为大量针状纳米棒围绕一个中心而成的花状结构,纳米棒的长度约为10 ~ 15 μm,直径约为100 ~ 200 nm。使用循环伏安和线性扫描法测试了CoO/RGO@NF电极电催化CO₂的还原性能,在-0.76 V（vs. SHE）电位下,CoO/RGO@NF电极电催化CO₂还原的电流效率达到70.9%,产甲酸法拉第效率达到65.2%,甲酸产率为59.8 μmol·h^-1·cm^-2,且电极可持续稳定电催化还原CO₂ 4 h,表明CoO/RGO@NF电极对CO₂电还原有着优良的催化活性、选择性和稳定性。     

Actuation design for high‐performance shape memory polyurethanes

A series of shape memory polyurethanes were synthesized from poly(tetramethylene glycol), 4,4‐methylene diphenyl diisocyanate, and 1,3‐butanediol. The prepolymers with different molecular weights (M_c) were capped with 2‐hydroxyl ethylacrylate or 3‐aminopropyltriethoxysilane (APTES) and crosslinked by UV curing or a sol–gel reaction. Variations of the crosslinker functionality (f), subchain density (N), and hard segment content (HSC) produced systematic variations of the glass transition temperature (6–45 °C), accompanied by changes in the mechanical, dynamic mechanical and shape memory properties. More than 95% of shape fixity and 98% of shape recovery up to the fourth cycles were obtained with APTES crosslinked 3000M_c with 30% of HSC. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013 , 51, 1473–1479     

Nucleophilic substitution of ferrocenyl alcohols catalyzed by bismuth(III) in aqueous medium at room temperature

A nucleophilic substitution reaction of an α‐ferrocenyl alcohol with various amines, indoles and thiols was successfully developed by using a catalytic amount of Bi(NO₃)₃.5H₂O at room temperature without the aid of phase transfer catalyst. The reactions proceeded in aqueous media, leading to the formation of new C=C, C=N and C=S bonds bearing ferrocenyl substituent with high efficiency. Copyright © 2012 John Wiley & Sons, Ltd.